page 4 of 5
Installing Media
Option 1: FANFOLD Badge Stock
1.Open the front face of the printer
by lifting the dark gray latch UP.
2.Open the back panel of the
printer and lift the blue lever to
adjust the media guide.
Feed the fanfold with the black
timing mark facing down and
blank/pre-printed side facing up
with the timing mark leading out
first.
3.Pull the dark gray lip down in the
center of the media dispenser
and adjust the media guide.
Push the lip back up, lock in
place, and close the front door to
begin auto calibration.
Note: Be sure your media behind the printer is not obstructed or feeding at
angles to prevent random tears.
