General Information
[
[
[
[
[
[
[
[
[
[
[
[
[
This product must be earthed.
Do not make any inflammable liquids, water or metal objects enter this
unit.
Very hot lamp. Disconnect the power and wait for at least 10 minutes
before you can replace the lamp.
Make sure the fan and the air inlets are clean and not blocked by
anything before using.
Do not operate this unit if the ambient temperature(Ta) exceeds 40 C
(104 F).
Do not stare directly into the light, as may do harm to your eyes.
Keep all flammable materials at least 1 meter away from this unit.
Never operate this unit when its cover is removed.
Keep this unit out of children.
Do not dismantle or modify the unit.
Unplug the fixture from the AC outlet and allow the fixture to cool
before any service.
The installation should be done by qualified staff only.
Safety Instructions:
Read users manual before use. Never look directly into the light source.
Caution:
During the operation the housing becomes very hot!
Before opening the housing disconnect from mains! Keep away from rain
and moisture! "Disconnect from mains before replacing the lamp. CAUTION-Hot
Lamp."
-4-
Operation Guide
This is a High-Tech product. When you are sure you have set up this unit
properly, you can operate this unit freely.
1. Always be sure to mount this unit in the area that will allow proper
ventilation.
2. Check that the local power outlet match that of the required
voltage of your unit.
3. Plug this unit into the AC power outlet, turn the switch on.
4. The lamp will be lit and the cooling fan will start immediately.
Important!
Never disconnect or reconnect the power frequently during operation, this will
shorten the lamp life.
Wait at least 10 minutes to cool down the lamp completely before restarting this
unit. (the warm lamp will cause the igniter holding the lamp in a glow state.)
1. Disconnect the fixture from power.
2. With a flat screwdriver wedge the fuse holder out of its housing.
3. Remove the old fuse from the holder and replace with the exact same type
fuse.
4. Replace the fuse holder in to the fuse holder housing.
5. Reconnect main power.
Fuse Replacement
-7-
Optional Accessories & Effects
A pair of low voltage electrified guides(24V) with short-circuit protection are
equipped with this fixture to accept the user's choice of lens unit and optional
accessories for different effects and various combinations. The effects can be
either static or motorized for stationary and moving images.
Simple-This spot is compact, easy to use and entertaining, and the electrified
guides makes it extraordinarily simple to mount the effects system.
Safe-The low voltage used for the effects eliminates the risk of electric shock.
Forced cooling design reduces operating and surface temperature.
Styling-The spot is elegantly styled, fit in anywhere and runs quietly over long
periods with low operating costs.
