CORAVIN 1000 Manuale utente

Removing the Coravin System from the Box

• To remove your Coravin 1000 from the box, gently grasp the unit around the logo

and lift upwards.

• Peel back the protective packaging tape – this protects it from scung during

shipment.

• Carefully remove and discard the yellow covers on the spout and the needle.

These coverings are for shipping purposes only and are not needed to operate or

maintain the Coravin System. PLEASE BE CAREFUL – THE NEEDLE IS SHARP.

SETUP

DISCARD

GETTING STARTED

MAKE SURE the clamp

is up to easily access

the black cup that will

contain the Coravin

Capsule

TWIST ocapsule cup

INSERT Coravin Capsule

TWIST the cup back onto

the unit quickly and tightly,

then give it an extra half

turn for proper seal

SLIDE clamp down

DO NOT UNTWIST CAPSULE

CUP UNTIL CORAVIN

CAPSULE IS EMPTY. THIS WILL

RESULT IN THE LOSS OF

UNUSED GAS.

INSERTING THE CAPSULE

In the down position

SQUEEZE clamp and

PLACE on bottle

CHECK the needle to

ensure it’s fully tighten

into the system

ENSURE needle guide is on

top of cork (foil)

RELEASE clamp

PLACE bottle into a

Coravin wine bottle sleeve

and zip it closed

ACCESSING THE BOTTLE

TAP trigger quickly

(a fraction of a second) to

release a short burst of gas

to clear needle of old wine

PRESS needle through the cork and

ENSURE needle is all the way down

GRIP bottle with your

dominant hand with

spout facing the glass

TILT bottle up as shown so

the base of bottle is higher

than spout

NOTE: For best results,

ensure spout is pointed

at the side of the glass

INSERT ﬁngers of your

other hand through the handle,

leaving your thumb free

TILT

POURING THE WINE

PRESS trigger (1/2 second) and

quickly release to pour wine

TILT bottle to upright position to stop pouring

REPEAT when wine slows or

stops

NOTE: Longer

trigger presses will

be needed as the

bottle empties.

NOTE: Coravin may

hiss, releasing excess

pressure from bottle.

GRASP clamp ﬁrmly and

PULL up on handle to

remove needle

SQUEEZE clamp to remove

from bottle

PLACE on stand and

TAP trigger quickly

(a fraction of a second)

to clear any excess

wine

REMOVE wine bottle sleeve

REMOVING THE CORAVIN

CLEANING THE CORAVIN

PLACE spout of the Cora-

vin System under a small

stream of warm water to

rinse; allow water to ﬂow

out of needle

DO NOT PRESS THE TRIGGER

WHILE RINSING THE SPOUT.

REMOVE from and

PRESS trigger to release a

short burst of gas to clear

any excess water from

system

DRY with soft cloth to re-

move any water that may

be left on device

YOUR CORAVIN SYSTEM

is now ready to use.

Indice

Altri manuali CORAVIN Utensile da cucina

CORAVIN

CORAVIN Model Eleven Manuale utente

Manuali Utensile da cucina popolari di altre marche

Bourgini

Bourgini 41.0016.00.00 Manuale utente

Hamilton Beach

Hamilton Beach 74150 Manuale utente

Spring

Spring CBS Manuale utente

Rohe

Rohe GP 001 Guida alla configurazione

Melissa

Melissa 646-035 Manuale utente

NuWave

NuWave 31760 Manuale utente

Miele

Miele KMTY Manuale utente

Weston

Weston 07-0301 Manuale utente

Westfalia

Westfalia 849372 Manuale utente

IKEA

IKEA TROVÄRDIG Manuale utente

IKEA

IKEA UNDERSÖKA Manuale utente

TRFL

TRFL LoafNest Guida rapida

NEFF

NEFF T4..3.. Manuale utente

Schulte-Ufer

Schulte-Ufer De Luxe i Series Guida alla configurazione

Cook's Companion

Cook's Companion IntelliBag Series Manuale utente

Breville

Breville EW30XL Manuale utente

Genius

Genius Nicer Dicer Chef S Manuale utente

Swissmar

Swissmar 3-in-1 fondue set Istruzioni operative