Copyright © 1992 by Commodore Electronics Limited. All rights Reserved. This document may not, in
whole or
in
part, be copied, photocopied, reproduced, translated or reduced to any electronic medium or
machine readable form without prior consent,
in
writing, from Commodore Electronics Limited.
With this document Commodore makes no warranties or representations, either expressed, or implied,
with respect to the products described herein. The information presented herein
is
being supplied on an
"AS IS" basis and
is
expressly subject
to
change without notice. The entire risk as to the use of this
information is assumed by the user.
IN
NO
EVENTWILL COMMODORE
BE
LIABLE FOR ANY
DIRECT, INDIRECT, INCIDENTAL, OR CONSEQUENTIAL DAMAGES RESULTING FROM ANY
CLAIM ARISING
OUT
OF THE INFORMATION PRESENTED HEREIN, EVEN IF IT HAS BEEN
ADVISED OF THE POSSIBILITIES OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE
LIMITATION OF IMPLIED WARRANTIES OR DAMAGES, SO THE ABOVE LIMITATIONS MAY NOT
APPLY.
Commodore and the Commodore logo are registered trademarks of Commodore Electronics Limited.
Amiga
is
a registered trademark, and AmigaDOS, Bridgeboard, Kickstart, and Workbench are
trademarks, of Commodore-Amiga, Inc. Hayes
is
a registered trademark of Hayes Microcomputer
Products, Inc. Centronics
is
a registered trademark of Centronics Data Computer Corp. Motorola is a
registered trademark, and 68030 and 68EC020 are trademarks, of Motorola Inc. MultiSync
is
a
registered trademark of NEC Technologies Inc. ARexx
is
a trademark of William
S.
Hawes. MS-DOS
is
a registered trademark of Microsoft Corporation.
NOTE: This equipment has been tested and found
to
comply with the limits for a Class B digital device,
pursuant to Part 15 of FCC Rules. These limits are designed
to
provide reasonable protection against
harmful interference
in
a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used according with the instructions, may cause harmful
interference to radio communications. However, there
is
no guarantee that interference will not occur
in
a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user
is
encouraged to try
to correct the interference
by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into
an
outlet
on
a circuit different from that to which the receiver
is
connected.
• Consult the dealer or
an
experienced radiorrV technician for help.
CAUTION: Only equipment with shield-grounded cables (computer input-output devices, terminals,
printers, etc.) certified to comply with appropriate FCC limits can be attached to this device.
Operation with non-certified equipment may result
in
communications interference. Changes or
modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the device.
This digital apparatus does not exceed the Class B electromagnetic noise emission limits for digital
apparatus as defined
in
the radio interference regulations of the Canadian Department of
Communications.
Le present appareil numerique n'emet pas de bruits radioelectriques depassant les limites applicables
aux appareils numeriques de Classe B prescrites dans le reglement sur le brouillage radioelectriques
edicte par le Ministere des Communications du Canada.
Printed in Germany, Hong Kong, the Philippines, Singapore, Taiwan and the United Kingdom.
This book was produced using a variety
of
Commodore systems by Ross
Hippely, Wilson Harp, and Carina Ahren,
PIN:
368997-01
