Epson ActionLaser 1000 Manuale utente

EPSON

Connect Your Macintosh

Computer

to Epson Laser Printers

Installation Guide for

ActionLaser™ 1000

ActionLaser 1500

EPL-8000

CPD-1310

Epson

Talk

™

Connect Your Macintosh®Computer to Epson Laser Printers

Epson Talk allows you to use an Epson printer with your

Macintosh computer. Use this Installation Guide to install

Epson Talk quickly. If you require further details, please read

the manuals enclosed, Epson Interface Card for LocalTalk™

C823121 and

Epson PostScript™

Card C826091 User’s Guide,

along with your printer manual.

What You Need for Installation

A minimum of 2.0 MB RAM printer memory

LocalTalk cable (not included)

Interface Card for LocalTalk (C823121)

PostScript Card (C826091)

A cross-head screwdriver

An ActionLaser™ 1000, an ActionLaser 1500, or an EPL-8000

Before You Install Epson Talk

Use your printer’s Setup and Maintenance guide to set up and

test your new printer. Go only as far as test printing; you will

use the procedures in this guide to connect the Macintosh.

Once

you

see that your printer operates properly, install Epson

Talk as described below.

Installing the Interface Card

Make sure that both the printer and computer are turned off

and that all power and interface cables are removed from

the printer.

Caution:

Avoid touching the printer circuits or card circuit board

contacts. Otherwise, you may damage them.

Turn your printer so that its interface cover or shield plate

faces you.

3. Use a screwdriver to remove the screws securing the cover or

shield plate; then lift it off.

ActionLaser 1000/1500 EPL-8000

4. Slide the interface board into the grooves in the interface slot.

Push it in firmly to make sure it connects to the printer’s

internal socket.

ActionLaser 1000/1500

EPL-8000

Secure the interface with the two screws provided with

the card.

Attach your LocalTalk cable to the LocalTalk port (indicated

by the

icon) on the interface card. (Do not use the serial

port.) Then plug the other end of the cable into your

computer.

Plug the power cord into your printer and an electrical outlet.

Installing the PostScript Card

Caution:

Do not insert the card while the printer is turned on.

Do not touch the gold connectors along the card’s edge.

Do not use too muchforce when you insert and remove the

card. Otherwise, you may damage it.

Make sure the printer is turned off.

Hold the card so that the arrow on the card is aligned with

the arrow on slot A. (Do not use slot B.)

ActionLaser 1000/1500 EPL-8000

Gently but firmly slide the card into the slot as far is it can go.

4. Turn on the printer and computer.

Selecting PostScript

You need to change the emulation or mode setting through

SelecType before you can use PostScript.

The SelecType instructions below enable you to assign

PostScript quickly. If you need more detailed instructions on

using SelecType, see your printer manual

Note:

Be sure to install the interface and PostScript cards first. Otherwise,

the PostScript emulation or mode aloes not appear as a SelecType

option on the printer display.

For the ActionLaser 1000 and 1500

Press the

ON LINE

button to take the printer off line.

Press the

SelecType Level 2

button.

Press Vuntil EMULATION appears on the display.

4. Press

Press Vuntil CH O appears.

6. Press

Press Vuntil PS appears.

Press

to set the PS emulation.

9. Press the

EXIT

button twice to return to the READY message.

Note:

The READY message may not show O PS (indicating the

optional interface and PostScript) until after yourfirst print job

is sent from your computer to the printer each time you turn on

your printer.

10. Make sure that AppleTalk is active in the Chooser under the

Apple menu on your Macintosh.

11. Click LaserWriter in the Chooser menu. The name of your

printer appears in the Select a LaserWriter box. Click on the

name of your printer and then close the Chooser.

Note:

If the

LaserWriter printer driver is not yet installed on your

computer, you can find it on one

your Macintosh System disks.

Follow your computer manual instructions to install it on your

Macintosh.

12. begin printing using your application software.

For the EPL-8000

Note:

you have an Epson EPL-8000 printer, you must have aj%mware

version 22.48 or later to use Epson Talk. To find out your printer’s

firmware version, print a status sheet as described in your printer

manual. If you do not have the above firmware version, please call the

Epson Connection at (800) 922-8911.

