CNB MPC1070PN Manuale utente

MPC1070PN

5M Pixel Panoramic IP Camera

r’

’s

Rev.1.0 (Dec. 2013) 2

Caution

Any changes or modifications in construction of this device which are not explicitly

approved by the party responsible for compliance could void the user’s authority to

operate the equipment.

Note

This equipment has been tested and found to comply with the limits for a Class A digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generate, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the following

measures:

 Reorient or relocate the receiving antenna.

 Increase the separation between the equipment and receiver.

 Connect the equipment into and outlet on a circuit different from that to which

the receiver is connected

 Consult the dealer or an experienced radio/TV technician for help.

Directions

Be careful not to cause any physical damage by dropping or throwing MPC1070PN. Especially

keep the device out of reach from children.

Do not disassemble MPC1070PN. No After Service is assumed when disassembled.

Use only the power adapter provided with MPC1070PN.

Be careful to prevent moisture or water penetration into the unit. Particular attention is

needed when installing MPC1070PN. The screw holes for the installation screws and pipe

should be maintained water tight during the whole life time of the product.

All the electrical connection wires running into the unit should be prepared so that water from

the outside cannot flow into the unit through the surface of the wires. Penetration of the

moisture through the wire for extended period can cause malfunction of the unit or

deteriorated image.

r’

’s

Rev.1.0 (Dec. 2013) 3

Revision History

Date Revision Details

2013-12-01 1.0 First manual revision creation.

r’

’s

Rev.1.0 (Dec. 2013) 4

Contents

1. Introduction .............................................................................................................................................. 5

1.1. Overview ............................................................................................................................................. 5

1.2. Specification ........................................................................................................................................ 6

1.3. Applications of MPC1070PN ................................................................................................................ 7

2. Product Description ................................................................................................................................. 8

2.1. Contents ............................................................................................................................................. 8

2.2. Product Preview .................................................................................................................................. 8

2.3. Physical description............................................................................................................................. 9

2.3.1. External View ............................................................................................................................ 9

2.3.2. Dimension ................................................................................................................................. 9

2.3.3. External Connector .................................................................................................................. 10

2.3.4. Factory Default Switch............................................................................................................. 10

2.4. Functional Description ....................................................................................................................... 11

3. On Site Installation ................................................................................................................................. 13

4. Getting Started ....................................................................................................................................... 14

4.1. PC Requirement................................................................................................................................ 14

4.2. Quick Installation Guide ..................................................................................................................... 15

4.2.1. Connect PC and MPC1070PN to network. ............................................................................... 15

4.2.2. Install “IP installer and set IP parameters on MPC1070PN ....................................................... 15

4.2.3. Remote video connection to MPC1070PN ............................................................................... 17

4.2.4. Additional settings through connection to the Admin Page ....................................................... 18

4.2.5. Panoramic viewing through NVR-Pro....................................................................................... 19

5. Trouble Shooting ................................................................................................................................... 20

5.1. No power is applied ........................................................................................................................... 20

5.2. Cannot connect to the Video ............................................................................................................. 21

5.3. Windows Vista or Windows 7............................................................................................................. 22

5.4. Technical Assistance ......................................................................................................................... 25

Appendix A – Important Notice in Exchanging SD Card (Micro SD)...................................................................... 26

r’

’s

Rev.1.0 (Dec. 2013) 5

1. Introduction

1.1. Overview

The MPC1070PN is panoramic IP camera offering panoramic view of 360 or 180 for covering entire

surveillance area with a single IP camera. 5 Mega Pixel image from Panomorph camera module can replace up

to 4 PTZ cameras and 5 fixed cameras. It enables real time transmission of synchronized video of up to

2,592x1,944(10fps) video and audio data. Remote clients can connect to MPC1070PN for the real time

video/audio data through various client solutions running on PC or smart device. Real time 2-way

communication is available through bidirectional audio communication feature.

Designed to be a stand-alone streaming audio & video transmission device, MPC1070PN can be applied to

various application area such as video security, remote video monitoring, distance education, video conference

or internet broadcasting system.

Vandal proof and weather proof housing will extend the application area to harsh environment of wide

temperature range. Embedded PoE (Power over Ethernet, IEEE 802.3af) will enable the owner to reduce TCO

(Total Cost of Ownership) by reducing on-site wiring works for the installation.

Original Video

PTZ mode

Pan/Tilt/Zoom Control

Quad mode

Each sub-screen with independent

Pan/Tilt/Zoom replaces 4 independent

PTZ cameras.

Perimeter mode

2 x180 views with panning control for

ceiling mount. One 180 views for wall

mount. Replaces two 180 cameras..

Up to 5 crop windows of 320 x 240.

Replaces up to 5 fixed cameras.

r’

’s

Rev.1.0 (Dec. 2013) 6

1.2. Specification

Camera

Image sensor Progressive scan 1/2.5 inch CMOS 5.0M pixels

Full resolution 2,592 x 1,944 pixels

Min. illumination Color : 0.12 Lux (F1.4)

S/N Ratio 47dB or more

White Balance AWB

Sync System Internal

Lens 0.98~1.12mm Panomorph lens

Day & Night Not Supported

Video

Compression method Simultaneous Dual Codec (H.264 / MJPEG)

Resolution 2592x1944@10fps

Multi-Profile Streaming - 5 simultaneous video profiles

- Select the codec type, resolution and frame rates for each profile.

