Dixon 312 Manuale di istruzioni

TECHNICAL DATA

ZTR Model 312

IMPORTANT -READ OPERATOR'S MANUAL BEFORE OPERATING OR MAKING ADJUSTMENTS

SEAT ADJUSTMENT

1. Pull or lift body retention latch P/N 3934

from transaxle backing plate,raise

and push body and seat assembly

forward.

2. Loosen four seat adjustment knobs P/

N 1849 and slide seat forward or

backward to desired position.

3. Re-tighten seat adjustment knobs P/N

1849. DO NOT operate mower without

seat adjustment knobs properly

tightened.

4. Close upper body and push retention

latch. P/N 3934 over transaxle backing

plate.

IXON INDUSTRIES. INC. A

BLOUNT COMPANY AIRPORT

INDUSTRIAL PARK

PO BOX 1569

COFFEYVILLE KS 67337 0945

316 251 2000

FAX 316 251 4117

REMOVING THE BODY

1. The 312 has a two-piece polyethylene body. The upper body can be folded forward to

expose the transaxle. In some cases, it may be necessary to remove the upper body to

service the transaxle.

2. To remove upper body, remove two bolts P/N 3093 from the front of upper body hinge

located on the brake shaft P/N 9283. Disconnect seat switch P/N 4761 at plug-In.

3. Reverse above procedure to reinstall.

ADJUSTMENT OF MOWER DECK DRIVE BELT

1. This mower deck drive belt is tensioned by a spring loaded engagement Idler quadrant.

2. This system Is designed to maintain the proper belt tension at all times.

3. Belt tension can be adjusted by moving the engaging rod P/N 7013 into the outside hole of

engagement handle P/N 7020.

4. After belt tension is adjusted, check to assure that the mower blade will not turn freely when

the engaging rod is in the "OFF" position.

5. If the mower blade turns freely, adjust the blade brake by loosening nut P/N 3205 at the end

of the brake rod P/N 2988.

6. After adjustment is achieved, perform the safety checks listed below.

REMOVING THE MOWER BLADE

Secure blade P/N 2483 from turning. Remove blade bolt from centerof blade P/N 3268, and

blade washer P/N 6260 then remove blade P/N 2483. To reinstall. reverse above procedure.

WARNING: Sharp edges on blade can cause injury!

Caution should be exercised when service is required on blade.

REMOVING THE MOWER DECK

1. Loosen belt keepers P/N 7026 & 7027 located under the engine by loosening two rear

engine

mounting bolts, allowing the deck drive belt to come free of the rear pulley.

2. Disconnect the wiring loom at the deck safety switch P/N 4242.

3. Remove the two clevis pins P/N 3072 from the two rear L-rods P/N 1355 and slide from slots.

4. Remove clevis pin P/N 3072 from L-rod attached to lift handle and slide from slot.

5. Remove clevis pin P/N 3072 from front deck hanger shaft P/N 1332, located at front of mower

deck on slide plates welded at battery box, and remove.

6. Lift front of mower chassis clear of deck. Roll chassis free of the deck.

7. To install, reverse the above procedure. . ~ .

MOWER BLADE OPERATION

To engage mower blades, turn engagement lever on floor slowly to the "ON" position. To

Disengage mower blades, turn leverslowly to the "OFF" position.

SAFETY CHECKS

IMPORTANT-PERFORMSAFETYCHECKSAFTERMAKINGANYREPAIRSORADJUSTMENTS

•' •'-'••••'

1. After reassembly, while seated on mower, attempt to start engine with mower deck

engaged. Engine should not start. If engine does start, returnthe mower to an Authorized

Dixon dealer for adjustment or repair.

2. Disengage mower deck and start engine. With the operator In the normal seated position. ,

engage mower deck and remove weight from seat. The engine should stop. If the engine

does not stop when operator rises from seat, return the mower to an Authorized Dixon

dealer for adjustment or repair.

