Danfoss ECtemp 330 Manuale utente
Danfoss A/S is not liable or bound by warranty if these
instructions are not adhered to during installation or service.
The English language is used for the original instructions.
Other languages are a translation of the original instructions.
© 2013 Copyright Danfoss A/S
Table of Contents
1 Introduction ............... 3
1.1 Technical Specifications ..... 4
1.2 Safety Instructions ........ 5
2Mounting Instructions ......... 6
3Warranty ................. 7
4Disposal Instruction .......... 7
1Introduction
ECtemp 330 is an electronic thermostat to be installed in
electric cabinets with DIN rail attachment. Used primarily
for controlling a lower temperature range as by frost pro-
tection. The thermostat must be installed via an all-pole
disconnection switch. Either a wire sensor or an external air
sensor must be used to measure and control the desired
temperature.
The thermostat has a button to adjust the temperature set-
ting, with a scale from -10° to +10°C. An LED indicator
shows standby periods (green light) and heating periods
(red light).
More information on this product can also be found at:
ectemp.danfoss.com
ECtemp 330 (-10 to +10°C)
Installation Guide 3
1.1 Technical Specifications
Operation voltage 220-240V~, 50Hz
Standby power consumption Max 0.25W
Relay:
Resistive load
Inductive load Max 16A / 3680W @ 230V
cos φ= 0.3 max1A
Sensing units NTC 15kOhm at 25°C
Sensing values:
0°C
25°C
50°C
42kOhm
15kOhm
6kOhm
Hysteresis ± 0.2°C
Ambient temperature 10°C to +50°C
Lowering in economy periods -5°C
Temperature range -10°C to +10°C
Cable specification max 1x4mm2or 2x2,5mm2
Ball pressure temperature 75°C
Pollution degree 2 (domestic use)
Type 1C
Storage temperature -20°C to +65°C
IP class 20
ECtemp 330 (-10 to +10°C)
4 Installation Guide
Protection class Class II -
Dimensions 86 x 36 x 58mm
Weight 83g
The product complies with the EN/IEC Standard "Automatic
electrical controls for household and similar use":
▪EN/IEC 60730-1 (general)
▪EN/IEC 60730-2-9 (thermostat)
1.2 Safety Instructions
Make sure the mains supply to the thermostat is turned off
before installation.
Please also note the following:
▪The installation of the thermostat must be done by an
authorized and qualified installer according to local
regulations.
▪The thermostat must be connected to a power supply
via an all-pole disconnection switch.
▪The sensor is to be considered as live voltage. Have
this in mind if the sensor must be extended.
▪Always connect the thermostat to continuous power
supply.
▪Do not expose the thermostat to moisture, water, dust,
and excessive heat.
ECtemp 330 (-10 to +10°C)
Installation Guide 5
2 Mounting Instructions
Please observe the following placement guidelines:
▪Install the thermostat in an electric cabinet with DIN
rail attachment or a separate DIN attachment accord-
ing to local regulation on IP classes.
▪Do not place the thermostat in a way that it will be ex-
posed to direct sunlight.
Follow the steps below to mount the thermostat:
1. Click the thermostat on to the DIN rail attachment.
2. Connect the thermostat according to the connection
diagram.
IP20
10T50 D330
-10°C to
+10°C
8765
N
4321 L
Mains
220-240V~
250V~
16 (1) A
Sensor
ECtemp 330 (-10 to +10°C)
6 Installation Guide
The screen of the heating cable must be connected to
the earth conductor of the power supply cable by us-
ing a separate connector.
Note: It is recommended that you install the sensor in
a conduit.
3. Turn on the power supply.
3 Warranty
2
Y E A R
4 Disposal Instruction
ECtemp 330 (-10 to +10°C)
Installation Guide 7
ECtemp 330 (-10 to +10°C)
8 Installation Guide
ECtemp 330 (-10 to +10°C)
Installation Guide 9
ECtemp 330 (-10 to +10°C)
10 Installation Guide
Altri manuali per ECtemp 330
3
Indice
Altri manuali Danfoss Termostato
Danfoss
Danfoss 102E7 Istruzioni di montaggio
Danfoss
Danfoss FP715Si Manuale utente
Danfoss
Danfoss FH-CWP Manuale utente
Danfoss
Danfoss ECL Comfort 310 Manuale utente
Danfoss
Danfoss ECtemp 610 Manuale utente
Danfoss
Danfoss RT52 Manuale utente
Danfoss
Danfoss CFZ Manuale utente
Danfoss
Danfoss RMT-230 Manuale utente
Danfoss
Danfoss DEVI DEVIreg Opti Manuale utente
Danfoss
Danfoss Icon Master Controller 24 V Manuale utente
Danfoss
Danfoss 103E5 Manuale utente
Danfoss
Danfoss TP75-RF Manuale utente
Danfoss
Danfoss Icon Master Manuale utente
Danfoss
Danfoss 088L5130 Manuale utente
Danfoss
Danfoss BasicPlus2 WT-DM Manuale utente
Danfoss
Danfoss HC6110-3 Manuale utente
Danfoss
Danfoss ORT-01 Manuale utente
Danfoss
Danfoss living connect Manuale utente
Danfoss
Danfoss HCS6101-3 Istruzioni utente
Danfoss
Danfoss RAS-D2 Combi Manuale utente
