CDA SL300BL Guida utente
1
SL300BL
SL300SS
Twelve function electric oven with timer
Use and maintenance
2| Instruction Manual
3 Important information
5 First use of the oven
5 Using the electronic programmer
6 Setting the timer
7 Semi automatic cooking
8 Automatic cooking
9 Settings
10 Oven functions and operations
13 Using the grill
14 Cleaning and maintenance
21 Changing the light bulb
22 Installation
24 Mains electrical connection
26 Technical assistance
27 Specifications
28 Product fiche
29 Product information
Contents
IMPORTANT: Please read the user instructions carefully before
using the appliance for the first time and before installing it.
Failure to install the oven, or to have it installed, as per the
instruction manual could invalidate the warranty. Any service
calls relating to misue or incorrect installation could incur a
service charge
Instruction Manual | 3
Important information
This appliance must only be used for the purpose for which it is
intended, i.e. domestic cooking. Any other use could be dangerous
and may lead to premature failure of the appliance.
The CDA Group Ltd. cannot be held responsible for injuries or losses
caused by incorrect use or installation of this product. Please note
that CDA reserves the right to invalidate the guarantee supplied with
this product following incorrect installation or misuse of the appliance.
Under no circumstances should any external covers be removed for
servicing or maintenance except by suitably qualified personnel.
User information
• The appliance and its accessible parts become hot during use.
Care should be taken to avoid touching heating elements
• The appliance can be used by children aged from 8 years
and above. Persons with reduced physical, sensory or mental
capabilities must be given instruction or supervision
concerning safe operation of the appliance and understand the
hazards involved
• Do not allow anyone unfamiliar with the contents of this instruction
manual to operate the oven
• Do not use harsh cleaning agents or sharp metal objects to clean
the door as they can scratch the surface potentially resulting in
cracking or shattering of the glass
• Take care when opening the oven door during or after a cooking
cycle as hot steam may escape
• Do not use the oven in the event of a technical fault. Any faults
must be fixed by an appropriately qualified and authorised person
• In the event of an incident due to a technical fault, disconnect the
power and report the fault to CDA Customer Care
• The appliance has been designed only for cooking, any other use
may invalidate your warranty and cause danger
• Do not place anything weighing over 15kg on the opened oven
door
4| Instruction Manual
Appliance information
Please enter the details on the appliance rating plate below for
reference, to assist CDA Customer Care in the event of a fault with
your appliance and to register your appliance for guarantee purposes.
Appliance Model
Serial Number
EU Declarations of Conformity:
This appliance has been manufactured to the strictest standards and
complies with all applicable legislation and the following European
Directives.
• The Low Voltage Directive 2014/35/EU
• Electromagnetic Compatibility Directive 2014/30/EU
• ErP Directive 2009/125/EU
The product has been marked with the symbol and the
Declaration of Conformity has been issued to the manufacturer and
is available to the competent authorities regulating the market
IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE
PRODUCT IN ACCORDANCE WITH EC DIRECTIVE 2012/19/EU.
At the end of its working life, the product must be taken to a special
local authority waste collection centre or to a dealer providing
appliance recycling services.
Disposing of a household appliance separately avoids possible
negative consequences for the environment and health. It also
enables the constituent materials to be recovered, saving both energy
and resources. As a reminder of the need to dispose of household
appliances separately, the product is marked with a crossed-out
wheeled dustbin .
Instruction Manual | 5
First use of the oven
In order to remove oil residues accumulated during the manufacturing
process and dust accumulated during storage and transport, we
recommend a preliminary cleaning before first use. This is to protect
your health and provide optimum quality in cooking.
Preliminary heating
1. Remove any packaging elements from the oven cavity
2. Turn on ventilation or extractor fan in the room or open a window
3. Set the oven to 250°C using the rapid preheating function
4. Allow to heat for approximately 30 minutes
5. Turn oven o and allow to cool
6. To clean the oven use a well wrung-out cloth with warm water and
a small amount of washing up liquid
7. Dry with a clean cloth
A slightly unpleasant smell may be emitted during this process due to
the vaporising of oil residue used to protect the oven during storage.
Do not use corrosive or abrasive powders when cleaning the
appliance as they can damage the surface
Using the electronic programmer
This oven’s electronic timer is equipped with touch control sensors.
Each registered touch of the sensor is confirmed by a single beep. It
is recommended to keep the touch sensors clean at all times for ease
of operation.
- Select the mode of operation
- Increase setting sensor
- Decrease setting sensor
- Appliance on indicator
- Minute minder
- Duration
- End time
6| Instruction Manual
Setting the time
When first connected to the power supply, the digital display will flash
0.00.
The oven will not operate until the time is set.
