Eiki EK-800U Manuale utente

SERVICE MANUAL

EK-800U

Date Revise Version Description

2016.01.11 V1.0 Initial Issue

EK-800U

Preface

This manual is applied to EK-800U projection system.The manual gives you a brief

description of basic technical information to help in service and maintain the product.

Your customers will appreciate the quick response time when you immediately identify

problems that occur with our products.We expect your customers will appreciate the

service that you offer them.

This manual is for technicians and people who have an electronic background.Please send

the product back to the distributor for repairing and do not attempt to do anything that is

complex or not mentioned in the troubleshooting.

Note: The information found in this manual is subject to change without prior notice.Any

subsequent changes made to the data herein will be incorporated in future edition.

EK-800U Service Manual

Manual Version Rev 1.0

EK-800U

Table of Content

Chapter 1 Introduction

Highlight 1-1

Chapter 2 Disassembly Process

Equipment Needed & Product Overview 2-1

Disassemble Projector Lens 2-2

Remove the Fan 1 and Fan 2 2-3

Remove the Lamp 1 and Lamp 2 Module 2-5

Remove the Color Wheel Module 2-6

Remove the Fuse 2-7

Remove Top Cover 2-8

Remove Main Board 2-9

Remove the front cover and components 2-16

Remove the Back Cover 2-18

Remove the Left Cover 2-21

Remove the Keypad 2-22

Remove the Right Cover and Fan 4 2-23

Remove the lamp driver 2-24

Remove the Optical Engine Module 2-27

Remove the DA,Lamp Housing 2-30

Remove the DMD,DMD Board 2-31

Remove the Color Wheel Docking Board 2-33

Remove the AC Inlet 2-34

Remove the Power Supply 2-35

Remove the Fan 7 and Fan 10 2-36

Remove the bottom cover 2-37

Repair Action 2-38

EK-800U 4

Chapter 3 Troubleshooting

LED Lighting Message 3-1

Equipment Needed 3-2

Main Procedure 3-3

No Power Troubleshooting 3-4

Power Troubleshooting 3-5

Pin Protect Troubleshooting 3-8

Image Performance Troubleshooting 3-9

Remote Control Troubleshooting 3-13

Network Troubleshooting 3-14

Chapter 4 Test & Inspection

Test Equipment Needed 4-1

Service Mode and Factory Mode 4-1

Factory Reset 4-3

Calibration 4-4

Adjustment 4-11

Chapter 5 Firmware Upgrade

Formatter/Scalar/LAN/MCU Firmware Upgrade 5-1

Recovery Mode 5-9

Re-write Serial Number 5-11

Appendix A

Exploded Image I

1-1

EK-800U

Chapter 1 Introduction

1. Introduction

1-1 Highlight

No Item Description

1Dimensions (W xH x D)

• 520 x 208 x 591 mm (with protrusion)

• 520 x 194 x 591 mm (without protrusion)

2 Weight (kg) • 23.8 kg (without lens)

3 Power Supply

• 1150W (110V)

• AC 100 - 120 V, 200 - 240 V

• Fuse:250V 15A

4 Keystone Correction

• Horizontal: +/- 20 degrees

• Vertical: +/- 20 degrees

5 Brightness • Normal: 12000 lm

• Eco: 9600 lm

6 Throw Ratio

• AH-B22010(A18): 0.84~1.02

• AH-B22020(A19): 1.02~1.36

• AH-B22030(A20): 1.20~1.50

• AH-B21010(A21): 1.50~2.00

• AH-B24010(A22): 2.00~4.00

• AH-B23010(A23): 4.00~7.20

7 Uniformity • 90% (JBMA)

8Lamp • 1500 hours typical (Normal:465W)

• 2000 hours typical (Eco:370W)

9 I/O Terminal

• HDBase-T:

• 3G HD-SDI:

• HDMI:

• DVI-D:

• R/G/B/H/V, Y/Pb/Pr:

• VGA:

• Video:

• VGA (Out):

• 3D Sync:

• RJ45 x 1

• BNC x 1

• HDMI (v1.4a)x 1

• DVI-D x 1

• BNC x 5

• D-sub 15 pin x 1

• BNC x 1

• D-sub 15 pin x 1

• BNC x 1

1-2 EK-800U

Chapter 1 Introduction

No Item Description

10 Control Terminal

• LAN Control:

• Remote Control IN:

• Remote Control OUT:

• Serial port (RS232C):

• Wi-Fi (with dongle):

• Service:

• RJ45 jack x 1

• Mini jack (3.5mm) x 1

• D-Sub 9 pin (Cross) x 1

• USB Type A x 1

• Mini USB x 1

11 DMD chip • 0.96" WUXGA, Type A, DC3

12 Native resolution • 1920 x 1200

13 Video Compativility • NTSC (M, 3.58/4.43 MHz)

• PAL (B/D/G/H/I/M/N, 4.43 MHz)

14 Color Wheel • Brightness type (Normal): 6 segments (Y44 type)

• Color type (Optional): 6 segments (Y41 type)

15 Operating Temperature

• 0~40 degree

• 0~2500 ft: 0~40 degree

• 2500~5000 ft: 0~35 degree

• 5000~10000 ft: 0~30 degree

Note:Measurement,measuring conditions and method of notation all comply

with ISO 21118 international standards.

