Entone URC 4 Manuale utente

entone Universal Remote Control URC User Guide

http://www.manuallib.com/file/2591295

From ManualLib.com

ManualLib.com collects and classifies the global product

instrunction manuals to help users access anytime and

anywhere, helping users make better use of products.

Home: http://www.manuallib.com/ Chinese: http://www.shuomingshuku.com/

This Manual: http://www.manuallib.com/file/2591295

v2.5forURC4

Universal Remote Control

URC 

User’sGuide(NorthAmericaEdition)

This Manual: http://www.manuallib.com/file/2591295

v2.5for URC4

information protected by copyright. No part of this p blication may be reprod ced,

stored in a retrieval system, or transmitted in any form or by any means,

electronic, mechanical, photocopying, recording or otherwise, witho t the prior

written consent of Entone, Inc., 20863 Stevens, Creek Blvd, S ite 300, C pertino,

CA 95014, U.S.A.

DISCLAIMER

IF THIS PRODUCT DIRECTS YOU TO COPY MATERIALS, YOU MUST HAVE

PERMISSION FROM THE COPYRIGHT OWNER OF THE MATERIALS TO AVOID

VIOLATING THE LAW WHICH COULD RESULT IN DAMAGES OR OTHER REMEDIES.

TRADEMARKS

Entone and the tagline “Connecting the Home” are trademarks of Entone, Inc. All

other trademarks or registered trademarks belong to their respective owners.

CHANGES

The material in this doc ment is for information only and is s bject to change

witho t notice. While reasonable efforts have been made in the preparation of this

doc ment to ass re its acc racy, Entone, Inc. ass mes no liability res lting from

the se of the information contained herein.

Entone, Inc. reserves the right to make changes in the prod ct design witho t

reservation and witho t notification to its sers.

P/N: 99-98xx10-00

CUSTOMER SUPPORT AND CONTACT INFORMATION

For Customer Support please call: 650.572.7000

C stomer Contact Information:

Entone, Inc.

20863 Stevens, Creek Blv

Suite 300,

Cupertino, CA 95014

U.S.A.

Tel: 650.572.7000

www.entone.com

This Manual: http://www.manuallib.com/file/2591295





2011

v2.5 for URC 4

Table of Contents

Declaration of Conformity................................................................................................................................................3

1.1

Introduction...........................................................................................................................................................4

Loading Batteries......................................................................................................................................................4

2.1

Control using RF URC..........................................................................................................................................5

RAP Installation (in remote room).............................................................................................................................6

Connecting STB to the TV coax network..................................................................................................................7

Janus without Tuner Connection...............................................................................................................................7

Janus with Tuner Connection....................................................................................................................................7

Amulet F1 Connection...............................................................................................................................................7

RF URC Registration ................................................................................................................................................8

3.1

Control using IR URC...........................................................................................................................................9

IR Reception Range................................................................................................................................................10

4.1

Controlling Your Television and other A/V Devices............................................................................................11

To Program aTV or AUX device.............................................................................................................................12

Toggle Power Key Punch-through Functionality.....................................................................................................12

Toggle Volume Key Punch-through Functionality...................................................................................................12

Auto Search Procedures.........................................................................................................................................13

Appendix A – Device Code............................................................................................................................................14

Appendix B – Other Features........................................................................................................................................24

Showing URC 4 Firmware Version.........................................................................................................................24

Showing Programmed Device Code.......................................................................................................................24

This Manual: http://www.manuallib.com/file/2591295

URC4 User’sGuide



v2.5 for URC 4

Declaration of

Conformity

The manufacturer is not responsible for any radio or TV interference caused by unauthorized

modifications to this equipment. Such modifications could void the user’s authority to operate

the equipment.

This Manual: http://www.manuallib.com/file/2591295

URC4 User’sGuide



v2.5 for URC 4

Chapter

1.1 Introduction

The Entone Universal Remote Control v4.x (URC 4) is designed to work either on Radio Signals (RF) or InfraRed (IR).

