EUTECH INSTRUMENTS 60010-00 Manuale utente
Technology Made Easy ...
Thermocouple
Thermometer Models
60010-00 (Type J)
60010-10 (Type K)
60010-20 (Type T)
68X309905 Rev 1 04/04
TABLE OF CONTENTS
1.
INTRODUCTION 4
2.
SAFETY PRECAUTIONS 6
3.
SPECIFICATIONS 7
4.
BATTERY INSTALLATION AND
REPLACEMENT 10
5.
SELF TEST 12
6.
CONNECTING A THERMOCOUPLE
12
7.
SELECTING TEMPERATURE
SCALE 16
8.
HOLD FUNCTON 17
9.
CALIBRATION 17
10.
CANCELING A FIELD CALIBRATION
18
11.
FIELD CALIBRATION LOCKOUT
AND RE-ENABLE 19
12.
LOCKOUT PROCEDURE 19
13.
RE-ENABLE PROCEDURE 20
14.
MAINTENANCE 20
15.
CLEANING 21
16.
BATTERIES 21
17.
ACCESSORIES 22
18.
SERVICE 24
19.
WARRANTY 25
20.
PRODUCT RETURN 25
4
1. INTRODUCTION
This versatile hand-held instrument
provides highly accurate temperature
measurements. The instrument is
designed for easy operation and
includes
the following features:
• Operator selection of Celsius or
Fahrenheit scale
• Resolution of 0.1° from –99.9 to
299.9°
• Four-digit LCD
• Hold feature for temporarily retaining
a reading
• Field calibration capability
5
• Low battery warning
• Built-in tilt stand for easy hands-free
operation
• Two blade female ANSI mini-
connector input
• Operates with a wide selection of
probes 2
6
2. SAFETY PRECAUTIONS
WARNING: THIS INSTRUMENT IS
DESIGNED TO ACCEPT LOW
LEVEL SIGNALS SUPPLIED BY
STANDARD THERMOCOUPLES.
UNDER NO CIRCUMSTANCES
SHOULD THE INPUT VOLTAGE
EXCEED THE SPECIFIED 50V RMS.
CAUTION: DO NOT USE OR STORE
THIS INSTRUMENT IN MICROWAVE
OVENS OR ANY ABNORMALLY HOT
OR COLD AREAS.
CAUTION: WEAK BATTERIES
SHOULD NOT BE LEFT IN THE
INSTRUMENT. DEAD BATTERIES
CAN LEAK AND CAUSE DAMAGE TO
UNIT.
DANGER: VOLTAGES PRESENT AT
THE THERMOCOUPLE MAY ALSO
BE PRESENT AT THE BATTERY
TERMINALS. ALWAYS DISCONNECT
THE THERMOCOUPLE WHEN
CHANGING BATTERIES.
WARNING: TO PREVENT IGNITION
OF A HAZARDOUS ATMOSPHERE,
BATTERIES MUST ONLY BE
CHANGED IN AN AREA KNOWN TO
BE NON-HAZARDOUS.
7
3. SPECIFICATIONS
THERMOCOUPLE PROBES
Type Temperature range
Type J –200°C to 1000°C
(–328°F to 1832°F )
Type K –250°C to 1372°C
(–418°F to 2501°F )
Type T –250°C to 400°C
(–418°F to 752°F )
Out of range display: - - - -
Resolution
0.1°/1° autoranging, 0.1° from –99.9° to
299.9°, 1° outside this range.
Accuracy
> –99.9°: +(0.2% of reading +0.5°C)
+(0.2% of reading +0.9°F)
< –99.9°: +(0.25% of reading, +1°C)
+(0.25% of reading +2°F)
Display
4-digit LCD with 0.5 in high numerals.
Display update rate
0.6 sec per update.
Input
One thermocouple with ANSI
connector.
8
Input Protection
50V rms
Battery
Two AA, 1.5V alkaline ANSI-L40, IEC-
LR6.
Battery Life: 750 hours continuous,
typical.
Low battery indication
Battery Symbol on when 8 to 10 hours
of battery life remains.
Battery symbol blinking: replace battery
Operating Conditions
Stated accuracy:
18°C to 28°C (64°F to 82°F)
Useful range:
0°C to 40°C (32°F to 104°F)
Storage:
–40°C to 65°C (–40°F to 149°F)
Humidity (non-condensing):
10% to 90% 4
Dimensions
3 cm D x 8.4 cm W x 15.8 cm H
(1.2 in x 3.3 in x 6.2 in)
Weight with batteries
227 grams (8 ounces)
9
Ingress protection
Meets IEC-529 IP-54 for dust and
water resistant enclosures.
Intrinsic safety
This product is energy limited for
intrinsically safe operation in hydrogen
atmospheres per Class I, Division 1,
Groups A, B, C and D
hazardous(classified) locations for UL
per UL913 and CSA per C22.2 No. 0-
M1982 and No. 157-M1987. Maximum
surface temperature: 135°C (T4); UL
file No. E182612 (1997).
Electromagnetic Compatibility
(For CE Mark) EN61326-1/1A: 1998
(EU EMC Directive)
10
4. BATTERY INSTALLATION AND
REPLACEMENT
If battery indicator turns on, battery
life is approximately 8 to 10 hours. The
battery indicator will start blinking with
less than 1 hour of life remaining.
Selected settings are stored in memory
and will remain in memory even after
power is turned off, or while batteries
are being replaced.
1. Before changing battery, turn
instrument off and disconnect
thermocouple.
2. Loosen screw and lift battery cover
off back of case.
3. Remove the two AA batteries.
4. Insert two new batteries observing
polarity.
5. Install cover and tighten screw.
Questo manuale è adatto per i seguenti modelli
2
Indice
Altri manuali EUTECH INSTRUMENTS Termometro
EUTECH INSTRUMENTS
EUTECH INSTRUMENTS ECOSCAN TEMP JKT PORTABLE METER Istruzioni per il montaggio
EUTECH INSTRUMENTS
EUTECH INSTRUMENTS ECOSCAN TEMP 456 PORTABLE METER Istruzioni per il montaggio
EUTECH INSTRUMENTS
EUTECH INSTRUMENTS ECOSCAN TEMP 456 PORTABLE METER Manuale utente
EUTECH INSTRUMENTS
EUTECH INSTRUMENTS ECOSCAN TEMP JKT TEMPERATURE METER Manuale utente
