Extron electronics FOX 2G Tx AV Manuale utente

Setup Guide — FOX 2G Tx/Rx AV

(Continued on reverse side)

The FOX 2G Tx AV and FOX 2G Rx AV are a high performance, low resolution video, audio,

and data (RS-232) transmitter (Tx) and receiver (Rx) pairs. Both the transmitter and receiver are

available in single mode (SM) and multi-mode (MM) models. The SM models transmit signals

up to 30 km (18 miles) over ﬁber optic cable, at rates up to 2 Gbps.

NThe transmitter and receiver must be compatible. Both must be MM or both must be SM. It

is not possible to mix types.

WThe FOX 2G Tx/Rx AV outputs continuous invisible light (Class 1 rated), which may

be harmful and dangerous to the eyes; use with caution.

Do not look into the rear panel ﬁber optic cable connectors or into the ﬁber optic cables

themselves.

NPlug the attached dust caps into the optical transceivers when the ﬁber optic cable is

unplugged.

To install, cable, and power on the transmitter/receiver pair:

Step 1

Turn off all equipment or disconnect it from power sources.

Mount the transmitter and receiver as required.

Step 2

Connect a low resolution video source to the transmitter using

the input BNC connections for composite or component sources.

S-video can be connected using either the BNC connectors or the

4-pin mini DIN. (See the ﬁgure at right).

Step 3

Connect balanced or unbalanced, stereo or mono audio input

to the transmitter using the 5-pole, 3.5 mm captive screw

connector. (See the ﬁgure at right).

Step 4

If required, connect an alarm system to the transmitter’s

2-pole captive screw connector.

Step 5

To conﬁgure the transmitter and receiver using RS-232

commands, connect a control device to the three right poles

( ,Tx, and Rx), labeled RS-232 Remote, on the RS-232 captive

screw connector of the transmitter (see the ﬁgure at the bottom

of the page). Alternatively, the host device can be connected

through the front panel Conﬁg port or the corresponding ports on the receiver

(see step 13). These ports may also be used to conﬁgure the system with the

FOX Extender Windows®Control Program.

Step 6

To pass through RS-232 commands to remote devices, independently of the

FOX 2G Tx/Rx AV, use the three left poles (Tx, Rx, and ), labeled RS-232

Over Fiber. The ground is common for both sets of RS-232 signals. (See the

ﬁgure at right).

Y/VID

R-YS-VID

B-Y/C

S-video

-Y

Y/VID

R-YS-VID

B-Y/C

-VI

S-video

Y/VID

R-YS-VID

B-Y/C

-VID

Component

Y/VID

R-YS-VID

B-Y/C

-VID

Composite

-Y/

Balanced Audio

Tip

Ring

Tip

Ring

L R

Sleeves

Unbalanced Audio

Tip

Sleeve

Tip

L R

WInstallation and service must be performed by

authorized personnel only.

These instructions provide a quick setup guide for

the Extron FOX 2G Tx/Rx AV. They are for use by

experienced installers.

REMOTE

Tx RxTx Rx

OVER FIBER

RS-232

Setup Guide — FOX 2G Tx/Rx AV

Extron USA - West

Headquarters

+800.633.9876

Inside USA / Canada Only

+1.714.491.1500

+1.714.491.1517FAX

Extron USA - East

+800.633.9876

Inside USA / Canada Only

+1.919.863.1794

+1.919.863.1797FAX

Extron Europe

+800.3987.6673

Inside Europe Only

+31.33.453.4040

+31.33.453.4050 FAX

Extron Asia

+800.7339.8766

Inside Asia Only

+65.6383.4400

+65.6383.4664FAX

Extron Japan

+81.3.3511.7655

+81.3.3511.7656FAX

Extron China

+400.883.1568

Inside China Only

+86.21.3760.1568

+86.21.3760.1566 FAX

Extron Middle East

+971.4.2991800

+971.4.2991880 FAX

68-1466-50

Rev. A

04 09

Step 7

Connect the 12 VDC power supply to the transmitter’s 2-pole captive screw connector. Do not

switch on the power supply.

Step 8

Connect the receiver to a low resolution video display using either the output BNC connectors

(component, S-video, or composite) or the 4-pin mini DIN (S-video only), as shown in the

ﬁgure at right.

Step 9

Connect the receiver’s audio output to a sound system, using the 5 pole, 3.5 mm captive screw

connector.

