D-Link DCS-4602EV Manuale utente
This document will guide you through the
basic installation process for your new
D-Link Network Camera.
DCS-4602EV
Documentation also available on
CD and via the D-Link Website
Quick Installation Guide
Vigilance Full HD OutdoorVandal-Proof PoE Dome Camera
Quick Installation Guide
Installationsanleitung
Guide d’installation
Guía de instalación
Guida di Installazione
Краткое руководство по установке
Guia de Instalação Rápida
快速安裝指南
Petunjuk Pemasangan Cepat
D-Link DCS-4602EV Quick Installation Guide 1
ENGLISH
Quick Installation Guide
This installation guide provides basic instructions for installing the Network Camera on
your network. For additional information about how to use the camera, please see the
User Manual which is available on the CD included in this package or from the D-Link
support website.
Package Contents
DCS-4602EV Vigilance Full HD Outdoor Vandal-Proof PoE Dome Camera
Cable Waterproofing Connector
Rubber Power Connector Plug
Mounting Kit
Manual and Software on CD-ROM
Quick Installation Guide
If any of the above items are missing, please contact your reseller.
Safety Notice:
Installation and servicing should be done by certified technicians so as to conform to all
local codes and prevent voiding your warranty.
D-Link DCS-4602EV Quick Installation Guide
2
ENGLISH
Hardware Overview
IR LEDs
Provide illumination for
low-light environments
Camera Lens
Reset Button
Resets camera back
to the factory default
settings
Grounding Screw
Attach to a grounding wire
if desired
Ethernet Jack
RJ-45 connector for Ethernet which can also be used to
power the camera using Power over Ethernet (PoE)
Power Connector
Connects to an optional 12 V / 1.5 A
power adapter (not included)
Protective Cover
Cover Screws
The three screws can be
removed with the included
wrench
Tilt Adjustment Screw
Can be loosened to adjust
camera angle
Inner Cover
D-Link DCS-4602EV Quick Installation Guide 3
ENGLISH
Configuring the Camera
Insert the DCS-4602EV CD into your computer's CD-ROM drive to begin the installation.
If the Autorun function on your computer is disabled, or if the D-Link Launcher fails to
start automatically, click the Start button and type D:\autorun.exe (where D: represents
the drive letter of your CD-ROM drive) and press Enter.
Click on the D-Link Setup Wizard SE icon that was
created in your Windows Start menu (Start > D-Link >
Setup Wizard SE).
The Setup Wizard will appear and display the MAC
address and IP address of your camera(s). If you have a
DHCP server on your network, a valid IP Address will be
displayed. If your network does not use a DHCP server,
the network camera's default static IP 192.168.0.20 will be
displayed.
Select your camera, then click the Wizard button to
continue.
Click Setup Wizard and follow the instructions to install
the Setup Wizard.
Enter the Admin ID and password. When logging in for
the first time, the default Admin ID is admin with the
password left blank.
Click the checkboxes if you wish to change the admin ID
and password for the camera, and enter the new ID and
password you wish to use.
Click Next to continue.
Select DHCP if your camera obtains an IP address
automatically from a DHCP server such as a router.
Select Static IP if you want to manually enter the IP
settings for the camera.
Click Next to continue.
D-Link DCS-4602EV Quick Installation Guide
4
ENGLISH
ViewingYour Camera via Web Browser
Click on the D-Link Setup Wizard SE icon that was
created in your Windows Start menu (Start > D-Link >
Setup Wizard SE).
Select the camera and click Link to access the web
configuration.
The Setup Wizard will automatically open your web
browser to the IP address of the camera.
This section displays your camera’s live video.You can
select your video profile and view or operate the camera.
For additional information about web configuration, please
refer to the user manual included on the CD-ROM or the
D-Link website.
Enter admin as the default username and leave the
password blank. Click OK to continue.
Take a moment to confirm your settings and click Restart.
D-Link DCS-4602EV Quick Installation Guide 5
ENGLISH
Mounting Instructions
It is highly recommended that you configure and test your camera before mounting it.
Place the mounting sticker where you want to position the
camera.
