INSTALLATION MANUAL
RK SERIES - IP NETWORK CAMERAS
Page:7
DSE SRL - ITALY - WWW.DSE.EU
bracket for wall mounting, specially made to allow the passage of cables inside it and protect
them from tampering attempts. The camera is usually mounted at the cable outlet so that no
cables are left bare. However, the fixing base also has a lateral cable outlet slot if the cables come
from the side in an external conduit.
The bracket must be fixed to the wall or ceiling with the supplied plugs. On the back of the way
bracket is an insulating foam pad whose function is to eliminate the space for the penetration of
insects.
With the Allen key supplied, loosen the retaining screw B and then orient the camera thanks to
the joint A. At the end, fully tighten the retaining screw B to lock the camera in its position
ASSEMBLY OF SPHERICAL CAMERAS
The spherical cameras consist of the camera globe and the fixing
base which are screwed together. Before proceeding with the
assembly, the fixing base must be unscrewed, separating it from
the camera body. In general, no tools are needed to unscrew the
fixing base from the camera body, however if this is tightened too
deeply, it is possible to help.placing a rigid rod, such as a
screwdriver, between the two lateral cable outlet slots located in
the base.
The fixing base, separated from the camera, is fixed to the wall or
to the wall with plugs in correspondence with the cable outlet hole and then the camera body is
screwed onto it. Before tightening fully, orient the viewing angle correctly.
CONNECTION BOXES
For both cylindrical and spherical models, watertight boxes are available separately to house the
connections, to be mounted between the wall and the bracket. The boxes have a rear or side
cable entry (watertight cable gland included) and have the fixing holes for the different models on
the cover.
