EUFY eufyCam E330 Manuale utente
QUICK START
GUIDE
E330 eufyCam (Professional)
Anker Innovations Limited. All rights reserved. eufy Security and eufy Security Logo are
trademarks of Anker Innovations Limited, registered in the United States and other
countries. All other trademarks are the property of their respective owners.
51005004021 V1
KURZANLEITUNG
GUÍA DE INICIO RÁPIDO
GUIDE DE DÉMARRAGE RAPIDE
GUIDA RAPIDA
SNELSTARTGIDS
GUIA DE INÍCIO RÁPIDO
EN 01
AT A GLANCE
①
④
⑤
⑥
⑦
⑧
⑨
②
③
①Status LED
②Reset Hole
③Speaker
④Hard Drive Bracket
⑤SYNC / ALARM OFF Button
⑥USB Port 1 (Output: 5Vdc/2.4A)
⑦USB Port 2 (Output: 5Vdc/0.7A)
⑧Ethernet Port
⑨Power Port
Model: T8030
S380 HomeBase
English 01
Deutsch 19
Español 35
Français 51
Italiano 67
Nederlands 83
Português 99
115
EN 0302 EN
INSTALLING YOUR
STORAGE DRIVE (Optional)
⚠
• The S380 HomeBase must be powered off when you install or
remove a storage drive.
• To avoid data loss, transfer any existing data on your storage drive
to another location before adding your storage drive to The S380
HomeBase.
1. Push down the top lid to remove it.
(For 4-Cam Kit) The S380 HomeBase comes with a pre-
installed 1TB storage drive for storing video recordings.
(For 2-Cam Kit) You need to install a storage drive (not
included) to store video recordings.
E330 eufyCam (Professional)
①
②
③
④⑤⑥
⑦
⑧
SYNC
Ensure Tight Seal
SD Card SYNC
①Camera Lens
②Spotlight
③LED Indicator
④Micro USB Port (for maintenance only)
⑤microSD Card Slot
⑥SYNC Button
⑦Mounting Bracket
⑧Angle Adjustment Knob
Model: T8600
EN 0504 EN
4. Insert and screw the bracket back into the S380 HomeBase, then put
the top lid back into place.
Your additional storage drive must meet the following
requirements:
Type Hard disk drive (HDD) or solid-state drive (SSD)
that uses the SATA interface
Drive Size 2.5 inch
Capacity Unlimited
Recommended Western Digital, Seagate, SAMSUNG, Kingston,
PNY, Crucial, SanDisk
2. Unscrew and take out the storage drive bracket.
3. Fix your storage drive to the bracket with the included screws.
HARD DRIVE
EN 0706 EN
3. Download and install the eufy Security app, then sign in or create an
account.
4. Follow the in-app instructions to add the S380 HomeBase and
cameras to the device list.
≤3.3 ft (1 m)
SETTING UP THE SYSTEM
1. Power on the S380 HomeBase and connect to your router using an
Ethernet cable. Wait for up to 1 minute and the S380 HomeBase is now
ready to be set up.
2. Connect your cameras to power using their power adapters.
EN 0908 EN
⚠Disconnect the camera from the power outlet before mounting.
We recommend mounting the camera 7-10 ft (2-3 m) above the
ground. This height maximizes the detection range of the camera.
• The camera can be mounted both indoors and outdoors. Avoid
mounting the camera under direct sunlight.
Camera
Field-of-View
Up to 33 ft (10 m)
7-10 ft
(2 - 3 m)
MOUNTING YOUR CAMERA
Select a Location and a Height
Select a location that is within reach of a power outlet. If the distance
exceeds 16.4 ft (5 m), please consider a separately sold extension
cable.
≤16.4 ft (5 m)
Make sure the camera receives a strong signal from the S380
HomeBase in the location you want to mount it to achieve a smooth
video stream in the app.
EN 1110 EN
2. Route the power cable into the waterproof case and connect it to
the power adaptor, then plug the adaptor into the power outlet.
Mount the Camera
1. Use the position template to drill holes with correct spacing, then
mount the camera using the provided screws.
• Screw anchors are necessary for walls that are made out of hard
materials such as concrete, brick, or stucco.
EN 1312 EN
4. Fasten the cable to the wall using the included cable clips if needed.3. Rotate the camera to adjust the view and check it using the live
stream, which you can access in the eufy Security app.
10~25°
(Optimal)
EN 1514 EN
SAFETY
• The suitable temperature range for E330 eufyCam (Professional) and
accessories is -20°C to 45°C (-4°F - 113°F). The suitable temperature
range for S380 HomeBase and accessories is -10°C to 45°C (14°F
- 113°F). The recommended temperature range for devices and
accessories is 5°C to 25°C (41°F - 77°F).
