Place the projector in a dry area away from sources of dust, moisture, steam, smoke,
sunlight or heat.
The projector is heavy. Use safe handling techniques when lifting the projector.
Do not drop or knock the projector.
Before installation, make sure that the surface, ceiling or rigging that is to support the
projector is capable of supporting the combined weight of the projector and lens.
When stacking projectors, the stack MUST be vertical, to ensure that the stresses are
distributed to all four chassis corners.
Do not stack more than 3 projectors.
Do not place heavy objects on top of the projector chassis. Only the chassis corners
and the optional rigging frame are capable of withstanding the weight of another
projector.
Backup safety chains or wires should always be used with ceiling mount installations.
Ensure that the intake vents do not recycle hot air from the exhaust vent.
When operating the projector in an enclosed space, ensure that the surrounding air
temperature within the enclosure does not exceed operation temperature while the
projector is running, and the air intake and exhaust vents are unobstructed.
All enclosures should pass a certied thermal evaluation to ensure that the projector
does not recycle exhaust air, as this may cause the device to shutdown even if the
enclosure temperature is with the acceptable operation temperature range.
Turn on Altitude Mode when located in high altitude areas.
The projector can only be installed upright or inverted.
When installing the bracket, make sure the weight limit is not exceed and the projector
is rmly secured.
Avoid installing near an air conditioner duct or a subwoofer.
Avoid installing at high temperature, insufcient cooling and heavy dust locations.
Keep your product away from uorescent lamps (>1 Meter) to avoid malfunction caused
by IR interference.
The VGA IN connector should be connected to the VGA IN port. Note that it should
be inserted tightly, with the screws on both sides securely fastened to ensure proper
connection of the signal wire for achieving optimal display effect.
The AUDIO IN connector should be connected to the AUDIO IN port and CANNOT be
connected to AUDIO OUT or other ports like BNC, RCA; otherwise, it will lead to mute
output and even DAMAGE the port.
Install the projector above 200cm to avoid damage.
The power cord and signal cable should be connected before the projector is powered
on. During startup and operation, DO NOT insert or remove the signal cable or the
power cord to avoid damaging the projector.
The projector generates a massive amount of heat during use. The internal fan
dissipates the heat of the projector when shutting down, which could continue for a
certain period. After the project enters STANDBY MODE, press the AC power button
to turn off the projector and remove the power cord. DO NOT remove the power cord
during shutdown as it may cause damage to the projector and may affect the service
life of the projector.