Press the

ON LINE

button to take the printer off line.

Hold down the

SelecType

button until the

Level 2 light

comes on.

Press

until MODE ASSIGN appears on the display.

Press buntil CH P appears.

Press

until CH O appears.

6. Press

Press

until CH O PS appears.

8. Press

to set the PS setting.

Press

to return to MODE ASSIGN.

10. Press

until P-CONFIG.SAVE appears.

11. Press

twice to save

the CH

PS setting.

12. Press

twice to return to the READY message.

13.

Press the

ON LINE

button.

Note:

The READY message may not show O PS (indicating the

optional interface and

PostScript)

until after your first

job

is sent from your computer to the printer each time you turn on

your

printer.

14. Make sure that AppleTalk is active in the Chooser under the

Apple menu on your Macintosh.

15. Click LaserWriter in the Chooser menu. EPL-8000 appears

in the Select a LaserWriter box. Click on EPL-8000 and then

close the Chooser.

Note:

the LaserWriter printer

driver is not yet installed on your

computer, you can find it on one of your Macintosh System disks.

Use

your computer manual instructions

to install

if on your

Macintosh.

16. Begin printing using your application software.

Altri manuali per ActionLaser 1000

Questo manuale è adatto per i seguenti modelli

Indice

Altri manuali Epson Stampante

Epson

Epson DFX-5000+ Manuale utente

Epson

Epson SureColor P800 Manuale utente

Epson

Epson TM-T20 Manuale utente

Epson

Epson Stylus Pro 9000 - Print Engine Manuale utente

Epson

Epson AcuLaser C9300N Manuale utente

Epson

Epson SC-F2000 Series Manuale utente

Epson

Epson Color Printer Manuale utente

Epson

Epson EPI-4000 Manuale utente

Epson

Epson XP-3200 Series Manuale utente

Epson

Epson Stylus Pro 10000 Series Manuale utente

Epson

Epson U295P - TM - Receipt Printer Manuale utente

Epson

Epson L575 Manuale utente

Epson

Epson Stylus Photo PX720WD Guida utente

Epson

Epson AL-M8200 Series Manuale utente

Epson

Epson 7800 - Stylus Pro Color Inkjet Printer Manuale utente

Epson

Epson Stylus 10000 Series Manuale utente

Epson

Epson Stylus Pro 7880 ColorBurst Edition - Stylus Pro 7880... Manuale utente

Epson

Epson 4012364-00 Manuale utente

Epson

Epson L1300 Manuale di istruzioni

Epson

Epson Disc Producer PP-100AP Manuale utente

Epson

Epson NT-II30m-T Manuale utente

Epson

Epson Stylus C42 Series Manuale utente

Epson

Epson SecurColor TM-C3400 Manuale utente

Epson

Epson TM-T88II Series Manuale utente

Manuali Stampante popolari di altre marche

Lexmark

Lexmark 1400 Series Manuale

Canon

Canon i70 Series Manuale utente

Evolis

Evolis Elypso Manuale utente

Kyocera

Kyocera FS-9530DN Manuale utente

Canon

Canon LASER SHOT LBP-1210 Manuale utente

Samsung

Samsung BIXOLON SRP-350plusF Manuale utente

Canon

Canon PIXMA PRO-1 Series Manuale utente

Canon

Canon PIXMA G3560 Guida all'installazione

Dell

Dell Color Laser Printer 2130cn Manuale utente

Tektronix

Tektronix Phaser 840 Manuale utente

Canon

Canon CLBR 460ps Manuale utente

Eltron

Eltron P210 Guide Manuale utente

Ricoh

Ricoh MD-P1 Manuale utente

Canon

Canon imagePASS-A2 Manuale utente

Canon

Canon S820D Manuale utente

IRA3D

IRA3D POETRY4 Manuale utente

Ricoh

Ricoh Aficio AP400 Manuale utente

BIXOLON

BIXOLON SRP-352plusV Manuale utente