Explanation
GB-6
GB
Installation/connection
GB-5
vbTerminals for venetian blind switch
At these inputs you can connect a venetian blind switch.
VBTerminals for ProLine devices
It is possible to connect all potential-free devices to these
terminals. However only devices from the ProLine family can use
all the signals.
Advice: The connected ProLine devices must be calibrated as
DRIVE CONTROL DEVICES.
Programming the radio
Programming the transmitter/channel
Precondition: The Invio-868 must be installed. The switch or
another ProLine control device must also be
connected.
1. In the case of already-installed receivers,switch the fuse off
and then on again after a few seconds.
The receiver will now be in ready-to-program mode for
5 minutes
.
2. Now press the Pkey on the Invio-868 or on a manual
transmitter.
The receiver will now be in ready-to-program mode.
3. In order to define the key assignment,immediately after the
start of upward travel (1 sec.) press the UP key on the switch or
on the control device.
The roller shutter will stop for a short time.
Immediately after starting downward travel press the DOWN
key on the switch or on the control device.
The roller shutter will stop.
The Invio-868 has now been programmed.
2. Carry out the Invio-868 programming procedure at the
receiver (see Section entitled„Radio programming“).
3. Place the Invio-868 in the switchbox.
Advice: Make sure that the aerial is installed optimally.
Connection
The design for a control device can be found in the controller catalogue.
Warning!
Risk of injury due to electrocution!
•The connection must only be made by an authorized
specialist!
•The device only offers protection against touch by the back
of the hand (IP1X), no protection against accidental contact.
• Do not kink, shorten or extend the aerial..
• Only actuate the programming key P with an insulated tool
(4 kV proof voltage).
Precondition: Branch switchbox at 60 mm depth.
1. Connect the stripped cable ends without connector sleeves
as follows:
