EPH Controls HRT Istruzioni operative

Installation and Operation Guide

Room Thermostat

HRT

Factory default settings

Specications

LCD Display

Buttons

Wiring

Mounting & installation

Replacing the batteries

Locking the Keypad / Backlight

Menu Function

On / O Function & Adjusting the target temperature

Table of contents

Installation Instructions

Operating Instructions

Delay Start Control (On/O)

PO 1 Operating Mode

Nor (Normal Mode)

Time Proportional Integral Mode (TPI)

PO 2 Setting High and Low limits

PO 3 Hysteresis HOn and HO

PO 4 Calibration

PO 5 Setback Mode

PO 6 Frost Protection

Resetting the Thermostat

Battery operated non-programmable Room Thermostat

Installation Instructions

2HRT

Factory default settings

Contacts: Volt Free

High and Low Temp. limitation: O

Keypad lock: O

Backlight: Auto

Setback: 0.0˚C (o)

Operating mode: Normal

EPH Controls Ltd.

Specications

Power supply / Input: 2 x AA Alkaline Batteries

Power consumption: Operating <0.05W

Standby <0.1mW

Temperature range: 5 … 35˚C

Ambient temperature: 0 … 45˚C

Ambient admissible humidity: 5-95%RH

Contact rating: 8A 230Vac

Dimensions: 85 x 85 x 36mm

Temperature sensor: NTC 100K

Backlight: White

IP rating: IP20

Pollution degree: 2

Switching dierential: Adjustable from 0.0 – 1.0°C

0.1°C increments

Automatic action: 1C

4HRT

[1] [2]

[7]

[3]

[4][5]

[6]

[1] Shows the current / target temperature.

[2] Displayed when batteries need to be replaced.

[3] If the keypad is locked, the lock symbol is displayed.

[4] When the thermostat is calling for heat, the ame

symbol is displayed.

[5] When a high or low temperature limit is set, ‘LIM’ is displayed.

[6] Displayed when setback is enabled.

[7] Displayed when delay start is enabled.

LCD Display

EPH Controls Ltd.

Buttons

Handwheel

Reset

Button

Standby Button

6HRT

Wiring

321

COM

230V on Terminal 1: Thermostat works in Normal mode

0V on Terminal 1: Thermostat works in Setback mode

Terminal Connections

Terminal 1 Setback

Terminal 2 Common

Terminal 3 On

EPH Controls Ltd.

Mounting & Installation

Caution!

Installation and connection should only be carried out by a qualied person.

Only qualied electricians or authorised service sta are permitted to open the

thermostat.

If the thermostat is used in a way not specied by the manufacturer, its safety may be

impaired.

Prior to setting the thermostat, it is necessary to complete all required settings

described in this section.

Before commencing installation, the thermostat must be rst disconnected from the

mains.

This thermostat can be mounted in the following ways:

1) Directly mounted on wall

2) To a recessed conduit box

8HRT

1) Remove the thermostat from its packaging.

2) Choose a mounting location so that the thermostat can measure

the room temperature as accurately as possible.

- Mount the thermostat 1.5 metres above the oor level.

- Prevent direct exposure to sunlight or other heating / cooling

sources.

3) To open the front housing

a) use a philips screwdriver to loosen the screw on the bottom

right of the thermostat.

b) insert and rotate a 3.5mm at screwdriver into the slot on

the bottom left.

4) Wire the thermostat according to the wiring diagram on page 6.

5) Screw the backplate onto a back box or directly to the surface.

6) Close the front housing and tighten the screw on the bottom of

the thermostat.

Mounting & Installation Continued

Altri manuali per HRT

Indice

Altri manuali EPH Controls Termostato

EPH Controls

EPH Controls CP4M Manuale utente

EPH Controls

EPH Controls R37 Manuale utente

EPH Controls

EPH Controls CDT2-24 Manuale utente

EPH Controls

EPH Controls CRT2 Manuale utente

EPH Controls

EPH Controls TRFPi2 Manuale utente

EPH Controls

EPH Controls RFRB Manuale utente

EPH Controls

EPH Controls RFRP-HW-OT Manuale utente

EPH Controls

EPH Controls T37-RFi Manuale utente

EPH Controls

EPH Controls RDTP Istruzioni operative

EPH Controls

EPH Controls RFRP-OT Manuale utente

EPH Controls

EPH Controls EDBS Istruzioni operative

EPH Controls

EPH Controls RFC Manuale utente

EPH Controls

EPH Controls CDTP2 Manuale utente

EPH Controls

EPH Controls CDC2 Istruzioni operative

EPH Controls

EPH Controls HDT Istruzioni operative

EPH Controls

EPH Controls RFRP Manuale utente

EPH Controls

EPH Controls CP4M Istruzioni operative

EPH Controls

EPH Controls T27-RFi Manuale utente

EPH Controls

EPH Controls HRT Istruzioni operative

EPH Controls

EPH Controls CP4B Istruzioni operative

EPH Controls

EPH Controls curve crtp Manuale utente

EPH Controls

EPH Controls RDT Istruzioni operative

EPH Controls

EPH Controls RFCA-RF Manuale utente

EPH Controls

EPH Controls CRTP2 Istruzioni operative

Manuali Termostato popolari di altre marche

EWELLY

EWELLY EW-181 Manuale utente

Prolon

Prolon T1100 Istruzioni per l'installazione

Computherm

Computherm Q20 Manuale utente

Heatmiser

Heatmiser neoStat Manuale utente

Aube Technologies

Aube Technologies TH111GFCI-NP 240 VCA Manuale utente

Mars

Mars HEAT CONTROLLER IR Wireless Thermostat Manuale utente

Saswell

Saswell SAS920XWHB-7-S-RF Guida

Aircalo

Aircalo TFP1-ET85P2 Manuale utente

Honeywell

Honeywell CM721 Manuale utente

Carrier

Carrier DEBONAIR 33CS Manuale utente

Lennox

Lennox iHarmony Zone Thermostat Istruzioni per il montaggio

Gemtech

Gemtech GT7000 Manuale di istruzioni

Rollei

Rollei Smartes 45000 Manuale utente

Sinope

Sinope TH1300RF Manuale utente

Honeywell

Honeywell RLV4305 Manuale utente

Honeywell

Honeywell Prestige 2.0 THX9421 Manuale utente

NuTone

NuTone NTBZ48 Istruzioni operative originali

Stelpro

Stelpro MAESTRO ASMT402AD Manuale utente