Christie DHD700 Manuale utente
DHD700/DHD800 Lamp/Filter Replacement Instruction Sheet 1 of 4
020-000207-02 Rev. 1 (10-2010)
DHD700/800 Lamp/Filter Replacement
Instruction Sheet
INTRODUCTION
These instructions outline the details for Lamp and Filter replacement in the DHD700 (Model No. 103-
022105-01) and DHD800 (Model No. 103-029102-01) projectors. NOTICE: Use only a Christie
approved Lamp and Filter Kit for your specific projector model.
KITS REQUIRED
DHD700
003-120504-01 (Replacement Lamp)
003-001726-01 (Replacement Air Filter)
DHD800
003-120577-01 (Replacement Lamp)
003-003378-01 (Replacement Air Filter)
INSTRUCTIONS
LAMP REPLACEMENT
When the projection lamp reaches its end of life, the Lamp
Replacement icon appears on the screen and the LAMP 1/2
REPLACE indicator lights orange. Replace the lamp with a
new one promptly. The timing when the LAMP 1/2
REPLACE indicators should light depends on the lamp mode.
NOTES: 1) The Lamp replacement icon will not appear when
the Display function is set to “Off”, or during “Freeze”. 2) It
is recommended that both lamps be changed at the same time
in order to maintain picture quality (better color balance and
brightness). Figure 1 Lamp Replacement Icon
2 of 4 DHD700/DHD800 Lamp/Filter Replacement Instruction Sheet
020-000207-02 Rev. 1 (10-2010)
Always power down and disconnect/disengage all power sources to the
projector before servicing or cleaning.
Allow the projector to cool for at least 45 minutes before the lamp cover is
opened. The inside of the projector can become very hot and may cause injury.
Do Not operate the projector while any of the lamps are removed. This may
result in malfunctions, fire hazard, or other possible accidents.
NOTICES: 1) For continued safety, replace with a lamp assembly of the same type. 2) Do not drop
the lamp assembly or touch a glass bulb! The glass can shatter and may cause injury.
Use the Lamp Status Display to verify which lamp needs to be
replaced.
1. Loosen the lamp cover screw (Figure 1-Top) and lift the
cover.
2. Loosen the 2 screws (Figure 1-Bottom) that attach the
lamp unit to the projector.
3. Use the handles to remove the lamp unit from the
projector (Figure 1-Bottom).
4. Set the new lamp unit into place and tighten the 2 screws
that attach it to the projector.
5. Slide the lamp cover back into place, and tighten the lamp
cover screw.
Figure 2 Lamp Replacement
DHD700/DHD800 Lamp/Filter Replacement Instruction Sheet 3 of 4
020-000207-02 Rev. 1 (10-2010)
REPLACING THE FILTER CARTRIDGE
Always power down and disconnect/disengage all power sources to the
projector before servicing or cleaning.
Allow the projector to cool for at least 45 minutes before the lamp cover is
opened. The inside of the projector can become very hot and may cause injury.
NOTE: To maintain normal internal ventilation replace the filter unit periodically.
1. Use a vacuum cleaner to remove dust on and around the filter
cover (Figure 3-Top-Left).
2. Lift and pull the bottom clips to remove the filter cover
(Figure 3-Top-Right).
3. Pinch and pull the filter clips to remove the filter unit (Figure
3-Bottom-Left).
4. Use a vacuum cleaner to remove dust on and around the
intake vents of the projector (Figure 3-Bottom-Right).
5. Install the new filter unit into the place.
6. Install the filter cover.
NOTICES: 1) Make sure the filter cartridge is correctly inserted
into the projector otherwise, the projector cannot be turned on. 2)
Do not block the air vents. Doing so may result in malfunction of
the projector. 3) When using the projector under dusty or smoky
conditions, dust may accumulate on a lens, liquid crystal panels,
or optical elements inside the projector. Such conditions may
degrade the quality of the projected image. When the symptoms
above are noticed, contact your authorized dealer or service
station for proper cleaning.
Figure 3 Filter Replacement
4 of 4 DHD700/DHD800 Lamp/Filter Replacement Instruction Sheet
020-000207-02 Rev. 1 (10-2010)
RESETTING THE FILTER COUNTER
1. Switch the power button to ON.
2. Press the MENU button to display the On-Screen
Menu. Use the cursor buttons to move the red
frame pointer to the Setting Menu icon (Figure 3).
3. Use the Point buttons to move the red frame
pointer to Filter counter and then press the SELECT
button. A dialog box appears showing the Used time
option and the Scrolls remaining option. Use the Point
buttons to select Used time.
4. Used time shows the total accumulated time of the filter
use, a timer setting option, and the Reset option. Select
Reset and the “Filter counter Reset?” appears. Select
[Yes] to continue.
5. Another confirmation dialog box appears, select [Yes]
to reset the Filter counter.
NOTES: 1) The FILTER TIME value shown on the EASY
menu is the use time since the last time the FILTER TIME
was reset. Refer to the value for proper maintenance. 2) Do
not reset the FILTER TIME without replacing a filter.
RESETTING THE FILTER COUNTER
1. Switch the power button to ON.
2. Press the MENU button to display the On-Screen
Menu. Use the Point buttons to move the red frame
pointer to the Setting Menu icon.
3. Use the Point buttons to move the red frame pointer
to Filter counter and then press the SELECT button. A
dialog box appears showing the Used time option and
the Scrolls remaining option. Use the Point buttons
to select Scroll(s) remaining.
4. Scroll(s) remaining shows the number of the remaining
scrolls and the Reset option. Select Reset and the “Scroll
counter Reset?” appears. Select [Yes] to continue.
5. Another confirmation dialog box appears, select [Yes]
to reset the Scroll counter.
Figure 4 Filter Counter
Figure 5 Scroll Counter
Altri manuali per DHD700
1
Questo manuale è adatto per i seguenti modelli
1
Indice
Altri manuali Christie Proiettore
Christie
Christie CP2215 Manuale utente
Christie
Christie DS+405 Manuale utente
Christie
Christie M Series Manuale utente
Christie
Christie CCM-LX Manuale utente
Christie
Christie CP2308-C Guida utente
Christie
Christie Mirage S+14K Manuale utente
Christie
Christie LW555 Manuale utente
Christie
Christie 38-VIV208-01 Manuale utente
Christie
Christie Mirage SIM Manuale utente
Christie
Christie M RGB Series Istruzioni per il montaggio
Christie
Christie DWU1052 Manuale utente
Christie
Christie DS+26 Manuale utente
Christie
Christie Solaria One Manuale utente
Christie
Christie CP2320-RGB Istruzioni per il montaggio
Christie
Christie DWX600-G Manuale utente
Christie
Christie Roadster X4 Manuale utente
Christie
Christie CP2230 Manuale utente
Christie
Christie Roadster S+12K Manuale utente
Christie
Christie Q Series Guida utente
Christie
Christie LX1200 Manuale utente
