6
950066-00 15/07/22
cables, if it has received dents, if it has been
dropped or if it has been damaged.
Do not use the appliance if during use,
charge or conservation the battery smells,
heats up, or deforms or has acid leaks.
Do not disassemble the appliance but take
Clean the appliance with a dry cloth. Do not
use solvents or other detergent aggressive
substances.
Store the appliance at ambient temperature
and away from heat sources.
Description of the starter
This appliance is a portable multifunction
starter equipped with a lithium battery.
It can be used as an emergency starter for
motor vehicles with 12-volt electrical system;
devices.
It is equipped with a LED light with the
function of continuous, intermittent, SOS
light.
Controls, reports and accessories Fig.1
B) Cable with clamps for jump starting
E) Cigarette lighter 12/24V power supply
1) Terminals for start clamps 12V
2,1A,
1A
6) LED charge status
7) LED light
Jump starting
Use the appliance only as an
emergency starter to support the
vehicle battery. Do not use it alone
instead of the battery.
avoid sparks, make sure that the clamps
cannot disengage from the poles of the
battery during charging.
Stay away from moving parts such as fans,
transmission belts and pulleys.
Stay away from hot parts, such as engine
and cooling system to avoid burns.
Do not short circuit the terminals for the
emergency start cable because they are
always under tension.
Avoids that the red and black clamps come
into contact. Accidental short circuits of the
terminals caused by an electrical conductor
object for example a tool, a jewel, etc. could
generate enough heat to cause serious
burns, electric arc or cause incandescent
metal splashes.
Do not reverse the polarity of the positive
“+” negative and “-” terminals
Sequence of operations
Starter battery must be fully charged
(4 led lit).
Carefully follow the starting
procedure, failure to comply may
2 Insert the cable with the clamps (B) into
the socket (1).
3 Connect red charging clamp to positive
(+) battery terminal and black charging
clamp (-) to negative battery terminal.
If the battery is installed on a motor
battery terminal that is not connected to
the bodywork. Afterwards, connect the
second clamp to the bodywork at a point
far from both the battery and the petrol
pipes.
4 Rotate the ignition key for up to 3 seconds.
If the vehicle did not start wait at
least 30 seconds before trying again.
If the vehicle did not start even the
second time wait at least 2 minutes.
¾After starting leave the engine running and
disconnect the starter:
¾Disconnect in the order the black clamp “-”
and then the red clamp “+”.
¾Disconnect the cable with the clamps from
the starter and put everything into its box.