3. Engage then disengage mower blade in each cutting height. Insure that blade disengages

and comes to a stop within (5) seconds in each height position. If blade does not

disengage properly, contact your Authorized Dixon dealer.

CAUTION: DO NOT OPERATE MOWER IF ANY SAFETY FEATURE IS NOT FUNCTIONING CORRECTLY

PARKING BRAKE ADJUSTMENT

Remove the body as described above. Tighten nut on brake rod P/N 2533 located In front of

the transaxle on each side, just enough to prevent brake from slipping when engaged.

CAUTION: Over-tightening may cause premature wear on the brake band P/N 5085

Revised 2/93

P/N 8114,

312 BODY ASSEMBLY

312 CHASSIS ASSEMBLY

312 TRANSAXLE ASSEMBLY

312 MOWER DECK ASSEMBLY 30'

312 WIRING ASSEMBLY

Questo manuale è adatto per i seguenti modelli

Altri manuali Dixon Taglia erba

Dixon

Dixon SpeedZTR 46 CE Manuale utente

Dixon

Dixon ZTR RAM SERIES Manuale di installazione

Dixon

Dixon ZTR Ram Ultra 61 Manuale utente

Dixon

Dixon DX152 Manuale utente

Dixon

Dixon D17K38 Manuale utente

Dixon

Dixon BLACK BEAR ZTR 34/968999564 Manuale utente

Dixon

Dixon SPEEDZTR 38 Manuale operativo e di manutenzione

Dixon

Dixon ZTR 966504101 Manuale utente

Dixon

Dixon Zeeter Zero-Turn Riding Mower Guida

Dixon

Dixon 7000 Manuale utente

Dixon

Dixon SPEEDZTR ZTR 42 Manuale di installazione

Dixon

Dixon RAM Series Manuale utente

Dixon

Dixon D25KH48 Manuale utente

Dixon

Dixon 1999 ZTR 4515B Manuale utente

Dixon

Dixon ZEETERTM 14295-1005 Guida

Dixon

Dixon ztr dx260 Manuale utente

Dixon

Dixon SpeedZTR 30 CE Manuale utente

Dixon

Dixon SPEEDZTR 44/965981001 Manuale utente

Dixon

Dixon ZTR 5000 Series 2000 Manuale utente

Dixon

Dixon D25K48YT Manuale utente

Dixon

Dixon ZTR 424 Manuale di istruzioni

Dixon

Dixon CE RAM Manuale utente

Dixon

Dixon ZTR 301 Manuale utente

Dixon

Dixon ZTR 4423 Manuale utente

Manuali Taglia erba popolari di altre marche

RHINO

RHINO 1958 Manuale utente

Wolf Garten

Wolf Garten Compact plus 40 B Manuale utente

Cub Cadet

Cub Cadet LTX 1045 Manuale utente

Craftsman

Craftsman 917.378461 Manuale utente

GGP ITALY SPA

GGP ITALY SPA CR/CS 434 SERIES Manuale utente

Challenge

Challenge CH18V2 Istruzioni operative

TALEN TOOLS

TALEN TOOLS AVR HGM30 Manuale utente

DEWEZE

DEWEZE ATM-725 Manuale operativo

Weed Eater

Weed Eater 180083 Manuale utente

Husqvarna

Husqvarna Poulan Pro PP185A42 Manuale utente

Better Outdoor Products

Better Outdoor Products Quick Series Manuale utente

Cub Cadet

Cub Cadet 23HP Z-Force 60 Manuale operativo

MTD

MTD 795, 792, 791, 790 Manuale utente

Toro

Toro Groundsmaster 3505-D Manuale utente

Dennis

Dennis FT 610 Manuale utente

AIRFORCE

AIRFORCE F-15 Gen 3 Manuale utente

MTD

MTD 126-220-000 Manuale utente

Toro

Toro 74806 Manuale utente