DELTA DORE TYXIA 1701 Manuale utente

EN 1-channel remote control for roller shutter

TYXIA 1701

Technical characteristics

• Power supplied by 3V lithium battery, CR2430

• Class III insulation

• X3D Transmission frequency:

868.7 MHz to 869.2 MHz

• Maximum radio power < 10 mW

• Receiver category II

• Wireless range: 100 to 300 metres outside,

variable depending on the associated equipment

(the range can vary depending on the installation

conditions and the electromagnetic environment)

• Wall-mounted

• Dimensions: 46 x 121 x 10.7 mm

• Degree of protection: IP 40

• Operating temperature: 0 to +55°C

• Storage temperature: -10 to +70°C

• Installation in an environment with normal

pollution levels

Contents

1/ Location/Mounting ............................................. 4

1.1 Mounted on the wall ......................................4

1.2 Placed on a at surface .................................5

2/ Wireless association........................................... 6

2.1 Pairing of a motor in

individual control mode ........................................6

2.2 Pairing of a Tyxia receiver for a roller

shutter motor (e.g. Tyxia 5630 or 5730)..........8

2.3 Pairing of several motors

or receivers in group control................................ 9

3/ Save the favourite positions...........................10

4/ Use ..........................................................................11

5/ Troubleshooting .................................................13

1.2 Placed on a flat surface

1/ Location/Mounting

1.1 Mounted on the wall

WARNING !

Do not ingest battery, chemical Burn Hazard.

This product contains a coin/button cell battery.

If the coin/button cell battery is swallowed, it can cause severe

internal burns in just 2 hours and can lead to death.

Keep new and used batteries away from children.

If the battery compartment does not close securely, stop using the

product and keep it away from children.

If you think batteries might have been swallowed or placed inside

any part of the body, seek immediate medical attention.

2/ Wireless association

If you own a solar motor, refer to its instructions.

2.1 Pairing of a motor in

individual control mode

When connecting to the power supply, a motor that

has never been wirelessly paired before will always

perform a brief movement. It is set to pending

pairing for 10 minutes.

2.1.1 If only a single motor is turned on

❶On the remote control, press

and

at the

same time and hold for 3 seconds, until the LED

ashes. Release the buttons.

When the motor is detected, the LED briey lights up

green.

❷ After a few seconds, the shutter activates

twice to conrm pairing, and the remote control

automatically exits pairing mode.

❸Then proceed with the setting of the stops (see

motor instructions).

2.1.2 If several motors are switched on

❶On the remote control, press

and

at the

same time and hold for 3 seconds, until the red

LED ashes. Release the buttons.

The remote control searches for the various motors.

The LED ashes red, then briey green as soon as a

new motor is found.

❷ When the LED starts ashing red slowly, press

the

button as many times as required to

select the motor to be paired.

The corresponding shutter activates briey.

❸Once themotor has been found, press

❹After a few seconds, the shutter activates twice

to conrm pairing.

❺To exit pairing mode, press

for 3 seconds.

❻Then proceed with the setting of the stops (see

motor instructions).

2/ Wireless association

2.3 Pairing of several motors

or receivers in group control

Important: if you pair several motors with the

remote control, you will no longer have access to

the stop settings from this remote control.

❶Set the motors to pending pairing (press the

button on their individual control for 3 seconds,

or via the Tydom app).

and/or

Set the receivers to pairing mode (press their

button for 3 seconds, or via the Tydom app).

❷On the remote control, press

and

at the

same time and hold for 3 seconds, until the LED

ashes. Release the buttons.

The remote control searches for the various motors

or receivers.

The LED ashes red, then briey green as soon as a

new receiver is found.

❸ Once the LED on the remote controle slowly

ashes red, press the

and

buttons at

the same time for 3 seconds, until the shutters

activate briey, then release the buttons.

2.2 Pairing of a Tyxia receiver for a roller shutter

motor (e.g. Tyxia 5630 or 5730)

❶Switch on and set the receiver to pairing mode

by pressing its button for 3 seconds until its LED

ashes red, then release.

❷On the remote control, press

and

at the

same time and hold for 3 seconds until the red

LED ashes, then release the buttons.

When the receiver is detected, the LED briey lights

up green and the receiver stops ashing.

The shutter activates briey to conrm the pairing.

The remote control automatically exits pairing mode.

1110

3/ Save the favourite positions

You can save up to 2 favourite positions from the

remote control:

and

❶❷ Set the shutter to the required position

(

❸Press

for 3 seconds to

save the positions.

