April 2019
2
Quick Start Guide
NOTICE
This guide provides basic guidelines for the Rosemount 705 Transmitter. It does not provide instructions for
detailed configuration, diagnostics, maintenance, service, troubleshooting, or installations. Refer to the
Rosemount 705 Reference Manual for more instruction. This guide and the manual are available electronically
on Emerson.com/Rosemount.
Explosions could result in death or serious injury.
Installation of device in an explosive environment must be in accordance with appropriate local, national and
international standards, codes, and practices.
Ensure device is installed in accordance with intrinsically safe or non-incendive field practices.
Electrical shock can result in death or serious injury.
Ground device to prevent electrostatic charge build-up. Care must be taken during transportation of power
module to prevent electrostatic charge build-up.
Device must be installed to ensure a minimum antenna separation distance of 8-in. (20 cm) from all persons.
Process leaks could result in death or serious injury.
Handle the transmitter carefully.
Failure to follow safe installation guidelines could result in death or serious injury.
Only qualified personnel should install the equipment.
NOTICE
Shipping considerations for wireless products:
The unit was shipped without the power module installed. Remove the power module prior to shipping the
unit.
Each power module contains two “C” size primary lithium batteries. Primary lithium batteries are regulated in
transportation by the U.S. Department of Transportation, and are also covered by IATA (International Air
Transport Association), ICAO (International Civil Aviation Organization), and ARD (European Ground
Transportation of Dangerous Goods). It is the responsibility of the shipper to ensure compliance with these or
any other local requirements. Consult current regulations and requirements before shipping.
Contents
Seal and protect threads . . . . . . . . . . . . . . . . . . . 3
Mount transmitter on a turbine meter or pulse
output device . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Connect to device . . . . . . . . . . . . . . . . . . . . . . . . 9
Configure k-factor (calibration factor) for pulse
output device or turbine meter . . . . . . . . . . . 10
Product Certifications . . . . . . . . . . . . . . . . . . . 11
00825-0200-4705_RevDA.fm Page 2 Tuesday, April 2, 2019 11:08 AM