Intelligent Bit-Rate Control Hybrid Bit Rate control (VBR+CBR)

PTZ Digital PTZ & video crop

Image Setting Text overlay, Privacy mask, De-interlace filter

Motion detection 3 regions

Audio

Mono Upstream 32Kbps G.726 ADPCM ~ MIC/Line-in

Mono Downstream 64Kbps 8-bit μ-law PCM ~ Line-out

Network

Network Protocol

- IPv4/v6, TCP, UDP, IGMP, ICMP, ICMPv6, ARP, RARP, PPPoE, RTCP

- RTP, RTSP, SDP, HTTP, HTTPS, SMTP, FTP, DHCP, UPnP

- NTP, DNS, DynDNS, SOCKS

Dynamic IP Supported (through CNB’s management server)

Security - User ID & Password protection, IP address filtering

- HTTPS encryption, Digest Authentication, User Access Log

r’

’s

Rev.1.0 (Dec. 2013) 7

External Terminals

LAN 10/100BaseT LAN (auto MDIX)

Analog output 1 channel D1 CVBS output of the encoding video

Alarm input / output Alarm I/O (1 Sensor input & 1 Relay output)

Factory Reset Supported

other MIC, Line in / Line out / 12V DC in

Alternate Power

Standard PoE (IEEE802.3af) Supported

Alarm & Event

Intelligent Video Motion Detection + IVS module(option)

Alarm Triggers Intelligent Video + Sensor Input

Alarm Events Video file upload(FTP), Still Image

transmission(Email),

PTZ presets, Relay output.

Video Buffer 00 sec Pre-alarm & 00 sec Post-alarm

Client Software

NVR-Pro 64ch@D1(free of charge)

Smart App. Android, iOS

Miscellaneous

Operating Temperature 0



C ~ 45



C (32



F~113



Operation Humidity 8~80% RH

Power 12V DC, 1A

Dimensions(WxD) 122mm(4.8”) x 55mm(2.1”)

Weight 0.4Kg (0.88Lb)

Casing AL, PC

Approvals FCC, CE, KCC, RoHS

Package information IP camera, CD (User’s guide, Software…)

1.3. Applications of MPC1070PN

 Security surveillance (buildings, stores, manufacturing facilities, parking lots, banks, government facilities,

military, etc.)

 Remote monitoring (hospitals, kindergartens, traffic, public areas, etc.)

 eleconference (Bi-directional audio conference). Remote Learning, Internet broadcasting

 Weather and environmental observation

r’

’s

Rev.1.0 (Dec. 2013) 8

2. Product Description

2.1. Contents

The product package contains followings :

Contents Description Remarks

MPC1070PN IP camera MPC1070PN main unit

Accessories

CVBS Cable 1EA,

Screws (3 pieces of 1 type),

Anchors (3 pieces of 1 type),

L-type wrench with six angles 1EA

CD Software & User’s Guide

Quick Reference Guide Quick installation guide

Power Adaptor Default built in standard PoE module

(IEEE802.3af)

12V DC Adaptor

(Optional item)

2.2. Product Preview

MPC1070PN IP-Installer CMS Software (NVR)

Vandal Proof

Pancake IP Camera

PC software to allocate an IP

address to the IP Camera

PC software to view and record the

A/V streaming data transmitted from

IP camera.

(Simultaneous support of up to 64

IP cameras@D1)

r’

’s

Rev.1.0 (Dec. 2013) 9

2.3. Physical description

2.3.1. External View

Figure 2-1. External view of MPC1070PN

2.3.2. Dimension

Unit : mm

Figure 2-2. Dimension

r’

’s

Rev.1.0 (Dec. 2013) 10

2.3.3. External Connector

Figure 2-3. Connector for external connection

2.3.4. Factory Default Switch

Factory default switch is provided for returning the IP camera to factory default state. Unscrew the cover to

access the switch. There are two functions assigned to factory default switch.

1. Returning to Factory Default State : Press the switch about 5 seconds while power is applied to

return to factory default state.

2. Safe Removal of Micro-SD Card : Press the switch for 1 second to unmount Micro-SD Card for safe

removal.

Figure 2-4. Factory Default switch and Micro-SD Card slot

Factory Default Switch

Micro SD Card slot

Network (LAN)

Power

Sensor Input (white(+), Red(-))

Relay Output (Black(+), Yellow(-))

Mic/Line Input

Line Output

Altri manuali per MPC1070PN

Indice

Altri manuali CNB Telecamera IP

CNB

CNB S2465NX Manuale utente

CNB

CNB LXC1050IR Manuale utente

CNB

CNB MPC1070PN Manuale utente

CNB

CNB AN802IR Manuale utente

Manuali Telecamera IP popolari di altre marche

FLIR

FLIR Exx series Manuale utente

Avigilon

Avigilon H4A-BO1-IR Manuale utente

Digital Watchdog

Digital Watchdog DWCA-C128-64 Manuale utente

ShareTech

ShareTech AV1 Manuale utente

Ezviz

Ezviz C6C Manuale utente

Melchioni

Melchioni UCAM 2015 Manuale utente

Geutebruck

Geutebruck G-Cam/ESD-4630 Manuale utente

Arecont Vision

Arecont Vision MegaBall AV3146DN-3310-D-LG Manuale utente

Mitel

Mitel 6800i Series Manuale di servizio

Vitek

Vitek VTC-IR403-212NP Manuale utente

THOMSON

THOMSON DSC - 323W Manuale utente

AVer

AVer FB2027 Manuale utente

ENFORCER

ENFORCER EV-T5105-N2SQ Manuale utente

Wansview

Wansview NC543 Manuale utente

Eneo

Eneo MCB-64A0003M0A Manuale utente

deView electronics

deView electronics CBDNI36F Manuale utente

Swann

Swann SwannEye Manuale utente

LevelOne

LevelOne IP CamSecure Manuale utente