Ekwb 3831109831335 Guida

All disclosures, notices and warranty conditions are being written on the back of the box. Revision 1.1. Released on 7th of June, 2016.

Installation and mounting manual for EK-FC1070/1080 GTX

Backplate

This product is intended for installation only by expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to your equipment. EK Water Blocks assumes no liability

whatsoever, expressed or implied, for the use of these products, nor their installation. The following instructions are subject to change without notice. Please visit our web site at www.ekwb.com for updates. Before

installation of this product please read important notice, disclosure and warranty conditions printed on the back of the box.

STEP 1: GENERAL INFORMATION. Sample picture of nVidia GeForce 1070/1080 GTX graphics card.

STEP 2: PREPARING YOUR GRAPHICS CARD

EK-FC1080 GTX Backplate is very easy to install. First install EK-FC1070/1080 GTX series water block according to its installation manual. If you have it

already installed, please check the picture below to see which mounting screws are to be left in their position and which are to be removed. Please remove

the six (6) M2.5x4 AX1 screws and their PVC washers as well (marked with arrow).

STEP 3: APPLYING THE THERMAL PADS

EK-FC1070/1080 GTX Backplate features passive cooling of the printed circuit board and its components therefore it is mandatory to install the

enclosed thermal pad. Please install enclosed 1mm thick thermal pad (Thermal Pad A –1,0mm (120x16) as shown on the picture below. You may

need to trim the excess thermal pad.

Thermal PAD F - 1mm (120x16mm)

EK-FC 1070/1080 GTX Backplate

All disclosures, notices and warranty conditions are being written on the back of the box. Revision 1.1. Released on 7th of June, 2016.

STEP 4: ATTACHING EK-FC1070/1080 GTX BACKPLATE TO THE GRAPHICS CARD

Take enclosed mounting screws and install them as shown on picture below. Use six (6) M2.5x7 AX1 screws, and tighten them using Philips head screwdriver

screwdriver.

HINT: Do not tighten screws until they are all positioned in their mounting holes. The backplate has milled in standoffs, so there is no fear of over tightening of

the screws. Nevertheless do not exaggerate with screwing force as there is no need for it.

By all means users must also consider that this product is intended to be used only with EK-FC1070/1080 GTX series water blocks. No other 3rd party heat sinks

or coolers are officially supported! EK does not offer any assistance or support in the latter application.

IMPORTANT DISCLOSURES

VERY IMPORTANT NOTICE: Once the installation is completed, it is a recommended practice to test the cooling circuit for leaks prior to powering up the

computer. We recommend a 24 hour leak test prior to powering up the computer. Do not test the water block using city water pressure. This will rupture the top

of the housing and render the block unusable (and will void your warranty).While all efforts have been made to provide the most comprehensive tutorial possible,

EK Water Blocks assumes no liability expressed or implied for any consequential damage(s) occurring to your equipment as a result of using EK Water Blocks

cooling products, either due to errors or omissions on our part in the above instructions, or due to failure or defect in the EK Water Blocks cooling products.

WARRANTY:

Our products are warranted against defects in materials or workmanship for a period of 24 months beginning from the date of delivery to the final user. During

this period, products will be repaired or have parts replaced at our discretion provided that: (I) the product is returned to the agent from whom it was purchased;

(II) the product has been purchased by an end user and has not used for commercial purposes; (III) the product has not been misused, handled carelessly, or

used in a manner other than in accordance with the instructions provided describing its installation and proper use. This warranty does not confer rights other

than those expressly set out above and does not cover any claims for consequential loss or damage. This warranty is offered as an extra benefit and does not

affect your statutory rights as a consumer. This warranty is voided if the product comes in contact with aggressive UV additives or other improper liquids.

EK blocks are sealed with warranty void circular label, which proves that the block has withstood a pressure leak test. Removing it will void leak-free guarantee

and not the guarantee on the product itself. Any other RMA issues can be reported to EK Support at http://www.ekwb.com/support for further analysis.

REQUIRED TOOLS AND MOUNTING SCREWS:

Philips head screwdriver scissors

M2.5x7 AX1

Questo manuale è adatto per i seguenti modelli

Indice

Altri manuali ekwb Hardware per computer

ekwb

ekwb EK-FC1080 GTX Ti Aorus RGB Manuale utente

ekwb

ekwb EK-FB GA AX370 Gaming RGB Monoblock Manuale utente

ekwb

ekwb EK-FC1080 GTX FTW Guida

ekwb

ekwb EK-PRO GPU WB RTX A100 80GB Manuale utente

ekwb

ekwb EK-Quantum Vector2 Trio RTX 3080/90 ABP Set... Manuale utente

ekwb

ekwb EK-Velocity sTR4 Manuale utente

ekwb

ekwb EK-FC1080 GTX Ti FTW3 Backplate Guida

ekwb

ekwb EK-FC 770 GTX DCII Manuale

ekwb

ekwb EK-FC1080 GTX Ti Aorus Manuale utente

ekwb

ekwb EK-Vector RTX 2080 FTW3 Manuale utente

ekwb

ekwb EK-Quantum Vector TUF RX 6800 Manuale utente

ekwb

ekwb EK-Quantum Momentum2 ROG Strix Z690-I Gaming D-RGB -... Manuale utente

ekwb

ekwb EK-Quantum Vector Trinity RTX 3080/3090 Manuale utente

ekwb

ekwb EK-SB ASUS M6G Guida

ekwb

ekwb EK-FB ASUS Maximus XI HERO Manuale utente

ekwb

ekwb EK-Quantum Magnitude sTRX4 Manuale utente

ekwb

ekwb EK-FC R9 Fury X Guida

ekwb

ekwb EK-Classic GPU Water BlockRTX 2080Ti D-RGB Manuale utente

ekwb

ekwb EK-Supremacy EVO X99 Series Manuale utente

ekwb

ekwb EK-PRO GPU WB H100 Rack - Nickel + Inox Manuale utente

ekwb

ekwb EK-FC Strix RTX 2080 Ti Backplate Classic Manuale utente

ekwb

ekwb EK-FC980 GTX Ti Classy KPE Series Manuale

ekwb

ekwb EK-PRO GPU WB RTX 6000 ADA Nickel Inox Manuale utente

ekwb

ekwb EK-RES X3 D-RGB Manuale utente

Manuali Hardware per computer popolari di altre marche

EMC2

EMC2 VNX Series Manuale del proprietario

Panasonic

Panasonic DV0PM20105 Manuale utente

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Manuale utente

Gigabyte

Gigabyte B660M DS3H AX DDR4 Manuale utente

Raidon

Raidon iT2300 Manuale utente

National Instruments

National Instruments PXI-8186 Manuale utente

Hauppauge

Hauppauge WinTV-HVR-2250 Manuale utente

Kontron

Kontron CP6002 Manuale utente

Manhattan

Manhattan 702843 Manuale utente

Aphex

Aphex 230 Manuale utente

AMD

AMD Phenom II Manuale operativo

Intel

Intel NUC 12 Pro Manuale utente

dbx

dbx Zone Pro 1260 Manuale utente

Galaxy

Galaxy GHDX2-2430S-24F4D Manuale utente

Intel

Intel AXXRMFBU4 Manuale utente

Kontron

Kontron DIMM-PC/MD Manuale utente

ST X-NUCLEO-SAFEA1B Istruzioni operative

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Manuale utente

ekwb 3831109831335 Guida

Manuali Hardware per computer popolari di altre marche