5
2.4 Maintenance and Repair
-If an incident occurs such that repairs to the workbench must be made, always remove the
battery from the docking unit under the benchtop first, or else remove the electrical plug
from the wall socket (depending on whether the workbench is mains-powered or battery-
operated).
-Ljunggren & daughters’product liability is extends only to products that were defective
coming from the factory. Ljunggren & daughters’product liability will be disclaimed in part or
in whole if the user does not follow the care instructions or uses spare parts that are not
original.
For each repair, there is a written set of instructions available in order to minimise the risk of
error; request such instructions when you order the spare parts and read them thoroughly
before you begin effecting repairs.
In order for a product warranty to be valid following a repair, the following conditions apply:
- Only original parts may be used when making repairs.
- No modifications may be made to the products, lifting column, battery, docking unit, battery
charger, ECU or control panel.
- Repairs shall be made according to the enclosed instructions.
- Following the repair, the workbench must continue to be used only in accordance with the
specified data.
3Operator’s Manual
3.1 Function of the System
Ljunggren & daughters adjustable-height Limbo workbench consists of a bottom chassis with
four wheels, a mechanical lifting mechanism and an upper chassis, as well as a benchtop and
control panel. The benchtop can be raised or lowered by means of the two buttons on the
control panel. The benchtop is pushed upward and pulled downward by a 3-piece telescoping
lifting column.
All four wheels are pivoted, which allows the workbench to be easily steered in the direction the
operator wishes. However, each wheel can also be locked in brake mode for stationary work.
The workbench is operated either by 230-volt mains power or by 24-volt battery.
The battery is charged separately using the included charger, which in turn is connected to a
230 V power supply. Once the battery is charged, it is moved and connected to the docking unit
under the benchtop.
The system is not intended for continuous operation!
3.2 Operation
The height of the workbench is adjusted using the upward arrow for up and the downward arrow
for down. Adjust the workbench to the working height offering the best working ergonomics for
the moment, then when loading or unloading goods, set it to the height that offers the best
ergonomics for that purpose.
