Denali B6 Manuale utente

Instruction Rev00

0mm 10 20 30 40 50 60 70 80 90

Thank you for choosing DENALI

We know you would rather be riding your bike than wrenching on it, so we go the extra

mile to make sure our instructions are clear and as easy to understand as possible. If

you have any questions, comments, or suggestions don’t hesitate to give our gear

experts a call at 401.360.2550 or visit WWW.DENALIELECTRONICS.COM

Please Read Before Installing

DENALI products should always be installed by a qualified motorcycle technician. If

you are unsure of your ability to properly install a product, please have the product

installed by your local motorcycle dealer. DENALI takes no responsibility for damages

caused by improper installation. Caution: When installing electronics is it extremely

important to pay close attention to how wires are routed, especially when mounting

products to the front fender, front forks, or fairing of your motorcycle. Always be sure

to turn the handlebars fully left, fully right, and fully compress the suspension to

ensure the wires will not bind and have enough slack for your motorcycle to operate

properly.

Installation Tips

We strongly recommend using medium strength liquid thread locker on all screws,

nuts, and bolts. It is also important to ensure that all hardware is tightened to the

proper torque specifications as listed in your owner’s manual. For included accessory

hardware please refer to the default torque specifications provided below. Inspect all

hardware after the first 30 miles to ensure proper torque specifications are

maintained.

Hardware Sizing Guide

Not sure what size bolt you have? Use this ruler to measure screws, bolts, spacers, etc.

Remember, the length of a screw or bolt is measured from the start of the “mounting

surface” to the end of the screw, so only include the screw head when measuring

countersunk screws.

M3 10.0 in-lbs - 1.0 Nm

M4 23.0 in-lbs - 2.5 Nm

M5 44.5 in-lbs 3.5 ft-lbs 5.0 Nm

M6 78.0 in-lbs 6.5 ft-lbs 9.0 Nm

M8 - 13.5 ft-lbs 18.0 Nm

M10 - 30.0 ft-lbs 41.0 Nm

M12 - 52.0 ft-lbs 71.0 Nm

in-lbs

ft-lbs NmBolt Size

0in 1 2 3

Whats In The Box?

Kit Contents

(a) B6 LED Brake Light Pod........................................................Qty 1

(b) Wiring Pigtail......................................................................Qty 1

Tools Required

Voltmeter/Multimeter

DENALIELECTRONICS.COM

B6 LED Brake Light

DNL.B6.003

Instruction Manual

(a)

(b)

1. Wiring The B6 Brake Light DENALIELECTRONICS.COM

Posi-Tap

1.1 - Identifying Vehicle Brake Wires

Note: If you are using the B6 Brake Light in conjunction with the DENALI

CANsmart Controller, please refer to the instruction manual of the

CANsmart Controller for brake light wiring.

Step One: Route the cable from the B6 Brake Light (a) into the rear of

the motorcycle to the area the factory brake light is located.

Step Two: Identify the wires coming from the factory tail light. There

will typically be only three wires exiting the factory brake light housing.

You will need to identify the Running Light Wire, Brake Light Wire as

1.2 - Wiring The Pigtail

well as the Ground Wire. Use a voltmeter or multimeter to assist in

identifying the correct wires.

Step Three: Use Posi-Tap connectors to wire the Pigtail (b) to the wires

identified in Step Two.

-Tap the Red Wire to Vehicle Running Light Wire

-Tap the Orange Wire to Vehicle Brake Light Wire

-Tap the Black Wire to Vehicle Ground Wire

Step Four: Plug the Pigtail (b) into the connector on the B6 Brake Light.

B6 LED Light Pod

Wiring Pigtail

Tap Black Wire to Vehicle Ground Wire - 12v Negative (-)

Tap Red Wire to Vehicle Running Light Wire - 12v Positive (+)

Tap Orange Wire to Vehicle Brake Light Wire - 12v Positive (+)

Altri manuali Denali Accessori per motociclette

Denali

Denali CANsmart Controller GEN II Manuale utente

Denali

Denali LAH.07.11300 Manuale utente

Denali

Denali DialDim DNL.WHS.22800 Manuale utente

Denali

Denali MA11729 Manuale utente

Denali

Denali LAH.04.10700 Manuale utente

Denali

Denali MBK.22.10000 Manuale utente

Denali

Denali DialDim Manuale utente

Denali

Denali LAH.11.10700 Manuale utente

Denali

Denali HMT.22.10100 Manuale utente

Denali

Denali ALG.003 Manuale utente

Denali

Denali HMT.04.10200 Manuale utente

Denali

Denali LAH.07.11000 Manuale utente

Denali

Denali DialDim DNL.WHS.23900 Manuale utente

Denali

Denali LAH.23.10000 Manuale utente

Denali

Denali LAH.08.10900 Manuale utente

Denali

Denali DNL.WHS.24200 Manuale utente

Denali

Denali HMT.07.11000 Manuale utente

Denali

Denali DNL.WHS.084 Manuale utente

Denali

Denali DNL.WHS.12700 Manuale utente

Denali

Denali SoundBomb TT-SB.10100.B Manuale utente

Denali

Denali HMT.07.11001 Manuale utente

Denali

Denali LAH.00.11600 Manuale utente

Denali

Denali KLR650 Manuale utente

Denali

Denali LAH.23.10100 Manuale utente

Manuali Accessori per motociclette popolari di altre marche

SRC

SRC B-TRK502-01-01-SL Manuale utente

3M Speedglas 9100 MP Manuale utente

hepco & becker

hepco & becker 6307520 00 01 Manuale utente

HOMCOM

HOMCOM AA0-077 Manuale utente

hepco & becker

hepco & becker 6307558 00 01 Manuale utente

Wunderkind Custom

Wunderkind Custom 106503-F15 Guida utente

Dräger

Dräger HPS 3500 Manuale utente

M-WAVE

M-WAVE SKI Manuale utente

Kuryakyn

Kuryakyn 6212 Manuale utente

hepco & becker

hepco & becker 6507504 00 01 Manuale utente

Tool it

Tool it PROMAX LCD 9.13G Manuale utente

Custom Dynamics

Custom Dynamics TruWrapz Manuale utente

Roof

Roof RO200 CARBON Manuale utente

Kabuto

Kabuto Japan IBUKI Manuale utente

PUIG

PUIG 5051 Manuale utente

rizoma

rizoma ZTH050 Manuale utente

Joubert

Joubert 10001711 Manuale utente

Sperian

Sperian Optrel p420 Manuale utente