Denver Electronics SCO-65110 Manuale utente
User manual
SCO-65110
facebook.com/denverelectronics
Before operating this vehicle, read all the instructions for safe assembl and operations. User’s manual can guide ou through the
functions and usage of Electric scooter. Before using this Electric scooter, familiarize ourself with how to operate, so that ou can
keep the Electric scooter in the best condition possible.
This appliance can be used b children aged from 14 ears and above and persons with reduced ph sical, sensor or mental
capabilities or lack of experience and knowledge if the have been given supervision or instruction concerning use of the appliance in
a safe wa and understand the hazards involved.
Children shall not pla with the appliance.
Cleaning and user maintenance shall not be made b children without supervision.
Version 1.0
1
Table of Contents
2
1. Product and Accessories
IMPORTANT:
This Electric scooter must be charged and stored in a safe place.
For safet reason and batter performance, never charge the Electric scooter in the temperature below 5°C or above 45°C. Onl use
the charger included to charge the Electric scooter. Alwa s disconnect the charger after the Electric scooter is full charged.
3
2. Unfold/fold t e Electric scooter
Unfold the Electric scooter
1) Stand the Electric scooter on its wheels, and press the unlock clasp.
2) Pull up the handle in a gentle wa .
3) The Electric scooter is unfolded as soon as ou hear the rod click into place.
Fold the Electric scooter
1) Hold the clasp and pull it outward
2) Press the front tube of Electric scooter downward (Attention: the limit position must be put right.)
3) The rod clicks audibl into place.
4
4) Dual action safet knob
Press the red button to fold or unfold the Electric scooter.
Rotate the safet knob to the “FOLDING” position on the left or right, then press the red button to fold our Electric scooter. Rotate
the safet knob to the “RIDING” position, ou can start our driving.
The knob must be set to the “RIDING” position when riding for safet issue to prevent unintended folding the Electric scooter.
3. Handle bar assembly
1) Parts inside the packaging: two handlebars
2) Change displa angle: Loosen the screw on the handlebar, and rotate the axle to make the handlebar meter
screen upwards while the and displa screen turn inwards in a horizontal level. Remember to tighten screws again
3) Before operating the electric scooter, turn the handlebar grips, and carefull check all the components to make sure that the
steering is correctl installed as described above, and that all connecting parts are secure and full functional.
Figure 1 Figure 2
5
4. Connect t e c arger
Plug the supplied adapter into the charging port.
6
5. Intended Use
The Electric scooter is neither a means of transport nor sports equipment, but a device for personal entertainment. The Electric scooter for
domestic use onl and onl b a person aged at least 14 with a maximum weight of 100 kg. The other parameters for the permissible operation
of the Electric scooter are defined in the section (“10. List of parameters”) . Importantl , the Electric scooter ma onl be operated in good
visibilit conditions and onl if the ph sical conditions for stabilit on the Electric scooter are met (for example, not on one leg/not under the
influence of drugs or alcohol). When operating the Electric scooter, the operator must wear personal protective equipment specified in the
section (“13. Warnings” > 13.2 Preparation”).
6. Safety Instruction
We recommend alwa s wearing helmet and protective gear like elbow, knee and wrist protectors to ensure our personal safet .
Also make sure ou have read the user manual carefull , to ensure ou know how to ride it in a safe and fun wa .
The Electric scooter is for domestic use onl .
It is our responsibilit to be aware of and compl with all regulations in our countr . If there are no regulations for this Electric
scooter in our countr , please take care of our own safet and the safet of others.
Also pa attention to other people. Alwa s ride safel and onl at a speed that allows ou to brake safel at an time. A common
thing for such products is that there is a risk that ou ma fall off the product and injure ourself. Alwa s ride as safel as possible.
If lending the Electric scooter to friends and famil , please make sure the use proper protective gear and know how to ride it.
Before riding the Electric scooter, please check that all parts are working as supposed to. If an loose parts, abnormal noise, reduced
batter life etc. are detected, please contact our retailer for product service and warrant . Do not repair the Electric scooter ourself.
Inspect the rear tire, rear brake, and brake pad according to Section 7 of the maintenance specification in this operating instructions.
The Electric scooter ma become unstable if the rear brake is deformed or loose. This is because the distance between the brake pad
and the rear wheel becomes too small, possibl leading to a blocked rear wheel.
Avoid appl ing too much force or stepping on the rear fender permanentl . This ma cause the fender to loosen or damage the spring
holding the fender.
As a result, the brake pad constantl touches the wheel and the motor temperature increases due to the additional resistance. The rear
tire can also get loose if the brake is in constant braking position.
Avoid constant braking. As a result, the tires will not onl wear off, but also become hot. This will soften the rubber and it will no
longer have the same grip on the road as usual. Do not touch the tire after braking.
If ou hear unusual noises or notice friction when switching on the Electric scooter, a bearing ma be damaged. A worn bearing ma
even be indicated b strong vibration of the handlebar. In this case, please contact our retailer since the bearing needs to be replaced
and/or the handlebar checked and adjusted.
Ride the Electric scooter onl on a dr surface since otherwise the riding safet and braking performance ma be impaired and the
motor or bearings ma be damaged.
Please do not ride up or down long and steep slopes.
Stop riding when ou receive the "Low Batter Warning". The Electric scooter then moves onl slowl and does not have the same
traction as normal and the electric brake does not work. In this case, please use the rear brake to stop the Electric scooter. Get off the
scooter as soon as the speed allows to do that safel .
Do not use the electric brake and the throttle at the same time.
A normall working Electric scooter operates safel and quietl . If ou hear noises or notice bump operation, please check wheels,
bearings, and brakes. Contact our customer service for repair and maintenance, if necessar .
7
7. Maintenance
•Storage and cleaning
If our Electric scooter gets dirt , please clean it with a damp cloth. ( ou can use a stiff brush first to get the worst dirt off and then
use a cloth afterwards to clean it.). It is also possible to use a little toothpaste if the dirt is stuck. Remember to clean with damp cloth
after this.
Please make sure to keep the Electric scooter turned off while cleaning it, and make sure to cover the charging input to avoid
problems with the electronics.
Please notice: Do not use alcohol, gas, kerosene or other corrosive and volatile chemical solvents. This can damage both the
appearance and the internal structure of the Electric scooter. You ma not use pressured water-gun or running water either.
Please store our Electric scooter in a dr and cool environment when not in use. Avoid leaving it outdoors, as it is not made for use
in wet areas. Nor is it good to expose to high temperatures caused b direct sun for a long time.
•Maintenance of batteries
Please make sure the batteries do not get over 50° Celsius, or minus 10° Celsius for a longer period of time. (e.g. don’t leave the
Electric scooter in a hot car in summer, do not put batteries into fire et.) Low temperature (e.g. subzero temperature) can damage the
batter cells.
Keep the Electric scooter awa from open flame or other sources of heat to prevent the batter from getting too hot. Also make sure
not to leave the Electric scooter at freezing temperatures. Both heat and excessive cold can cause the batter to discharge.
Please avoid draining the batteries 100%. It is best to charge them while there is still power on them. This will extend batter life.
Also if riding the Electric scooter in cold or ver hot areas, the batter time can be lower than when riding in temperatures from 15-
25° Celsius. This is not a failure on the batteries, but normal behavior.
Do not overcharge and discharge the batter .
Make sure that the batter is charged at regular intervals, even if ou do not use the Electric scooter for a long time. This is to prevent
damage to the batter caused b low voltage over an extended period.
Please notice: Even full charged batteries will run out of power if the Electric scooter is not used for a period of time. Expect
between 90 and 120 da s in off mode if batteries are full charged. If onl partiall charged, this period of time is lower.
Please make sure to charge the batteries before the are 100% out of power, to avoid damaging the batter cells. (damaged batter
caused b wrong handling are not covered b warrant )
It is forbidden to disassemble batter package. This is onl to be handled b official service repair centers and professionals.
•Maintaining bearings
The Electric scooter has sealed and dustproof bearings so that no lubrication is required. Check the bearings for wear at regular
intervals to avoid unsafe riding. Do not jump on and off and do not appl excessive force otherwise to avoid damage to the bearings.
This is not a sports Electric scooter.
•Maintaining wheels
Check the wheels for wear at regular intervals to avoid unsafe riding.
•Maintaining the brake
The brake pad is made of metal. Check the brake pad for wear at regular intervals to avoid unsafe riding. Do not appl excessive
force to avoid damage to the brake.
•Maintaining screws and other fasteners
Make sure that all screws are properl tightened to avoid unsafe situations.
8
•Please make sure to check that the steering s stem is correctl adjusted and that all connection components are firml secured
and not broken before riding, refer to handlebar assembl and safet instruction.
•Please read operation guide and warnings of correct techniques for use and braking
•Alwa s wear shoes;
•When self-locking nuts and other self- locking fixings ma lose their effectiveness
•All parts and materials' qualit of electric scooter can not be changed, modifications are not allowed
9
8. Operational control
For better operation, please read the instructions carefull .
8.1 Button
There are three buttons in the displa , Power button, ▲ Speed up button and ▼ speed down button.
8.2 Control and display
10
Indice
Altri manuali Denver Electronics Scooter
Denver Electronics
Denver Electronics SCO-65220 Manuale utente
Denver Electronics
Denver Electronics SEL-65220F Manuale utente
Denver Electronics
Denver Electronics SCO-65100 Istruzioni operative
Denver Electronics
Denver Electronics DBO-6500 MK2 Istruzioni operative
Denver Electronics
Denver Electronics SEL-65220 MK2 Manuale utente
Denver Electronics
Denver Electronics SEL-65220 Manuale utente
Denver Electronics
Denver Electronics DBO-10050 MK2 Manuale utente
Denver Electronics
Denver Electronics DBO-6502 Istruzioni operative
Denver Electronics
Denver Electronics SEL-65115 Istruzioni operative
Denver Electronics
Denver Electronics DBO-8050 MK2 Manuale utente