Use a 6 mm drill bit to make the required holes
approximately 25 mm deep, then insert the wall anchors
into the holes.
If you are running the camera cables through the wall,
drill a hole in the center and pull the cables through the
hole.
Use the included wrench to loosen the 3 screws on the
top of the camera, then lift the camera cover off.
Use the screws provided to mount the camera to the wall.
If you are running the camera cables out the side of
the camera, guide the camera cables through the cable
channel on the base.
D-Link DCS-4602EV Quick Installation Guide
6
ENGLISH
Connect the power and Ethernet cables, or just the
Ethernet cable if you are using a PoE connection.
Reattach the camera cover.
To adjust the camera's angle, pull the black inner cover
and remove it from the camera.
Loosen the adjustment screw on the side of the camera,
then retighten it after moving the camera to the desired
angle.You can also rotate the camera by grasping the
camera and turning it left or right.
When you are done adjusting the camera's angle, put the
inner cover back into place.
Note: The camera has a limited range of motion; if it stops
when you are adjusting it, do not attempt to rotate or tilt
the camera any further in that direction.
D-Link DCS-4602EV Quick Installation Guide 7
ENGLISH
Using the DCS-37-1 Mount (optional)
Use the provided screws to mount the DCS-37-1 to the
wall.
Place the DCS-37-1 mounting sticker in the desired
location, then use a 6 mm drill bit to drill the required holes
25 mm deep and insert the wall anchors into the holes.
If you plan to pass cables through the wall, you will also
need to drill a hole for the cable channel.
Remove the cover from the camera.
Pass the camera connectors through the back or bottom
cable channel on the DCS-37-1. Use the provided screws
to mount the camera to the DCS-37-1 using the set of
mounting holes marked A.
Remove the inner cover and adjust the angle and rotation
of the camera as desired, then put the inner cover back in
place.
Attach the camera cover.
If you are passing the camera cables through the wall,
place the rubber stopper into the bottom cable channel to
seal it.
D-Link DCS-4602EV Quick Installation Guide
8
ENGLISH
Using the DCS-37-2 Mount (optional)
Use the provided screws to mount the DCS-37-2 to the
wall using the inner mounting holes.
Place the DCS-37-2 mounting sticker in the desired
location, then use a 6 mm drill bit to drill the required holes
25 mm deep and insert the wall anchors into the holes.
If you plan to pass cables through the wall, you will also
need to drill a hole for the cable channel.
Remove the cover from the camera.
Pass the camera connectors through the back or side
cable channel on the DCS-37-2. Use the provided screws
to mount the camera to the DCS-37-2 using the set of
mounting holes marked A.
Remove the inner cover and adjust the angle and rotation
of the camera as desired, then put the inner cover back in
place.
Attach the camera cover.
If you are passing the camera cables through the wall,
place the rubber stopper into the bottom cable channel to
seal it.
Altri manuali per DCS-4602EV
4
Indice
Lingue:
Altri manuali D-Link Telecamera di sicurezza
D-Link
D-Link SECURICAM DCS-6110 Manuale utente
D-Link
D-Link DCS-935L Manuale utente
D-Link
D-Link DCS-5222L Manuale utente
D-Link
D-Link DCS-H100 Manuale utente
D-Link
D-Link DCS-2530L Manuale
D-Link
D-Link DCS-6111 Manuale utente
D-Link
D-Link DCS-6112V Manuale utente
D-Link
D-Link DCS-7413 Manuale utente
D-Link
D-Link SECURICAM NETWORK DCS-5300 Manuale utente
D-Link
D-Link SECURICAM DCS-6110 Manuale utente
D-Link
D-Link DCS-2310L Manuale utente
D-Link
D-Link DCS-930L Manuale utente
D-Link
D-Link DSB-C320 Manuale utente
D-Link
D-Link DCS-6314 Manuale utente
D-Link
D-Link DCS-4701E Manuale utente
D-Link
D-Link DCS-6314 Manuale utente
D-Link
D-Link DCS-3420 Manuale utente
D-Link
D-Link DCS-5222L Manuale utente
D-Link
D-Link DCS-5230L Manuale utente
D-Link
D-Link DCS-5020L Manuale utente