2-1

EK-800U

Chapter 2 Disassembly Process

2. Disassembly Process

2-1 Equipment Needed & Product Overview

1. Screw Bit (+) :105

2. Screw Bit (+) :107

3. Screw Bit

(-)

:107

4. Hex Sleeves 5 mm

5. Hex Sleeves :14.0 mm

6. Needle-nose pliers

7. Projector

* Caution:

-This process is protective level II. Operators should wear electrostatic chains.

-The unit should be powered down and disconnected from mains.

 -WhendisassembleEnginemodule(2-18),pleasenoticethatitrequirespecic

environmental conditions (clean room).

Chapter 2 Disassembly Process

2-2 EK-800U

2-2 Disassemble Projector

Lens

1. Press and hold on the lens bar.

2. Hold on projector lens, rotate it carefully

(As red arrow), then remove it carefully.

lens

Chapter 2 Disassembly Process

2-3

EK-800U

2-3 Remove the Fan 1 and Fan 2

1. Open the lamp cover module to loosen two

captive screw.

2. Remove the lamp cover module.

3. Loosen four screws and unplug two connectors

to remove the fan 1 and fan 2.

4. Disconnect the extended wire then separate

the outlet vent cover and fan.

Chapter 2 Disassembly Process

2-4 EK-800U

5. Tear off two rubbers to separate fan 1 and fan 2.

Note:Fan 1 and fan 2 are the same.

6. Unscrew two screws to remove the fan docking board.

7. Replace the rear cover if required.

Fan docking board

Rear cover

Altri manuali per EK-800U

Indice

Altri manuali Eiki Proiettore

Eiki

Eiki Brilliant LC-SB15 Manuale utente

Eiki

Eiki EK-830U Manuale utente

Eiki

Eiki EK-400X Manuale utente

Eiki

Eiki LC-XIP2000 Manuale utente

Eiki

Eiki LC-XNB3S Manuale utente

Eiki

Eiki LC-7000U Guida all'installazione

Eiki

Eiki LC-NB2U Manuale utente

Eiki

Eiki EIP-D450 Manuale utente

Eiki

Eiki LC-XB21 Manuale utente

Eiki

Eiki EX-5000 Manuale utente

Eiki

Eiki EK-301W Manuale utente

Eiki

Eiki LC-XSP2600 Manuale utente

Eiki

Eiki XGA Manuale utente

Eiki

Eiki LC-XB42 Manuale utente

Eiki

Eiki LC-7000U Guida all'installazione

Eiki

Eiki LC-X986 Istruzioni per l'installazione e il funzionamento

Eiki

Eiki EK-300 Series Manuale utente

Eiki

Eiki LC-XT6 Manuale di installazione

Eiki

Eiki LC-SD10 Manuale utente

Eiki

Eiki EK-300U Manuale utente

Eiki

Eiki LC-XB31 Manuale utente

Eiki

Eiki LC-HDT2000 Manuale utente

Eiki

Eiki Multimedia Projector LC-XG400 Manuale utente

Eiki

Eiki LC-X50M Guida all'installazione

Manuali Proiettore popolari di altre marche

iEmmet

iEmmet MP-312 Manuale utente

Epson

Epson VS400 Manuale utente

Sony

Sony VPL-HS10 Marketing Specifications & Features Manuale utente

Sony

Sony VPL-HW65ES Manuale di servizio

Toshiba

Toshiba TLP-791U Manuale utente

Philips

Philips LC1341 Guida di riferimento

Panasonic

Panasonic PTL735NTU - LCD PROJECTOR-NETWORK IB Manuale utente

NEC

NEC NP600S EDU Manuale utente

BenQ

BenQ SH753P Manuale utente

Epson

Epson PowerLite Pro Cinema 6020UB Manuale utente

Epson

Epson PowerLite Home Cinema 705HD Manuale utente

Christie

Christie LHD700 Manuale utente

Navitar

Navitar FX Manuale utente

InFocus

InFocus LitePro 560 Manuale utente

Sony

Sony SRX-R815P Manuale utente

Vivitar

Vivitar DP1500 X Manuale utente

Acer

Acer C20 Series Manuale utente

Asus

Asus ZenBeam Latte Manuale utente