CDA FW223 Manuale di riferimento
1
Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY
T: 01949 862 012 F: 01949 862 003 E: [email protected] W: www.cda.eu
Passionate about style
FW223 Integrated Under Counter
Larder Fridge
Manual for Installation, Use and Maintenance
2
Important
The CDA Group Ltd cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please
note that CDA reserve the right to invalidate the guarantee supplied with this product following incorrect installation or misuse
of the appliance.
This appliance is not designed to be used by people (including children) with reduced physical, sensorial or mental capacity, or
who lack experience or knowledge about it, unless they have had supervision or instructions on how to use the appliance by
someone who is responsible for their safety.
Under no circumstances should any external covers be removed for servicing or maintenance except by suitably qualified
personnel.
Appliance information:
Please enter the details on the appliance rating plate below for reference, to assist CDA Customer Care in the event of a fault with
your appliance and to register your appliance for guarantee purposes.
Appliance Model
Serial Number
CE Declarations of Conformity:
This appliance has been designed, constructed and marketed in compliance with safety requirements of EEC Directive 2006/95/EEC
(Low voltage) and requirements of EMC Directive 2004/108/EEC.
This appliance has been manufactured to the strictest standards and complies with all applicable legislation, including Electrical
safety (LVD) and Electromagnetic interference compatibility (EMC). Parts intended to come into contact with food conform to
EEC/89/109.4
IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH EC DIRECTIVE
2002/96/EC.
At the end of its working life, the product must not be disposed of as urban waste. It must be taken to a special local authority
differentiated waste collection centre or to a dealer providing this service.
Disposing of a household appliance separately avoids possible negative consequences for the environment and health deriving
from inappropriate disposal and enables the constituent materials to be recovered to obtain significant savings in energy and
resources. As a reminder of the need to dispose of household appliances separately, the product is marked with a crossed-out
wheeled dustbin.
3
Important
Never store inflammable or explosive items and strong corrosive acids or alkalis in the appliance.
This is a household appliance, which is produced in accordance with the national standard. It is intended for food storage only,
not for storage of blood, medicine and biological products.
To prevent risk of fire, keep the appliance away from petrol or any other inflammables.
To prevent risk of electromagnetic interference or other accidents, do not place a microwave oven on top of the refrigerator or
use any electric appliance inside the refrigerator.
Do not allow children to play with or near the appliance.
The internal surface of freezer compartment is very cold when the appliance is running. Do not touch the surface especially with
wet hands.
Do not splash water onto the appliance. Keep it away from places of high humidity that may have adverse effect on the electric
insulation performance.
Please remove the door, door seal and shelves before disposal of the old appliance and put them away in a safe place to prevent
children from being entrapped.
Before first use
You must allow the fridge to settle for at least twenty four hours prior to switching the power on.
It is recommended that you clean the interior of the appliance prior to first use, using a solution of bicarbonate of soda and warm
water and then thoroughly drying the interior.
The fridge may have an odour to it at first use. This will disappear as the appliance cools.
Please note:
The appliance will work continuously until it comes down to the correct temperature.
If the appliance is switched off, you should allow five minutes before switching it on again to prevent unnecessary damage to the
compressor.
Never store inflammable or explosive items and strong corrosive acids or alkalis in the appliance.
Setting the temperature
You must allow the fridge to settle for at least twenty four hours prior to switching the power on.
To adjust the temperature turn the thermostat control knob clockwise (from off) to the required level. The temperature becomes
colder the higher the number on the control.
4
Use
Fridge
• Never put liquids in the refrigerator uncovered.
• Never put hot foods in the refrigerator. Warm food should be allowed to cool to room temperature before being put into
the refrigerator.
• Nothing should rest against the rear wall of the refrigerator, as this will cause frost and possible condensation problems which
will be difficult to remove.
• Make sure food is clean and any extra water is wiped away before putting into the fridge.
• Wrap or cover food before putting into the fridge. This will help prevent the loss of moisture, keep food fresh and avoid
unpleasant odours.
• Sort foods prior to storing. Any foods to be used soon should be stored at the front of the shelf to prevent deterioration
caused by the door being open for prolonged periods.
• Do not overfill the fridge. There should be sufficient space between the foods to allow the cool air to circulate.
• Thawing frozen foods in the fridge compartment will help to keep the temperature low and save energy.
• Only open the door for as long as is necessary. Leaving the door open for long periods will affect the temperature inside the
appliance and waste energy.
• Ensure all compartments are fully closed after use.
5
Care and cleaning
Always disconnect the appliance from the power supply before any cleaning or maintenance.
The fridge sections should be cleaned using a solution of bicarbonate of soda and lukewarm water. Do not use abrasive products
or detergents. After washing, rinse and dry thoroughly.
Clean the shelves and balconies separately by hand with soap and water. Do not put them in the dishwasher.
The water drain hole at the back of the fridge compartment and the evaporating tray should be clened periodically to prevent the
defrosted water from collecting inside the fridge compartment. The drain plug can be used to clean the drain hole.
Once cleaning is complete, then reconnect the power.
• Keep the door gasket clean. If damaged, the gasket should be replaced.
• If the appliance is not used for prolonged periods of time, unplug and clean the appliance. The door should be left
slightly open to prevent the formation of mildew and smell.
Defrosting the fridge
The fridge is self-defrosting. Any water created will run out of the fridge through the channel at the back of the fridge.