It can control Janus Media Hub using RF from another room where is not at direct sight distance from the Janus. Or, it

can use IR to control Amulet High Definition IP Television Receiver at direct sight distance. The URC 4 can also be

used to control other A/V devices such as TV, DVD player and audio equipment using IR. There are two types of

Entone URC 4: IR only (IR URC) and IR+RF (RF URC). IR URC is included in the package of Janus/Amulet while RF

URC is included in Entone Second Stream Kit.

Loading Batteries

The URC 4 comes with AA-size batteries, which need to be installed when you first receive your system. When

you replace old batteries, you should replace all of the batteries. Use batteries of the same kind, for example

alkalineor carbonzinc, and donot mix batteries of different kinds. Alkaline batteries last longer than carbon zinc.

Warning: Mixing old and new batteries or different types of batteries poses a fire hazard.

To load batteries to URC 4:

1. Press down on the batterycover’s top latch and slide the cover off.

2. If you are changing out batteries, take out all of the old batteries.

3. Put the new batteries in. Make sure you matchthe plus ( “+” ) ends withthe plus markings onthe battery

case.

4. Slide thecover back into place.

Figure 1-1 Loading Batteries to URC 4

This Manual: http://www.manuallib.com/file/2591295

URC4 User’sGuide



v2.5 for URC 4

Chapter

2.1 Controlling STB using F U C

Janus is a multi-television media hub. It can support multiple outputs in multiple rooms viewing different

channels or TV programs. Amulet is a single output video receiver. You can connect Amulet to a primary

output only.

You can use RF URC 4 to control Janus/Amulet using radio signals (RF).These radiosignals travel over

long distances and go though walls and other solid objects. You must connect the Remote Antenna

Package (RAP) to the rear panel of theJanus/Amulet.

Your Janus/Amulet comes with one IR URC 4 to be used for output 1 (primary). (Additional RF URC 4 can

be purchased separately.) Your RF URC 4 must be registered to one of the 2 outputs(primary or

secondary) before it can be used. One RF URC 4 can only be registered to one output. However, you can

to control the outputs.

Figure 2-1 Controlling STB using RF URC 4

This Manual: http://www.manuallib.com/file/2591295

URC4 User’sGuide



v2.5 for URC 4

Here are some principles of the remote registration method:

Each output allows a maximum of 3RF URC 4 to be registered and a registration list is maintained. If

the user has registered 3 RF URC 4 and tries to register another RF URC 4, thefirst registered RF

URC 4 will be removed from the registration list. This works as a first-in-first-out fashion.

Each RF URC 4 can only be registered for one output. If user tries to register a RF URC 4 which is

already registered to another output, that remote registration will be removed from the original

registration list.

The registration list is maintained in order. If the secondly registered RF URC 4 is removed from the list,

the third entry will move forthtothe second andthe third will be blank for a new RF URC 4 to be

registered.

You must install the Remote Antenna Package (RAP) comes with Entone Second Stream Kit beforedoing

the registration. Please refer to the following sections forinstalling the RAP.

AP Installation (in remote room)

Please follow the following diagram to install the RAP. The RAP is used to enhance the URC radio

frequency transmission using the TV coax cable network in your home.

1 Plug the RAP into the TV.

2 Connect the TV coax cable tothe RAP and the TV coaxnetwork wall outlet.

Figure 2-2 Attaching Remote Antenna Package

NOTE: Don’t let the antenna touch anything.

ATTENTION: If your URC 4 isn’t working very wellfrom far away, you maybe experiencing interference

fromobjectsnear your receiver. Toimprove your URC 4’s reception range, tryto adjust the antenna

orientation using screwdriver as shown. You may need to trydifferent antenna orientation to achieve the

best reception.

Figure 2- Adjusting Antenna Orientation

This Manual: http://www.manuallib.com/file/2591295

URC4 User’sGuide



v2.5 for URC 4

Connecting STB to the TV coax network

Connect the Entone STB to the TV coax network wall outlet according to whether you are using an Entone

Janus or Amulet STB. The rear panel of actual product may vary.

1. Janus without Tuner Connection: Connect the Janus “MATV” or “TV OUT” output to the TV coax

network as shown.

