DCP 350 User Manual
10 Ribbon Balance
Type / Remains On On Card out Display the ribbon type
and remains Display the installed ribbon’s type and the remains. It can be shown
by pressing the left LED button on the system ready mode.
11 DCP350
Printing! On On Printing Under printing.
LED Button
No LCD Display Left Right Left Right State Description
12 DCP350
Mag R/W On On Reading or writing the
Magnetic stripe Magnetic encoder is reading or writing the magnetic stripe
information.
13 Spool Error!
<-Any Key Push-> Blinking Blinking Cancel &
Initialize Cancel &
Initialize Printing data is not
transmitted properly Shown it when error occurs in a printing data transmission. Press
any keys to delete the spooled data and to return the ready state.
14 Print Error xx
<Replay Cancel> Blinking Blinking Repeat Cancel &
Initialize Error in printing or
moving a card Error in the printing or the transmission. Retry by pressing the left
button or cancel the command by pressing the right button.
15 Top Cover Open
<-Card Moving -> Blinking Blinking Move a
card to the
back side
Move a card
to the front
side Top cover open
Top cover is open. The card in the printer can be moved by
pressing the left or right LED button. If press both buttons at the
same time, the print head will be up and down. (Flipper will be flip
over if it is installed)
16 Check Please..
Ribbon Not Found Blinking Blinking Ribbon
redetecting Ribbon
redetecting There is no ribbon in the
printer or fail to detect
Fail to detect the ribbon. Check the ribbon installed state. If there
is no ribbon, install the ribbon. If there is a ribbon, pull out it and
install again. Press the left or right button to redetect the ribbon.
17 Check Please..
Ribbon Zero Blinking Blinking Ribbon
redetecting Ribbon
redetecting The installed ribbon has
run out
It is displayed when the installed ribbon is all used up. Replace
with new ribbon. Press the left or right button to redetect the
ribbon.
18 Check Please..
TPH Not Found Blinking Blinking Thermal Print head is not
installed
Thermal Print Head is not installed or there is a misconnection of
the cable. Open the top cover to check the print head installed
state or turn off the printer and check the cable connecting state.
19 Print Error xx
Top Cover Open Blinking Blinking Fail to move the card out
(Check the card in the
printer)
The card in the printer will be come out when the initialization or
top cover close. If it is not come out, this message will be
displayed. Remove the card and close the top cover.
