Page 6
Remote Control
Remove the battery cover on the back of the handset by sliding downwards and insert 2 x AAA
batteries ensuring that the batteries are fitted correctly. Refit the battery cover.
Ensure that the ON / OFF Power Switch on the fire is in the ON position.
OPERATING INSTRUCTION WITH REMOTE CONTROL
Point the remote-control handset directly towards the fire and press the appropriate button to
operate the fire.
The remote handset has a memory function and will restart the fire with the last settings used
except for the Timer function which will always reset to off.
POWER
The Power button turns the appliance On and Off.
MODE
The mode button is used to cycle through the 3 available
setting modes –Flame , timer and heat
FLAME
When the flame icon is selected, the brightness icon
will blink for 5 seconds. During this period the flame effect
brightness can be changed using the Increase or
Decrease buttons to select one of the three available
brightness settings
( High, Medium, Low) or OFF. If no buttons are
pressed within 5 seconds the brightness icon will stop
blinking and the flame brightness will be set to memory. To
change the flame brightness again press the select button
which will blink the brightness icon allowing the flame
brightness to be changed. Note: The flame effect will not
switch off if the fire is on Low or high heat.
TIMER
When the timer icon is selected, the 00 icon will blink,
pressing the Increase or Decrease button within 5
seconds will adjust the shut-off timer range from 1-8 hours.
If no buttons are pressed within 5 seconds the timer icon
will stop blinking and the timer will be set to memory. To
change the timer again press the select button which
will blink the timer icon allowing the duration to be changed.
To switch off the timer function set this to 00.