It is important to keep the channel clear at all times. The defrosted water is collected in the evaporating tray at the back of the
appliance.
Changing the light bulb
Disconnect the appliance from the power.
• Carefully remove the light cover by pushing in the lever at the back of the cover, and then pulling the cover down..
• Unscrew the light bulb to remove it and replace with a new bulb (not more than 15W).
• Replace the light cover and reconnect the power after five minutes’ delay as explained on page 3.
fig. 1
6
Troubleshooting
If you have any problems with your appliance, you should check the troubleshooting prior to calling CDA Customer Care to
prevent unnecessary service calls and potential cost.
If the appliance is not working
• Check there is power to the appliance:
• The house fuses are intact and the fuse in the plug has not blown.
• The thermostat is not set to 0 (off position).
• The plug socket is functioning fine. To check this, plug another electrical appliance in to see if the socket is working.
• The temperature of the room is adequate (16°C or above).
The appliance is working, but not very well
• The appliance is not overloaded.
• The thermostat is set to an appropriate temperature.
• The door is closing properly.
• The cooling system at the rear of the appliance is clean and free of dust, and not touching the rear wall.
• There is enough ventilation at the side and rear walls.
• The temperature of the room is adequate (16°C or above).
The appliance is noisy
• The appliance is level and stable.
• The side and rear walls are clear, and there is nothing resting on the appliance.
• The cooling gas in the refrigerator will make a slight bubbling noise, even when the compressor is not running.
There is water in the lower part of the refrigerator compartment
• The drain hole in the channel at the back of the compartment is clear.
7
fig. 2
fig. 3
KIT
12
34
56
9 10
78
910
Installation
This appliance must never be installed close to heat sources i.e. heating elements, radiators, cookers or in damp
places.
The appliance should be mounted on a piece of wood (for example a section of worktop or kitchen carcass) if a
raised floor is to be fitted, if the kitchen floor is to be tiled after installation, or if the installation height of the
appliance is greater than 850 mm.
Contents and Tools Required
Fig. 2 - Installation kit contents
1. Wood screw (17 pcs)
2. Decor door fixing bracket
3. Decor door base fixings (2 pcs)
4. Decorative cover
5. Screw
6. Top bracket
Fig. 3 - Tools required
7. Spirit level
8. Spanner
9. Setsquare
10. Flathead screwdriver
8
fig. 6
fig. 4
fig. 5
600
min
550
820-
890
595 548
min 25
819-
889
100- 170
5
6
11
11
11
11
Installation
Fig. 4 - Dimensions of the appliance
Fig. 5 - Fitting the worktop bracket
Remove the screw (5) on the top of the appliance, locate the top bracket(6)
and fix the bracket with screw(5).
Fig.6 - Fitting the spacer piece
Take out the spacer piece (11) located on the side panel and remove the
protective tape. Stick the spacer piece on the opposite side to the door
hinges of the appliance.
9
fig. 9
Installation
Fig. 7 - Adjusting the appliance height
The height of the appliance can be adjusted by the help of adjustable feet to
fit the furniture height. Use a spirit level to ensure the appliance is level.
Fig. 8 - Aligning the appliance
Slide the appliance into the kitchen unit and align the hinge surface with
front surface of the kitchen unit.
Fig. 9 - Fixing the appliance
Screw the hinges and metal bracket to the kitchen unit using screws (1)
fig. 7
fig. 8
7
7
8
9
9
1
1
fig. 8
10
fig. 12
Installation
Fig. 10 - Fitting the decor door bracket
Unscrew and remove the nuts and washers from the appliance door. Place
fixing bracket on the appliance door by inserting the holes to adjustment
bolts.
Dimension B= Measure from the underside surface of kitchen unit to the
bottom of fixing bracket.
Dimension C= Measure from the underside surface of kitchen unit to the
top of next unit door.
Fig. 11 - Fitting the decor door bracket
Substract C from B and put the fixing bracket (2) in place using this
measurement for vertical position and place to the centre for horizontal
position. Secure the fixing bracket (2) using screws(1).
Fig. 12 - Fitting the decor door
Place the decor door onto the appliance door by inserting adjustment bolts
into the slots on the fixing bracket. Locate the washers and screw the nuts
onto the adjustment bolts.
fig. 10
fig. 11
2
1
B-C
C
B
Questo manuale è adatto per i seguenti modelli
1
Indice
Altri manuali CDA Frigorifero
CDA
CDA FW221 for Manuale di riferimento
CDA
CDA CW897 Manuale utente
CDA
CDA FW253 Manuale di riferimento
CDA
CDA BETTY Manuale di servizio
CDA
CDA PC52 Guida rapida
CDA
CDA CRI8851/1 Guida utente
CDA
CDA FF820 Manuale di riferimento
CDA
CDA FW224 Guida utente
CDA
CDA FF150 Manuale di riferimento
CDA
CDA FW522 Guida rapida
CDA
CDA PC65 Manuale utente
CDA
CDA CRI751 Guida utente
CDA
CDA CRI621/1 Guida utente
CDA
CDA CRI621 Guida utente
CDA
CDA FW870 for Manuale di riferimento
CDA
CDA FW820 Manuale di riferimento
CDA
CDA CRI951 Guida utente
CDA
CDA FW254/1 Guida utente
CDA
CDA PC44 Manuale di riferimento
CDA
CDA PC50 Manuale di riferimento
