ES4710.1
ES4710_SAV, R02, 2019.10.29
Item number F-00K-800-091
General Safety at Work
The existing regulations for safety at work and accident prevention must be followed. When using these products, all
applicable regulations and laws concerning their operation must be observed.
For damages resulting from improper operation or unintended use, the companies of the ETAS Group or their
representatives do not assume any liability.
Requirements for Users and Duties for Operators
Only install, operate and maintain the products if you have the required qualifications for and experience with them.
Incorrect operation or operation by users without sufficient qualifications may lead to injuries, death or property
damage.
The system integrator is responsible for the safety of systems that use the products.
Intended Use
ES4710.1
The ES4710.1 module was developed to meet the main requirements of CE conformity for Hardware-in-the-Loop (HiL)
test systems. Its task is to protect users against electric shocks and fire due to a short circuit or overload.
The ES4710.1 module is designed as a built-in device for ETAS HiL systems (LABCAR) and must therefore always be
installed in an HiL rack system or a comparable system. It must not be operated as a standalone system/component.
The rack system (or the comparable system) must have a protection class of IP20 or higher.
Intended Purpose
The intended use of the product is as follows:
tch/emergency off/emergency stop, shutdown in case of overtemperature
(additional temperature sensor required)) for an HiL system
oftware that supports the ES4710.1 module
of ETAS software products
If the ES4710.1 module is used for a purpose other than those mentioned above, ETAS shall not be liable in any way for
possible injury or damage that occurs.
Incorrect Usage, Misuse
The ES4710.1 module must be connected directly to the main power supply with no additional components positioned in
between. The ES4710.1 module must not be connected via another device to the power supply.
The protective ground conductor of the main power supply line must not be disconnected or removed.
The product is not intended for the following applications or cases:
-road vehicles
conditions section
below and see chapter "Technical Data" of the use manual)
Requirements for the Technical State of the Product
The product is designed in accordance with state-of-the-art technology and complies with recognized safety regulations.
The product must only be operated in a technically perfect condition and in accordance with the relevant documentation.
Requirements for Operation
are
used in any other way, product safety is no longer ensured.
Electrical Safety and Power Supply
Observe the regulations applicable at the operating location concerning electrical safety as well as the laws and
regulations concerning work safety!
