INSTALLATION AND USER MANUAL
HTM-24E
3 V0REV5ES1218
1. INTRODUCTION
Thank you for buying a product manufactured by CLIMER TECHNOLOGY. This product, has
been manufactured according to the European Quality Standards, incorporates prime grade
materials and its correct working has been tested before it leaves our facilities.
Through this Installation and User Manual, you will be guide towards the correct and safety
installation of the product. It is necessary to carefully read this manual before make any
handling to avoid problems arising from the misuse of the product.
The company CLIMER TECHNOLOGY reserves the right to modify the information included
in this document at any time without prior notice.
2. GENERAL INDICATIONS
1. Safety notes
- The incorrect or inappropriate use of this product could lead to hazardous
situations, causing damage or injuries to the user, third parties or even to the
product itself or material goods.
- The installer has the responsibility to install the minimum safety devices
(hydraulic and electrical) set out in this Manual. In case of failure, the lack of any
device may cause burns or other injuries.
- The installer has the responsibility to inform the user about the function and
placement of the safety devices installed into the device and the installation.
- The water outlet temperature could reach 65 degrees (depending on the model).
Do not touch the pipes while the system is working to avoid any risk of burns.
- Do not use not approved anticorrosive materials in the water circuit. It may cause
damage to the components.
- The system has to be charged with R407C coolant (depending on model).
These coolants should not be released to the atmosphere. It is responsibility of
the installer to check the tightness of the installation before making the gas
charge.
