3
2. Aer a few seconds, release the buon and
the randomized address will be saved. The LED
will begin flashing to indicate that the Control
Permissions may now be set.
3. Press each of the five buons on the transmier.
It does not maer in what order the buons are
pressed, only that each buon is pressed at least
one me. If a buon is not pressed during this
learning phase, that buon will not transmit during
use.
4. Press the CREATE buon again with the paperclip
or wait seventeen (17) seconds for it to me out.
The address and Control Permissions are now set.
Once the address and Control Permissions are set, the
transmier is now programmed and you are ready to
customize the receiver in the dock.
Special note:
Some users have found it beneficial to deliberately omit
certain buons (step 3 above) from the programming
sequence. For example, let’s say you had an assistant in
the audience who was there to adjust the volume level and
you did not want them to have control over other aspects
of your music. Selecng the volume up and down buons
during the programming sequence would give them
volume control but they could not start, stop or fade-out
the music.
