Digital Watchdog DWC-V4783WD Manuale utente

05/2015

ABOUT MANUAL

Before installing and using the camera, please read this manual carefully.

Be sure to keep it handy for future reference.

ANALOG HIGH DEFINITION

SnapIt Outdoor Dome Camera

DWC-V4783WD

DWC-V4783WTIR

PRECAUTIONS

Do not open or modify.

Do not open the case except during maintenence and installation,

for it may be dangerous and can cause damages.

Do not put objects into the unit.

Keep metal objects and flammable substances from entering the camera.

It can cause fire, short-circuits, or other damages.

Be careful when handling the unit.

To prevent damages, do not drop the camera or subject it to shock or vibration.

Do not install near electric or magnetic fields.

Protect from humidity and dust.

Protect from high temperature.

Be careful when installing near the ceiling of a kitchen or a boiler room,

as the temperature may rise to high levels.

Cleaning:

To remove dirt from the case, moisten a soft cloth with a soft detergent solution and wipe.

Mounting Surface:

The material of the mounting surface must be strong enough to support the camera.

FCC COMPLIANCE

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection

against harmful interference, when the equipment is operated in a residential environment. This

equipment generates, uses, and radiates radio frequency energy; and if it is not installed and used in

accordance with the instruction manual, it may cause harmful interference to radio communications.

WARNING: Changes or modifications are not expressly approved by the manufacturer.

Table of Contents

TABLE OF CONTENTS

Introduction

Installation

Module OSD Menu

Troubleshooting

Warranty Information

Specifications

Features

Parts and Descriptions

Dimensions

Inside the Box

Ceiling Mount Installation Instructions

Corner Mount Installation Instructions 11

Installation Instructions

Connecting to Monitors 13

Wall Mount Installation Instructions

Control Board

8-9

16-29

31-32

33-34

Adjusting the Camera Angle

FEATURES*

Analog High Definition (AHD) HD over Coax Technology

STAR-LIGHT™ Super Low Light Technology

Panasonic 1/3" CMOS Sensor

1080P Resolution at 30fps

Wide Dynamic Range (WDR)

Varifocal Auto-Focus P-Iris Lens 2.8~12mm

CleanView™ Hydrophobic Dome Coating Repels Water, Dust and Grease

Smart IR™ with Intelligent Camera Sync. 70ft Range [DWC-V4783WTIR Models]

Smart DNR™ 3D Digital Noise Reduction

Highlight Masking Exposure (HME)

True Day/Night Mechanical IR Cut Filter [DWC-V4783WTIR Models]

Auto Sensing 24VAC/12VDC with Line Lock

Secondary Video-BNC Output (While UTP in use)

Easy Icon Driven OSD Menu with Built-in Joystick

Programmable Privacy Zones

Auto Gain Control (AGC)

Back Light Compensation (BLC)

Dynamic Range Compressor (DRC) Reveals Low Light Detail

Auto White Balance (AWB)

Junction Box Built-in

RS-485 Built-in

IP68 Certified (Water Resistant)

Set Screw

PARTS & DESCRIPTION*

Mounting Hole

Surface Mount Base

Cables: BNC, UTP, RS485

Joystick for OSD Menu

Test MotitorCable Slot

Flush Mount Base

Lens

Control Board

Tilt Stopper Screw

Bubble Dome

Upper Case

Set Screw

DIMENSIONS IN MILLIMETERS (IN)*

Flush Mount Top View

Surface Mount

137(5.39”)

101(3.97”)

17(0.66”)

28(1.10”)

54(2.12”)

98.8(3.88”)

139(5.47”)

118.8(4.67”)

36(1.41”)

29(1.14”)

53.8(2.11”)

121(4.76”)

INSIDE THE BOX*

Included with your camera:

Camera

Template Sheet

Cables

Screw &

Plastic Anchor-2pcs

Test Monitor Calbe

User’s Manual

DC Plug Cable

Hexagonal Wrench

(for tighten Set Screw)

Torx Screw Driver

INSTALLATION*

1. Use the included T-wrench to remove the

camera’s dome from the camerta module.

2. To detach the cameremodule from the junction

box, use a phillips head screw driver to loosen the

three screws on the module case. The camera’s

module will be secured to the junction box with the

security cable.

3. Use the mounting template or your camera’s

junction box and drill the necessary mounting

holes to the mounting surface.

3. Pull Wires through and make connections.

4. Mount the camera to the mounting surface using

the included screws.

DC 12V

AC 24V

UTP

RS485

If you need to keep the wiring within the

camera housing, refer to the diagram above.