• Unless specifically indicated that it is safe to do so in the user guide
or instruction manual, do not use this device in an environment that
exceeds the recommended low or high temperature.
• Unless specifically indicated that it is safe to do so in the user guide
or instruction manual, avoid exposing your device to direct sunlight
or wet environments.
• The power adapter should be installed near the equipment and
should be easily accessible.
• Use only a power adapter supplied by or approved by the
manufacturer. Using an unauthorized power adapter may cause
danger and may violate the authorization of the device to receive
service under warranty.
• The power adapter is for indoor use only. The plug is considered as a
disconnect device of the adapter.
Warning:
– Replacing a battery with an incorrect type may bypass safeguards
and create danger;
– Disposal of a battery in a fire or other source of significant heat, or
by crushing, or cutting, may result in an explosion as well as leakage of
flammable liquids and gases;
– Leaving a battery in an extremely hot environment may result in an
explosion as well as leakage of flammable liquids and gases;
– A battery subjected to extremely low air pressure may result in an
explosion as well as leakage of flammable liquids and gases.
CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN
INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO
THE INSTRUCTIONS.
CAUTION: LITHIUM COIN CELL BATTERY. KEEP BATTERIES AWAY
FROM CHILDREN. IF SWALLOWED OR PLACED INSIDE THE BODY,
BATTERIES CAN CAUSE SEVERE OR FATAL INJURIES IN 2 HOURS
OR LESS, SEEK IMMEDIATE MEDICAL CARE IF SUSPECTED.
NOTICE
NOTICE (United States of America)
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to
operate the equipment.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: (1) Reorient
or relocate the receiving antenna. (2) Increase the separation between
the equipment and receiver. (3) Connect the equipment into an outlet
on a circuit different from that to which the receiver is connected. (4)
Consult the dealer or an experienced radio/TV technician for help.
FCC Radio Frequency Exposure Statement
The device has been evaluated to meet general RF exposure
requirements. The device can be used in fixed/mobile exposure
condition. The min separation distance is 20cm.
Notice: Shielded cables
All connections to other computing devices must be made using
shielded cables to maintain compliance with FCC regulations.
The following importer is the responsible party
Company Name: POWER MOBILE LIFE, LLC
EN 1716 EN
Address: 10900 NE 8th St, Ste 501, Bellevue WA 98004
Telephone: 1-800-988-7973
NOTICE (Canada)
This device complies with Industry Canada licence-exempt RSS
standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that
may cause undesired operation of the device."
Le présent appareil est conforme aux CNR d'Industrie Canada
applicables aux appareils radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes:
(1) l'appareil nedoit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement."
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-
003 du Canada.
IC RF Statement
When using the product, maintain a distance of 20cm from the body to
ensure compliance with RF exposure requirements.
Lors de l'utilisation du produit, maintenez une distance de 20 cm du
corps afin de vous conformer aux exigences en matière d'exposition
RF.
This product complies with the radio interference requirements
of the European Community.
Declaration of Conformity
Hereby, Anker Innovations Limited declares that this device is in
compliance with the essential requirements and other relevant
provisions of Directive 2014/53/EU. For the declaration of conformity,
visit the website: https://uk.eufylife.com.
This product complies with the radio interference requirements
of the United Kingdom.
Declaration of Conformity
Hereby, Anker Innovations Limited declares that this device is in
compliance with Radio Equipment Regulations 2017(SI 2017/1206). The
full text of the UK declaration of conformity is available at the following
internet address: https://uk.eufylife.com.
RF exposure information:
The Maximum Permissible Exposure (MPE) level has been calculated
based on a distance of d=20cm between the device and the human
body. To maintain compliance with RF exposure requirement, use
products that maintain a 20cm distance between the device and
human body.
Frequency bands and power as below:
Function Bands Operation Frequency Max. Power
Sub-1G for T8030 Sub-1G 866-866.8 MHz ERP 12.973 dBm
Wi-Fi for T8030 2.4GHz 2412-2472MHz EIRP 19.58 dBm
Wi-Fi for T8600 2.4GHz 2412-2472MHz EIRP 19.15 dBm
The adapter type (for T8600) is TEKA-TB120100XX, rated output
voltage/current is 12Vdc/1A.
The adapter type (for T8030) is KA2401A-1202000DE, rated output
voltage/current is 12 Vdc/2A.
The following importer is the responsible party (contract for EU
matters):
Anker Innovations Deutschland GmbH I Georg-Muche-Strasse 3, 80807
Munich, Germany
The following importer is the responsible party (contract for UK
matters):
Anker Technology (UK) Limited I GNR8, 49 Clarendon Road, Watford,
Hertfordshire, WD17 1HP, United Kingdom
Indice
Lingue:
Altri manuali EUFY Telecamera di sicurezza