The LED changes from red to green if the receiver

has correctly received the information. The shutter is

activated briey to conrm the association.

Release.

> 3s

4/ Use

• Press

to raise, and

to lower.

Press

to stop the shutters.

The LED changes from red to green if the receiver has

correctly received the information.

• Press

to go to favourite position 1 (if it has

been saved).

• Press

to go to favourite position 2 (if it has

been saved).

Control in silence mode (Tymoov RP2 motors):

In order to reduce the noise level, you can control

the motor in slow mode by performing a long press

on or (2 seconds).

1312

5/ Troubleshooting

• The red LED ashes several times

every time a button is pressed.

The battery is low. Change the battery.

• Remove an association

- Remove the front face of the remote control.

- Press button A. The red LED ashes.

- Press

as many times as required

to select the motor (receiver) to

remove.

- Press the

button. The shutter starts.

- Press button A to exit.

• Remove all associations

To release the remote control from all association.

- Remove the front face of the remote control.

- Press button A. The red LED ashes.

- Press the

and

buttons at the same time and

hold for 3 seconds. The shutters start.

- Press button A to exit.

• Your remote control is lost or not functioning

Initial condition: The lost remote control was only

associated with a single motor

Turn off the power to the motor, wait 10 seconds, then

turn the motor back on.

From a new remote control:

- Press the B button 2 times, until the LED ashes

orange.

- Press

and

for 3 seconds until the ashing stops.

The motor (receiver) has not been associated before

- Restart the association process for your new remote

control.

• The green LED does not ash after briey pressing

button B.

- Several motors are associated with the remote

control. Therefore, you cannot access the setting

modes in this case.

The remote control must only be associated with one

motor for the settings.

www.deltadore.com

Indice

Altri manuali DELTA DORE Telecomando

DELTA DORE

DELTA DORE TYDOM 140 Manuale utente

DELTA DORE

DELTA DORE TYXIA 1716 Manuale utente

DELTA DORE

DELTA DORE PACK TYXIA 541 Manuale utente

DELTA DORE

DELTA DORE TL 2000 Tyxal+ Manuale utente

DELTA DORE

DELTA DORE TYXIA 1703 Manuale utente

DELTA DORE

DELTA DORE TYXIA 1600 Manuale utente

DELTA DORE

DELTA DORE TYPHONE 3 SV Manuale utente

DELTA DORE

DELTA DORE TYXIA 1705 Manuale utente

DELTA DORE

DELTA DORE TYXIA 1703 Manuale utente

DELTA DORE

DELTA DORE TL 2000 TYXAL+ Manuale utente

DELTA DORE

DELTA DORE TL 2000 TYXAL+ Manuale utente

DELTA DORE

DELTA DORE TYPHONE 3 SV Manuale utente

DELTA DORE

DELTA DORE TYXIA 631 Manuale utente

DELTA DORE

DELTA DORE TYXIA 641 Manuale utente

DELTA DORE

DELTA DORE DRIVER 610 Manuale utente

DELTA DORE

DELTA DORE TL 2000 TYXAL+ Manuale utente

DELTA DORE

DELTA DORE TYXIA 630 Manuale utente

Manuali Telecomando popolari di altre marche

Panasonic

Panasonic EUR7622KB0 Manuale utente

Bang & Olufsen

Bang & Olufsen Beo4 Manuale utente

Sunwave Tech.

Sunwave Tech. RemoteComm SRC-7000 Manuale utente

Multiplex

Multiplex PROFI TX 9 Manuale utente

One Remote

One Remote RMB4 Manuale utente

FUTABA

FUTABA 9ZAP - PART2 Manuale utente

HR Matic

HR Matic HR MULTI 3 Manuale utente

Yamaha

Yamaha ACC-GNRST-30-20 Manuale utente

EisSound

EisSound KBSOUND Manuale utente

Marantz

Marantz RC101 Manuale utente

Conrad

Conrad FS20 TC6 Manuale utente

Anritsu

Anritsu MP1777A Manuale utente

Niles

Niles WVC100 Guida alla risoluzione dei problemi

RCA

RCA RCU1300 Manuale utente

Bang & Olufsen

Bang & Olufsen BEO6 Manuale utente

GE 94901 Manuale utente

Onbon

Onbon YQ1-75 Manuale utente

FUTABA

FUTABA R7108SB Istruzioni per l'installazione