CrimeStopper RS-800.IV Manuale utente
RS800 Series IV
Remote Engine Starting System
OPERATING INSTRUCTIONS
OPERATION CAUTIONS & WARNINGS
CRIMESTOPPER SECURITY PRODUCTS, INC. and its VENDORS shall not be liable for any accident resulting from
the use of this equipment. This system is designed to be professionally installed onto a vehicle in which all items, such
as parking brake and all associated components, door switches, transmission shift linkage, throttle linkage, and all
engine safety features, are in perfect working condition. This is a basic remote start system only; there are no keyless
entry functions built into the RS-800 IV. We recommend keeping your vehicle locked for safety when remote starting.
DO NOT install this Remote Engine Starting System on MANUAL TRANSMISSION vehicles. If accidentally left in
gear the vehicle could become a self-propelled threat to life and property.
IT IS ABSOLUTELY THE OWNER’S SOLE RESPONSIBILITY TO: A) Understand the operation of this system and its
safety features. B) Check for proper operation of these safety features prior to accepting delivery of the vehicle from the
installation facility. C) Check and maintain the condition of the vehicle and all items relative to the proper operation of
this system and its safety features. D) Always leave the doors and windows closed and locked to protect against
accident and theft.
DO NOT remote start the vehicle in a closed garage. Make sure that the garage door is open or there is adequate
ventilation. Failure to observe this rule could result in injury or death from poisonous Carbon Monoxide fumes.
This device complies with FCC Rules part 15. Operation is subject to the following two conditions: 1)
This device may not cause interference, and (2) this device must accept any interference that may be
received, including interference that may cause undesired operation. The manufacturer is not
responsible for any radio or TV interference caused by unauthorized modification to this equipment.
Such modification could void the user's authority to operate the equipment.
REV. A 08/2003
OPERATIONOPERATION
REMOTE ENGINE STARTING - SUCCESSFUL START:
1. Press start button for at least one second, then release.
2. Parking lights flash once, then turn ON along with the IGN/ACC circuits
3. After a few seconds the Starter Motor engages. (Parking lights and Acc
circuits turn off while cranking.)
4. Engine Starts and Runs. Parking Lights and Acc turn back on.
5. Engine will remain running for programmed run time or until reset with
Brake pedal.
REMOTE ENGINE STARTING - UNSUCCESSFUL START
In the event that the engine does not start on the first attempt, the system
shuts down for a few seconds, and then attempts to restart the engine a 2nd
and 3rd time. For hard starting engines, the unit will allow a starter crank time
of up to a maximum of 13 seconds. This should provide ample cranking time
for difficult starts, but is limited to help prevent damage to the starter from over cranking in the case of a problem with the
system.
1. If engine starts on 2nd or 3rd attempt, see steps 4 & 5 above of "Successful Start".
2. If Third attempt fails to start engine the system will abort. NO FURTHER ATTEMPTS WILL BE MADE
AUTOMATICALLY
TURNING OFF A REMOTE STARTED ENGINE:
1. Engine is running in Remote Start (Parking lights are ON).
2. Press start button for at least one second and release.
3. Engine and parking lights turn off.
VALET MODE
Before servicing your vehicle or handing the keys over to a Valet we recommend putting the unit into valet mode. The
remote start function WILL NOT operate when in Valet mode. To enter Valet mode, turn the key to the ON position,
press and hold Program/Valet switch for 6 seconds. The LED will turn on solid and the system is now in valet. Perform
this procedure again to exit of Valet mode.
HOOD OPEN SAFETY SWITCH (WITH INSTALLED HOOD PIN SWITCH)
A safety hood pin switch (when installed along with the remote start system) helps eliminate the risk of injury to someone
working under the hood. If will prevents the engine from being remote started while the hood is open. It will also abort a
remote started engine.
2
OPERATION
ANTI-GRIND / STARTER DISABLE (OPTIONAL)
Prevents the driver from accidentally grinding the starter if the Ignition key is turned too far (to the start position) while
engine is already running from the remote starter.
BRAKE PEDAL RESET CIRCUITRY
Prevents starting or shuts off a remote started vehicle when this circuit is active or activated. Prevents unauthorized
tampering. This circuit shuts the system down immediately when brake pedal is pressed if key is not in ignition and
turned to the run position.
LED (OPTIONAL)
The optional LED (if installed) is used as a indicator for Valet mode and also lights solid during programming options.
NOTE:
In the event of a malfunction, jumpstarting or performing electrical service you should remove the main Power Fuses.
TRANSMITTER PROGRAMMING
Note: All transmitter codes must be learned at time of programming!! The RS800 allows storage of up to 4
different transmitter codes.
1. Open Hood (Ground Gray hood pin wire if no hood pin is installed).
2. Turn key to the ON position.
3. Press Programming button 4 times. After a few seconds, the unit will flash the parking lights 4 times.
4. Press the Start Button of the transmitter to be coded. You should get 2 light flashes indicating the unit is waiting for a
2nd code, then press start button of a second transmitter, the unit will flash 3 times indicating its waiting for the 3rd
code and 4 flashes for the 4th code. If all 4 codes are learned, the unit will automatically exit code-learning mode,
otherwise turn key off and close hood.
2-VEHICLE OPERATION
The RS-800 IV system can be used for 2-car operation. A single RS800 IV remote control can operate two independent
vehicles with RS800 IV systems installed.
SETUP:
1. Using the switch on the side of the remote set your controller to Car II.
2. At Car II: Simply follow the transmitter programming steps listed above. Learn YOUR remote, along with Car 2’s
existing remotes.
3
ONLINE TECHNICAL SUPPORT
www.crimestopper.com/techweb03.html
www.crimestopper.com
Phone (800) 998-6880
FAX (805) 581-9500
© 2003 Crimestopper Security Products
Altri manuali per RS-800.IV
1
Indice
Altri manuali CrimeStopper Avviamento remoto
CrimeStopper
CrimeStopper Cool Start RS-850 Manuale utente
CrimeStopper
CrimeStopper EZEE START EZ-10 Manuale utente
CrimeStopper
CrimeStopper RSX-G6 Manuale utente
CrimeStopper
CrimeStopper EZEE Start EZ-45DP Manuale utente
CrimeStopper
CrimeStopper RS-999.FM Manuale utente
CrimeStopper
CrimeStopper Cool Start RS-1300DP Manuale utente
CrimeStopper
CrimeStopper Cool Start RS-3 Manuale utente
CrimeStopper
CrimeStopper CS-9704 Manuale utente
CrimeStopper
CrimeStopper Ezee Start EZ-90 Manuale utente
CrimeStopper
CrimeStopper EZEE Start EZ-3 Manuale utente
CrimeStopper
CrimeStopper Cool Start RS-1405DP Manuale utente
CrimeStopper
CrimeStopper Ezee Start EZ-30DP Manuale utente
CrimeStopper
CrimeStopper CoolStart RS900ER Manuale utente
CrimeStopper
CrimeStopper RS-901.III Manuale utente
CrimeStopper
CrimeStopper RS-901.V Manuale utente
CrimeStopper
CrimeStopper EZEE Start EZ-45DP Manuale utente
CrimeStopper
CrimeStopper RS-800.III Manuale utente
CrimeStopper
CrimeStopper RS-800 Manuale utente
CrimeStopper
CrimeStopper Cool Start RS-00 Manuale utente
CrimeStopper
CrimeStopper EZEE Start EZ-1 Manuale utente
