Easi-Dec Roof-Walk Manuale utente
RW010
Issue 01
PLEASE BE ADVISED: Before assembling the Roof-Walk for the first time, it is highly recommended
that Installers familiarise themselves with the component parts and carry out a test assembly and
disassembly in a safe area away from the point of final installation. All component parts detailed in the
operating instructions must be used in the assembly of the system. Should a piece be missing or
appear defective do not continue to assemble and contact Easi-Dec Immediately.
Step1 Step 2
Lay out the components ready for assembly.
Attach the first support Batten to the Board-Walk section using the
captivated pins in the hole in the stiles.
Step 3 Step 4
Repeat STEP 2 for the second Batten. Step 1 & 2 should be
repeated for each additional Board-Walk.
Tie the supplied strap to the top rung of the Board-Walk.
Step 5 Step 6
With the strap tied on securely lower the Board-Walk panel onto
the roof. You would repeat these steps for additional Board-Walk
panels. This picture is for demonstration purposes only.
Connecting Additional Board-Walk together, follow STEP 4 & 5 in
these instructions for laying the board walk into position.
RW010
Issue 01
Step 7 Step 8
Standing on the first Board-Walk, slide through the Locking pin.
When the Locking pin is in place secure with the supplied ‘R’ clip.
Step 9 Step 10
Install the two number trolleys on the separate tracks of Board-
Walk. Positioning the rollers on the stiles of the staging and
engaging the hooks on a rung.
Remove the height adjusting pin and raise the height of the
platform to the horizontal position. Remember this is usually set at
Roof level.
Step 11 Step 12
Repeat STEP 10 for the height adjustment of the trolley on the
second roof-Walk in.
Position the Cat-Walk onto the trolleys.
Step 13 Step 14
The Catwalk should be positioned uniformly over the trolleys.
The Platform is now strapped to the trolleys with the ratchets
straps provided. Repeat strap attachment for the second trolley.
RW010
Issue 01
Step 15 Step 16
Fit the two end uprights into the sockets and secure with the
supplied pin and ‘R’ clip.
Fit the mid-rail into position.
Step 17
Fit the top rail and secure both the mid and top rails to the end
uprights with the grub screws provided.
Remember
If working within 2m of an Edge the edge protection must be provided.
All Ladders should be erected using 4:1 rule and tied off for maximum safety.
Always clip on to the 3m safety-line fixed to one side of the platform with a lanyard whenever possible.
Always assess the site for suitability
Always strap the staging securely onto the Roof-Walk Trolleys.
Maximum load is 150Kg per Board-Walk
Dismantle: Reverse the above assembly.
Altri manuali Easi-Dec Sensore di sicurezza
