Ergotron StyleView Manuale utente
1
5
6
2
3
4
1
5
2
3
4
14mm
10mm
20"
(508 mm)
5"
(127 mm)
12˚
25˚
+12˚
STYLEVIEW®
QUICK REFERENCE
For more information on this or other Ergotron products, visit our website: www.ergotron.com
EN
777-24-006-G-00 rev.A • 08/10
ERGONOMICS
RANGE OF MOTION
Working
customize - to your size
1 Set top of monitor screen about one inch below eye level - Release brake
and lift or lower riser as needed.
2 Tilt screen for comfortable viewing and to reduce eye and neck strain.
3 Pull keyboard tray forward and position mouse tray and mouse pouch on
right or left, as needed.
4 Work with elbows bent at about 90° to minimize muscle strain.
5 If the riser moves up and down with diculty, or if it drifts out of set
position, consult the product
manual for adjustment
information.
6 Stay in charge!
Powered carts should be
plugged into outlet as often as
possible to keep battery charged
and computer running.
Moving
stow - before you go
1 During normal movement, release brake and lower worksurface to
lowest position for optimal stability and unobstructed view.
2 Tuck away open trays and return mouse, scanner and other
accessories to their places.
3 Unlock both front casters.
4 Push cart from rear with elbows bent at about 90° to maximize
control and minimize muscle strain.
5 Don’t run out!
Before moving, make
sure cord is unplugged
from outlet and hooked
to basket for safe travel.
Remember, charge
battery fully 100%
every day!
It is important that you adjust this product according to the weight of the mounted equipment as described in
the following steps. Any time equipment is added or removed from this product, resulting in a change in the weight of the mounted load, you should repeat
these adjustment steps to ensure safe and optimum operation. Adjustments should move smoothly and easily through the full range of motion and stay
where you set it. If adjustments are dicult and do not stay in the desired position, follow the instructions to loosen or tighten the tension to create a smooth,
easy adjustment motion. Depending on your product and the adjustment, it may take several turns to notice a dierence.
NOTE: Adjustment may require
40 - 60 revolutions.
STYLEVIEW®
QUICK REFERENCE
For more information on this or other Ergotron products, visit our website: www.ergotron.com
EN
777-24-006-G-00 rev.A • 08/10
READY ON
The Ready On button is located on the side of the enclosure.
Pressing this button will wake up your computer from
hibernate or power o. Setting your equipment to hibernate as
soon as possible is recommended to save battery charge. Your
computer must be hooked up via ethernet connection to the
Ready On ethernet port inside the eclosure.
KEYBOARD LIGHT
NOTE: Frequent operation of the cart while battery charge levels are
below 30% will signicantly reduce the life of your battery.
This power system interface will alert you to the percentage of charge
remaining in the cart battery with a series of steady or ashing red, yellow
or green lights, and an alarm that will beep when charge gets below 50%.
Remember, the battery needs to be charged to 100% every day, and you
can use the cart while charging, so plug-in cord as often as possible to
avoid running out of power!
NOTE: Put monitor in power save mode to optimize battery run time.
Do Not stretch coiled cord
further than 8 feet (2.5
meters), damage to the cord
may occur.
POWER SYSTEM
Battery has 100% charge.
Light flashes when charging (power cord plugged
into wall outlet) Allow battery to continue charging
until light stops flashing.After light stops flashing,
it is OK to unplug the power cord from the wall.You
can use cart while charging.
Battery has less than 90% charge.
Battery has less than 70% charge.
Battery has less than 50% charge. Light is yellow
and alarm beeps. Plug-in power cord and charge to
100%! You can use cart while charging.
Battery has less than 30% charge. Light is red and
alarm beeps. Plug-in power cord and charge to
100%! You can use cart while charging.
Alarm Mute button. Pressing this will temporarily
mute alarm.
Power button for internal power system outlets.
Pressing this will provide or remove power to/from
components plugged into the internal outlets.
When lit, the power system is
on.When dark, power system
is off.
Altri manuali per StyleView
14
Altri manuali Ergotron Scrivania
Ergotron
Ergotron StyleView Manuale utente
Ergotron
Ergotron WorkFit-P Manuale utente
Ergotron
Ergotron Command Post Manuale utente
Ergotron
Ergotron 48 Unit Management Cart Manuale utente
Ergotron
Ergotron Steve's Station Advanced Manuale utente
Ergotron
Ergotron STYLEVIEW Series Manuale utente
Ergotron
Ergotron 97-583-009 Manuale utente
Ergotron
Ergotron StyleView VL Enclosure Guida alla risoluzione dei problemi
Ergotron
Ergotron Desktop 16 Manuale utente
Ergotron
Ergotron WorkFit-P Manuale utente
Ergotron
Ergotron WorkFit-P Manuale utente
Ergotron
Ergotron StyleView Manuale utente
Ergotron
Ergotron WorkFit-P Manuale utente
Ergotron
Ergotron WorkFit-Z mini Manuale utente
Ergotron
Ergotron WorkFit-S Manuale utente
Ergotron
Ergotron WORKFIT Manuale utente
Ergotron
Ergotron StyleView Manuale utente
Ergotron
Ergotron WorkFit-S Manuale utente
Ergotron
Ergotron WorkFit-A, Single LCD Mount, LD Manuale utente
Ergotron
Ergotron TeachWell Mobile Digital WorkSpace Manuale utente
