JETRONIC-BOX – Instruct ons 1.8
Introduct on
The JETRONIC-BOX is a universal R/C processor for use in medium-si ed and large model
aircraft. Two R/C inputs can be programmed to control up to three R/C outputs, for example to
implement a landing gear with door control or a cockpit with open/close and lock functions, where
even an R/C transmitter with microprocessor control is not sufficient. Since such model functions
are often realised using pneumatic systems with an air tank and a pneumatic cylinder, the
JETRONIC-BOX also features an air pressure measurement and display function as well as the
corresponding adjustable pressure monitoring function.
To read the current operating data and to adjust settings, a suitable display and programming unit
(Engine Data Terminal) is required. The following devices are supported:
Jetronic-Display EDT, no.: 8830
Micro-EDT, no.: 8832
Graupner BOOSTER-EDT no.: 6813.10
Graupner ONBOARD-EDT no.: 6813.7
These units are equipped with an illuminated alphanumeric display and can be connected and
disconnected while the system is running, or they can be permanently installed in the model
(ONBOARD-EDT).
Besides the current operating parameters, such as the battery voltage, it is also possible to display
additional information, such as air pressure or R/C inputs and outputs. All display and adjustment
functions are accessible via a menu-controlled plain text dialog. The JETRONIC-BOX is connected
to the R/C receiver via RC-1 normally, but RC-2 can be used as well (additional function).
Using a USB cable (type Orbit Jetronic-SIO2USB), the JETRONIC-BOX can be updated via the
Internet, making it possible to install new functions or extensions. To do so, use the JetLog PC
software shipped with the Jetronic-SIO2USB cable.
This makes the JETRONIC-BOX suitable for future model projects, too – for example, flashing
position lights, warning lights or special control functions are possible.
3
