aXcs
®
Operatory Light
(Post Mount)
7
Section II Installation
6. Plug the light receptacle connector into the
light receptacle cord.
7. Plug the light receptacle connector into the
transformer power cord. (See photo below.)
Light Arm Assembly
1.Reconnect the chair power.
2. Place the chair in its lowest position.
3.Disconnect the chair power.
4. Apply a light coat of lubricant to the spindle.
5. Slide the bushing (lipped end first) over the
light cord and onto the spindle.
6. Feed the light cord through the center of the
light pole, pulling the cord out from the
bottom of the hub until the cord is not too
tight or loose.
7. Plug the light cord connector into the trans-
former box. Then neatly tuck the light cord
between the adaptor arm and transformer box.
Light Receptacle Cord
Light Cord
Connector
Light Cord
Light Receptacle
Connector
Transformer
Power Cord
8. Fold the excess light cord in half. Then affix a
cable tie around the folded end and run the
excess cord back up through the post.
9. Tighten the set screw in the light post to
secure the light arm assembly.
10.Reconnect the chair power and test the light
switch as described in Section III Operation.
NOTE: Replace the seat upholstery if it was removed.
Post Mount for Magellan
NOTE: Refer to the Magellan Unit manual for
installation of the light pole.
NOTE: If the chair's seat upholstery was
installed, remove it according to the respective chair's
manual.
Light Arm Assembly
1. Follow Steps 2through 5for the light arm
assembly on the left side of this page.
2. Feed the light cord through the center of the
light pole, pulling the cord out of the bottom
of the pole.
Transformer Box
1. Remove the chair's bottom cantilever cover
and pump cover.
2. Route the light cord through the chair's pivot
collar and the cantilever arm portion, then
underneath the electronics board.
NOTE: If the plastic connector is not on the end of
the operatory light cord, attach it following the
instructions enclosed in the bag with the connector parts.
3. Route the light cord into the utility service
center.
4. Follow Steps 3 through 6 on Page 5 for
electrical connection of the transformer box.
5. Replace the chair's cantilever and pump cover.
6.Reconnect the chair power and test the light
switch as described in Section III Operation.
NOTE: Replace the seat upholstery if it was removed.