• Simultaneously touch
and
until you see the dot below the
symbol flashing
• Touch or
within 7 seconds to set the current time. Once the
desired time is set, allow 7 seconds for the dot to stop flashing
followed by a beep. The time can be adjusted again at any time by
pressing
and
simultaneously and following the same steps
Minute minder
You can activate the minute minder at any time regardless of the
status of other functions. It can be set from 1 minute up to a maximum
of 23 hours and 59 minutes.
To set the minute minder:
• Touch and hold and the display will show a flashing
• Use the
and
sensors to set the time desired. The display will
show the set time and the symbol will be visible
• Once the set time elapses an alarm will sound and the icon
flashes. Touch and hold either
/
or to mute the alarm.
After approximately 7 seconds the will be o and the display will
show the current time
Please note:
If no sensor is touched the alarm will turn o automatically after
approximately 7 minutes.
Instruction Manual | 7
Semi-automatic cooking
This function allows for a cooking time to be set. When the set time
elapses the oven will switch the set function o and an acoustic signal
will sound to alert the user. The cooking time available ranges from
between 1 minute and 10 hours.
To switch on semi-automatic cooking
• Set the desired oven function and temperature
• Touch repeatedly until the display shows
dur
(duration) and the
symbol is flashing
• Set the desired duration from between 1 minute and 10 hours
using the
/
sensors
• The set duration will be memorised after 7 seconds and the
display will show the current time and the symbol
• Once the duration time has elapsed the oven will turn o
automatically. You will hear an alarm and the and symbols will
flash
• Set the function and temperature selection knobs to the o
position
• Touch and hold the
/
or to mute the alarm
• The and will go o and the display will revert to the current
time after approximately 7 seconds
8| Instruction Manual
Automatic cooking
This function allows for a duration and an end time to be set for
cooking. For example, if you set the cooking duration to 1 hour, and
the end time to 15:00, then the oven will activate the function at 14:00.
To switch on automatic cooking
• Touch repeatedly until the display shows
dur
(duration) and the
symbol is flashing
• Set the desired duration using the
/
• Touch repeatedly until the display shows
End
and the symbol
is flashing
• Using the
/
set the end time of the cycle up to a maximum of
23 hours and 59 minutes
• Set the function selector knob and temperature selector knob
to the desired settings. The and will be illuminated on the
display and are now active. The appliance will now switch on at
the end time minus the duration set
Once the duration time has elapsed the oven will turn o
automatically. The alarm will be heard and the and symbols will
flash. Set the function and temperature selector knobs to the o
position then touch and hold the
/
or to mute the alarm. The
and will be o and the display will show the current time after
approximately 7 seconds.
Instruction Manual | 9
Cancel settings
Timer and function settings can be cancelled at any time regardless
of the status of the operation. Simultaneously touch
/
to cancel.
In order to cancel the minute minder function, first hold down and
then simultaneously touch
/
to cancel.
Changing the beep tone
• Simultaneously touch and hold
/
• Touch repeatedly until the display shows
Ton1
• Touch
/
to select between
Ton1, Ton2
and
Ton3
Adjusting the display brightness
You can adjust the brightness of the display from 1 to 9, 1 being the
darkest and 9 the brightest. The brightness setting applies when no
controls are touched for 7 seconds.
You can adjust display brightness as follows:
• Simultaneously touch and hold the
/
• Touch repeatedly until
Bri
shows on the display
• Use the
/
sensors to select between 1 and 9
Night mode
The display is dimmed during the hours of 22:00 - 06:00
10 | Instruction Manual
Oven functions and operation
The ovens operations are controlled by the function selector knob on
the right side of the control panel and the temperature selector knob
on the left side.
Please note:
Only when the temperature has been selected will the oven begin to
heat up.
Switching on the oven is indicated by two signal lights, Land R.
When R is illuminated it signifies the oven is working. The Llight
indicates the temperature has been set; once this light goes out it
means the desired temperature setting has been reached. If a recipe
recommends placing dishes in a preheated oven, this should not be
done until the Llight goes out for the first time. When baking, the L
light will temporarily come on and go out indicating temperature is
being maintained inside the oven.
L R
Questo manuale è adatto per i seguenti modelli
1
Indice
Altri manuali CDA Forno
CDA
CDA SA116 for Manuale di riferimento
CDA
CDA SG121SS Guida rapida
CDA
CDA CD 307 Istruzioni operative
CDA
CDA DV1180 Series Manuale di riferimento
CDA
CDA SC210 Series Manuale di riferimento
CDA
CDA 9Q6 Series Manuale di riferimento
CDA
CDA DC740 Guida di sicurezza
CDA
CDA SL400SS Guida utente
CDA
CDA SC 310 Series Manuale di riferimento
CDA
CDA SK420 Istruzioni per l'installazione e il funzionamento