Figure 2-4 Connecting Janus without Tuner

2. Janus with Tuner Connection: Connect the Janus “MATV” or “TV OUT” and “RF IN” or “CABLE/ANT

IN” output to the TV coax network as shown using a 3-way splitter (which is not provided).

Figure 2-5 Connecting Janus with Tuner

3. Amulet F1 Connection: Connectthe Amulet “REMOTE CONTROL” and “COAX” or”TV OUT” output to

the TV coax network as shown using a 3-waysplitter (which is not provided).

Figure 2-6 Connecting Amulet

This Manual: http://www.manuallib.com/file/2591295

URC4 User’sGuide



v2.5 for URC 4

F U C egistration

You mayneed to registerthe RF URC to the STB beforeyou can use the remote. TheRF URC registration

procedures mayvaryfor different middleware and TV service running in theEntone STB. Please referto

the TV service user guide for detailed RF URC registration procedures.

Below lists thegeneral RF URC registration procedures (NOTE: Referto your TV service user guide for

exact RF URC registration procedures):

1. Press and hold the “OK” button on the STB front panel for 5 seconds until the touch panel backlight is

flashing. The STB is now in URC registration mode.

Figure 2-5 Janus in Remote Registration Mode

NOTE: If registration is not completed in 30seconds, the touch panel backlight will stop flashing.

2. Press “STB” button once on the URC.

3. Press and hold the “STB” button on the URC for 5 seconds until the “STB” button backlight is on.

4. Press “STB” button once again. Boththe “STB” and “AUX” button backlight will illuminate.

5. Press “1” or “2”to register the URC to output 1 (primary) or output 2 (secondary) (depending on the

middleware).

Upon successfulregistration, the STB POWER indicator will flash once and thetouch panel backlight

will stop flashing.

NOTE:

The POWER key can beconfigured to controlboththe STB and TV while the URC 4 is in “STB” mode,

please refer to the section “Toggle Power Key Punch-through Functionality” in Chapter 4 for details.

The Volume +/- and MUTE key can be configured tocontrol boththe STB and TV while the URC 4 is in

“STB” mode, please refertothe section “Toggle Volume KeyPunch-through Functionality” in Chapter 4

for details.

This Manual: http://www.manuallib.com/file/2591295

Indice

Altri manuali Entone Telecomando

Entone

Entone URC plus Manuale utente

Entone

Entone Stylus Manuale utente

Entone

Entone v4 Series Manuale utente

Entone

Entone Nova Manuale utente

Entone

Entone URC 4 (US Edition) Manuale utente

Entone

Entone URC 4 (EMEA Edition) Manuale utente

Entone

Entone Hydra Manuale utente

Entone

Entone URC plus Manuale utente

Entone

Entone remote Manuale utente

Entone

Entone GVTV Manuale utente

Entone

Entone Nova Manuale utente

Entone

Entone 3 mode Manuale utente

Manuali Telecomando popolari di altre marche

Panasonic

Panasonic EUR7622KB0 Manuale utente

Bang & Olufsen

Bang & Olufsen Beo4 Manuale utente

Sunwave Tech.

Sunwave Tech. RemoteComm SRC-7000 Manuale utente

Multiplex

Multiplex PROFI TX 9 Manuale utente

One Remote

One Remote RMB4 Manuale utente

FUTABA

FUTABA 9ZAP - PART2 Manuale utente

HR Matic

HR Matic HR MULTI 3 Manuale utente

Yamaha

Yamaha ACC-GNRST-30-20 Manuale utente

EisSound

EisSound KBSOUND Manuale utente

Marantz

Marantz RC101 Manuale utente

Conrad

Conrad FS20 TC6 Manuale utente

Anritsu

Anritsu MP1777A Manuale utente

Niles

Niles WVC100 Guida alla risoluzione dei problemi

RCA

RCA RCU1300 Manuale utente

Bang & Olufsen

Bang & Olufsen BEO6 Manuale utente

GE 94901 Manuale utente

Onbon

Onbon YQ1-75 Manuale utente

FUTABA

FUTABA R7108SB Istruzioni per l'installazione