Extron electronics DVI Output Card Manuale utente

Installation Guide

Digital Visual Interface Card for ISS 108/408 and ISM 482

68-761-01 Rev. B

01 09

DVI Output Card

DVI Output Card Installation

Installation

An optional digital visual interface (DVI) output card is available for

the ISS 108, ISS 408, and ISM 482. With the card installed, the switcher

outputs Program video simultaneously on the standard DVI connector

and Program Output BNC and 15-pin HD connectors.

Opening the Switcher

Extron recommends returning the switcher to Extron for service and

updates.

NThe ISM 482 Switcher installation is shown. The ISS 108 and

ISS 408 installations are similar.

To install the optional DVI output card, the switcher case must be

removed.

Remove as follows:

1. Disconnect the AC power cord to remove power from the switcher.

WTo prevent electric shock, always unplug the switcher from

the AC power source before opening the enclosure.

2. If the switcher is installed in a rack, disconnect all signal and

control cables and remove the switcher from the rack.

3. Remove the 16 screws from the switcher, 8 on the top and 4 on

each side of the cover (ﬁgure 1).

4. Remove the top two front panel screws.

5. Lift the top cover straight up approximately ﬁve inches for access

to the fan power cords.

CDo not touch any switches or other electronic components

inside the switcher. Doing so could damage the switcher.

Electrostatic discharge (ESD) can damage IC chips even

though it cannot be felt. A grounding wrist strap is

recommended.

6. Disconnect the two fan power cords from connectors J8 and J13 on

the main board.

7. Remove the top cover and set it aside.

Installation, cont’d

DVI Output Card Installation

12 3 4 5678

100

240

50/60 Hz

1.2A MAX.

H/HV

INPUTS

H/HV

Remove (16)

screws.

Remove top two

front panel screws.

Lift cover straight up.

Fan Connectors:

J8 and J13.

J8J13

DVI card socket J14

Figure 1 — Removing the switcher cover

DVI Output Card Installation

Installation, cont’d

DVI Output Card Installation

Install the DVI output card in the switcher as follows:

WChanges to electronic components must be performed by

authorized service personnel only.

WTo prevent electric shock, always unplug the switcher

from the AC power source before opening the enclosure.

1. Locate the DVI output card connector opening on the rear

panel and the DVI output card socket J14 on the left rear

portion of the main circuit board, as viewed from the front

(ﬁgure 2).

DVI Output Card

Socket J14 on

Main Circuit Board

DVI Output Card

Connector Opening

Rear Panel

Figure 2 — DVI output card connector opening and

socket J14

DVI Output Card Installation

Installation, cont’d

2. If the rear panel DVI connector opening is covered, remove the

two screws that secure the cover to the back panel and remove

the cover.

3. Position the DVI card above J14 with the DVI connector facing

toward the rear of the switcher. Ensure the pins on the DVI

card properly align with the J14 socket to prevent bending.

4. Carefully insert the DVI board 45-pin connector into socket J14

on the main circuit board (ﬁgure 3).

DVI Output Card

Mated to the

Main Board via

Socket J14

DVI Output Card

DVI Connector

Figure 3 — Output DVI board installation

5. Secure the DVI card to the rear panel with the two screws

provided in the kit.

CCarefully inspect the pins to be certain all are properly seated

in the socket before proceeding. The board connector should

have all pins inserted the same depth.

Extron USA - West

Headquarters

+800.633.9876

Inside USA / Canada Only

+1.714.491.1500

+1.714.491.1517FAX

Extron USA - East

+800.633.9876

Inside USA / Canada Only

+1.919.863.1794

+1.919.863.1797FAX

Extron Europe

+800.3987.6673

Inside Europe Only

+31.33.453.4040

+31.33.453.4050 FAX

Extron Asia

+800.7339.8766

Inside Asia Only

+65.6383.4400

+65.6383.4664FAX

Extron Japan

+81.3.3511.7655

+81.3.3511.7656FAX

Extron China

+400.883.1568

Inside China Only

+86.21.3760.1568

+86.21.3760.1566 FAX

Extron Middle East

+971.4.2991800

+971.4.2991880 FAX

Installation, cont’d

Closing the Switcher

1. Reconnect the two fan power cords to connectors J8 and J13 on the

main board. It does not matter which fan is connected to which

connector.

2. Replace the top cover on the switcher.

3. Fasten it with the screws that were removed in "Opening the

Switcher", step 3and step 4.

4. Reinstall the switcher and reconnect all cables.

Indice

Altri manuali Extron electronics Hardware per computer

Extron electronics

Extron electronics Dual Window Multi-Graphic Processor MGP 462 Manuale utente

Extron electronics

Extron electronics DMP 128 Plus Manuale utente

Extron electronics

Extron electronics Multi-Graphic Processor MGP 464 Manuale utente

Extron electronics

Extron electronics DMP 128 FlexPlus Manuale utente

Extron electronics

Extron electronics EDID 101H 4K PLUS Manuale utente

Extron electronics

Extron electronics Annotator 300 Manuale utente

Extron electronics

Extron electronics AXP 64 C AT Manuale utente

Extron electronics

Extron electronics IPL Pro Series Manuale utente

Extron electronics

Extron electronics IPCP 505 Manuale utente

Extron electronics

Extron electronics DMP Plus Series Manuale utente

Extron electronics

Extron electronics WindoWall Pro Series Manuale utente

Extron electronics

Extron electronics DMP 64 Manuale utente

Extron electronics

Extron electronics Annotator 401 Manuale utente

Extron electronics

Extron electronics StudioStation 100 Manuale utente

Extron electronics

Extron electronics UCS 601 Manuale utente

Extron electronics

Extron electronics Dual Window Multi-Graphic Processor MGP 462D Manuale utente

Extron electronics

Extron electronics SMP 300 Series Manuale utente

Extron electronics

Extron electronics PIP 422 Manuale utente

Extron electronics

Extron electronics DTP3 T 202 Manuale utente

Extron electronics

Extron electronics Quantum Ultra Manuale utente

Extron electronics

Extron electronics DTP3 T/R 301 Manuale utente

Extron electronics

Extron electronics Annotator Manuale utente

Extron electronics

Extron electronics DMP 64 Plus Manuale utente

Extron electronics

Extron electronics AXP 64 C AT Manuale utente

Manuali Hardware per computer popolari di altre marche

EMC2

EMC2 VNX Series Manuale del proprietario

Panasonic

Panasonic DV0PM20105 Manuale utente

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Manuale utente

Gigabyte

Gigabyte B660M DS3H AX DDR4 Manuale utente

Raidon

Raidon iT2300 Manuale utente

National Instruments

National Instruments PXI-8186 Manuale utente

Hauppauge

Hauppauge WinTV-HVR-2250 Manuale utente

Kontron

Kontron CP6002 Manuale utente

Manhattan

Manhattan 702843 Manuale utente

Aphex

Aphex 230 Manuale utente

AMD

AMD Phenom II Manuale operativo

Intel

Intel NUC 12 Pro Manuale utente

dbx

dbx Zone Pro 1260 Manuale utente

Galaxy

Galaxy GHDX2-2430S-24F4D Manuale utente

Intel

Intel AXXRMFBU4 Manuale utente

Kontron

Kontron DIMM-PC/MD Manuale utente

ST X-NUCLEO-SAFEA1B Istruzioni operative

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Manuale utente