Emerson Bettis RP4AF Manuale utente

Bettis RTS Relay Board (RP4AF)

Electric Actuator

Installation, Operation and Maintenance Manual

VCIOM-15749-EN Rev. 0

June 2021

Revision Details

June 2021

Installation, Operation and Maintenance Manual

VCIOM-15749-EN Rev. 0

Revision Details

No. Date Version Type of Change

1 June 2021 0 General update

(Migration to new template)

Revision Details

Table of Contents

June 2021

Installation, Operation and Maintenance Manual

VCIOM-15749-EN Rev. 0

Table of Contents

Section 1: Tools

Tools.........................................................................................................................1

Section 2: Material

Material.....................................................................................................................2

Section 3: Installation

Installation................................................................................................................3

Section 4: Programming

Programming............................................................................................................7

Notes

June 2021

Installation, Operation and Maintenance Manual

VCIOM-15749-EN Rev. 0

This page is intentionally left blank

June 2021

Installation, Operation and Maintenance Manual

VCIOM-15749-EN Rev. 0

1Tools

Section 1: Tools

! WARNING

Remove all power supplies before doing the exchange. Act always with caution during

the exchange!

• Needle nose pliers

• Screw driver phillips

• Screw driver at

• Allen key 5

• Socket wrench 5

Figure 1

June 2021

Installation, Operation and Maintenance Manual

VCIOM-15749-EN Rev. 0 Rev. 0

2Material

Section 2: Material

• 1x relay board RP4AF (ID:15772)

• 2x steel screw M3x16 (ID:952)

• 3x plastic distance 8 mm (ID:9896)

• 1x plastic screw M3x15 (ID:9895)

• 1x plastic nut M3 (ID:7084)

• 2x lock plates M3 red (ID:13674)

Figure 2

Figure 3

June 2021

Installation, Operation and Maintenance Manual

VCIOM-15749-EN Rev. 0

3Installation

Section 3: Installation

Unscrew the 4 hexagon socket screws from the cover and remove it carefully. Mind the

connection cable between display and logic board.

Figure 4

Unscrew the 4 cross recessed screws from the existing logic board and afterwards tilt it

carefully to you.

Figure 5

June 2021

Installation, Operation and Maintenance Manual

VCIOM-15749-EN Rev. 0 Rev. 0

4Installation

Section 3: Installation

Remove the cable with the 10-pole connector and connect it with the relay board.

Figure 6

Insert plastic screw M3x15 in provided hole and add plastic distance on it, after connect the

relay board with the logic board on suitable connector. Add plastic nut on plastic screw to

x the board.

Figure 7

June 2021

Installation, Operation and Maintenance Manual

VCIOM-15749-EN Rev. 0

5Installation

Section 3: Installation

Put two plastic distances 8 mm between logic and relay board, insert the M3x16 steel

screws through the estimated holes in logic board, plastic distances and relay board and

secure the screws with the red lock plates.

Figure 8

Install die logic + relay board back to the control (two small screws for original installation

will remain). Take care of possible damage of cables or other parts.

Figure 9

June 2021

Installation, Operation and Maintenance Manual

VCIOM-15749-EN Rev. 0 Rev. 0

6Installation

Section 3: Installation

Connect cable between display cover and logic board. Perform a Firmware update now,

before installing display cover on the unit. This update is important for the following

programming steps (use FW version display 1507, logic 219 or higher). For a detailed

description on how to perform a rmware update, please refer to separate manual.

During display cover installation, pay attention to the O-ring which must be sit correct

between cover and housing and x it with the 4 hexagon socket screws.

Figure 10

Altri manuali per Bettis RP4AF

Indice

Altri manuali Emerson Controllori

Emerson

Emerson EC3-932 Manuale utente

Emerson

Emerson Bettis 2000 Series Manuale

Emerson

Emerson Fisher Fieldvue DVC6030f Manuale utente

Emerson

Emerson Dixell iPro Master IPM500D Schema elettrico

Emerson

Emerson Dixell XR70CH Schema elettrico

Emerson

Emerson TARTARINI FL Series Manuale utente

Emerson

Emerson EL-O-MATIC EL35 Manuale utente

Emerson

Emerson EIM TEC2 500 Manuale utente

Emerson

Emerson Bettis CBB Series Istruzioni per l'installazione

Emerson

Emerson E300 Series Manuale utente

Emerson

Emerson 99 Manuale utente

Emerson

Emerson Bettis XTE3000 Manuale utente

Emerson

Emerson Asco Advantage Series Manuale utente

Emerson

Emerson Fisher 657C Manuale utente

Emerson

Emerson Tescom 44-1800 Series Manuale utente

Emerson

Emerson CASH VALVE B Series Manuale

Emerson

Emerson Fisher 67CS Manuale utente

Emerson

Emerson Site Supervisor Manuale utente

Emerson

Emerson EXD-SH2K Manuale utente

Emerson

Emerson Bettis RGS Q Series Manuale utente

Emerson

Emerson Affinity Manuale utente

Emerson

Emerson Fisher 67D Series Manuale utente

Emerson

Emerson PACSystems RX3i DNP3 Manuale utente

Emerson

Emerson EC3 Series Manuale utente

Manuali Controllori popolari di altre marche

Digiplex

Digiplex DGP-848 Istruzioni operative

YASKAWA

YASKAWA SGM series Manuale utente

Sinope

Sinope Calypso RM3500ZB Manuale utente

Isimet

Isimet DLA Series Style 2 Manuale di installazione

LSIS

LSIS sv-ip5a Manuale utente

Rockwell Automation

Rockwell Automation 1769-L31 Manuale utente

Airflow

Airflow Uno hab Manuale utente

ABB

ABB ACS580-01 drives Manuale utente

Panasonic

Panasonic GM1 Series Manuale utente

AutoAqua

AutoAqua Smart ATO micro SATO-120P Manuale utente

Panasonic

Panasonic FP? Positioning Unit RTEX Manuale utente

Samson

Samson Type 5824 Manuale di servizio

Alpha IP

Alpha IP MIOB 21001 Manuale utente

Siemens

Siemens OpenAir GMA 1 Series Manuale utente

Surecom

Surecom SR-629 Manuale utente

Fishman

Fishman TriplePlay Manuale utente

Regulus

Regulus SRS1 T Manuale utente

3M MicroTouch EX113 Manuale utente