INSTALLATION*

5. Adjust the camera’s lens position by using the 3-Axis gimbal.

6. Snap the camera dome over the camera module to complete the installation.

Flush Mount Installation

For a flush mount housing, remove the surface mount

base (junction box). Cut a large hole on the mounting

surface for the top part of the flush mount base.

Use the three screws fixed to the base to secure it to

the mounting surface. Follow steps 4 through 6 to

complete the installation.

ST4X35

INSTALLATION - WALL MOUNT*

1. Verify all parts are in the box.

2. Insert the wires from the

camera through the wall

mount housing.

3. Use the mounting template to

make pilot holes. Use the dry

wall anchors and woods screws

to attach the assembly.

4. Attach the camera’s surface

mount base (junction box) to

the wall mount.

5. Connect all cables and snap

the camera module onto the

base.

6. Adjust the camera and

secure the dome cover over

the camera module.

Questo manuale è adatto per i seguenti modelli

Indice

Altri manuali Digital Watchdog Telecamera di sicurezza

Digital Watchdog

Digital Watchdog V1362DIR Manuale utente

Digital Watchdog

Digital Watchdog MEGApix DWC-MPF5Wi4TW Manuale utente

Digital Watchdog

Digital Watchdog DWC-D6351D Manuale utente

Digital Watchdog

Digital Watchdog Star-Light DWC-B6763TIR Manuale utente

Digital Watchdog

Digital Watchdog MEGApix DWC-MB82i4V Manuale utente

Digital Watchdog

Digital Watchdog STAR-LIGHT 960H DWC-V6553D Manuale utente

Digital Watchdog

Digital Watchdog MEGApix DWC-MD72Di28T Manuale utente

Digital Watchdog

Digital Watchdog STAR-LIGHT PLUS DWC-B6853WTIRW Manuale utente

Digital Watchdog

Digital Watchdog MEGApix IVA DWC-MB84Wi4T Manuale utente

Digital Watchdog

Digital Watchdog MEGApix Pano DWC-MBW8Wi2TW Manuale utente

Digital Watchdog

Digital Watchdog PTZ37X Manuale utente

Digital Watchdog

Digital Watchdog MEGAPIX DWC-MV45WiATW Manuale utente

Digital Watchdog

Digital Watchdog Snapit DWC-D4363D Manuale utente

Digital Watchdog

Digital Watchdog D4252 Series Manuale utente

Digital Watchdog

Digital Watchdog DWC-V6763WTIR Manuale utente

Digital Watchdog

Digital Watchdog MEGApix DWC-MB45WiAT Manuale utente

Digital Watchdog

Digital Watchdog DWC-V1362DIR Manuale utente

Digital Watchdog

Digital Watchdog STAR-LIGHT Universal HD over Coax... Manuale utente

Digital Watchdog

Digital Watchdog MEGApix DWC-MD72i4V Manuale utente

Digital Watchdog

Digital Watchdog Star-Light DWC-B6263TIR Manuale utente

Digital Watchdog

Digital Watchdog DWC-V7553W Manuale utente

Digital Watchdog

Digital Watchdog DWC-D1363D922 Guida

Digital Watchdog

Digital Watchdog MEGApix PanO DWC-PPVF9Di2TW Manuale utente

Digital Watchdog

Digital Watchdog D1362D Series Manuale utente

Manuali Telecamera di sicurezza popolari di altre marche

Okina USA

Okina USA SIR36-870VF650LP Manuale utente

Divio

Divio NDR155PA Manuale utente

Canon

Canon VB-C500D Manuale utente

Easy Access

Easy Access EasyGuard Manuale utente

Vivotek

Vivotek FD9389-EHV-v2 Manuale utente

TUYA

TUYA COSMO W2 Manuale utente

Eusso

Eusso UNC7500-IR Guida all'installazione

urmet domus

urmet domus 1096/204 Manuale utente

VC VC20 series Manuale utente

Axis

Axis Q1614 Manuale utente

ieGeek

ieGeek DD201 Manuale utente

VADDIO

VADDIO ClearVIEW HD-USB PTZ 999-6990-000 Manuale utente

Vicon

Vicon V662-D-1 Istruzioni operative

Grundig

Grundig GCH-K0274P Manuale utente

Lorex

Lorex VANTAGE LBC7032 Manuale utente

4xem

4xem WPT Manuale utente

Samsung

Samsung SCV-3082 Manuale utente

Vitek

Vitek VTC-C544 Manuale utente