Step 10

If required, connect an alarm system to the receiver’s 2-pole

captive screw connector.

Step 11

Connect the ﬁber optic cable(s) from the transmitter to the back

of the receiver (see the ﬁgure below). Fiber optic link 1 connects

the Tx port of the transmitter to the Rx port of the receiver and

is essential for transmission of video, audio, and control signals

from the transmitter to the receiver. Fiber optic link 2 connects the Rx port of the transmitter

to the Tx port of the receiver. It is optional, but two-way communication from the Tx port of

the receiver is required to fully conﬁgure the system using RS-232 commands or FOX Extender

Windows Control Program.

RxTx

OPTICAL

RxTx

OPTICAL

Transmitter Receiver

Link 2 may be connected to another receiver in a daisy chain. In that case, there is no return

link to the transmitter.

Step 12

Connect an RS-232 control device to the 5-pole captive screw connector or the front panel

Conﬁg port of the receiver. These ports are an alternative to the transmitter ports (see steps 6

and 7).

NIf the RS-232 control device is connected to the receiver, ﬁber optic Link 2 is required to

conﬁgure the transmitter.

Step 13

Connect the 12 VDC power supply to the receiver’s 2-pole captive screw connector.

Step 14

Power up all devices and conﬁgure the system using the Simple Instruction Set (SIS™)

commands or FOX Extender Windows Control Program. Consult the user’s manual (available

online at www.extron.com) for more information about SIS commands and the Control

Program.

Y/VID

R-YS-VID

B-Y/C

S-video

-Y

Y/VID

R-YS-VID

B-Y/C

-VI

S-video

Y/VID

R-YS-VID

B-Y/C

-VID

Component

Y/VID

R-YS-VID

B-Y/C

-VID

Composite

-Y/

Altri manuali per FOX 2G Tx AV

Questo manuale è adatto per i seguenti modelli

Indice

Altri manuali Extron electronics Estensione

Extron electronics

Extron electronics eLink 100 Manuale utente

Extron electronics

Extron electronics EDID 101H 4K Manuale utente

Extron electronics

Extron electronics DVI 104 Manuale utente

Extron electronics

Extron electronics DTP HWP 4K 231 D Manuale utente

Extron electronics

Extron electronics PowerCage FOX 4G Tx VGA Manuale utente

Extron electronics

Extron electronics DTP T 3G-SDI 230 Manuale utente

Extron electronics

Extron electronics USB Extender Plus Series Manuale utente

Extron electronics

Extron electronics FOX3 101 Manuale utente

Extron electronics

Extron electronics DTP DVI 4K 330 Manuale utente

Extron electronics

Extron electronics USB Extender Tx Manuale utente

Extron electronics

Extron electronics AKM MAAP Manuale utente

Extron electronics

Extron electronics DTP HDMI 4K D Series Manuale utente

Extron electronics

Extron electronics UCS FT 901 Manuale utente

Extron electronics

Extron electronics DTP T HWP 232D Manuale utente

Extron electronics

Extron electronics eLink 100 Manuale utente

Extron electronics

Extron electronics Tx-Rx Manuale utente

Extron electronics

Extron electronics DDX 102 Tx Manuale utente

Extron electronics

Extron electronics DTP DVI 301 Manuale utente

Extron electronics

Extron electronics DTP DVI 301 Manuale utente

Extron electronics

Extron electronics HFX 100 Tx Manuale utente

Extron electronics

Extron electronics FOX3 101 Manuale utente

Extron electronics

Extron electronics DTP T UWP 4K 232 D Manuale utente

Extron electronics

Extron electronics HDMI 230 D Manuale utente

Extron electronics

Extron electronics DTP T/R DP 330 Manuale utente

Manuali Estensione popolari di altre marche

SY HDBT-60T Manuale utente

Appsys ProAudio

Appsys ProAudio ADX-16 Manuale utente

Atlona

Atlona RS232 Manuale utente

IDK

IDK OPF-TH1000-A Manuale utente

Enable-IT

Enable-IT 824WP Manuale utente

Worx

Worx Landroid RadioLink WA0864 Scheda tecnica

TP-Link

TP-Link TL-WA730RE Manuale utente

Camplex

Camplex CMX-HDMI-SFPL Manuale utente

SC&T

SC&T HE03-4K Manuale utente

Marmitek

Marmitek MegaView70 Manuale utente

Samsung

Samsung SCS-26UC4 Manuale utente

Foxun

Foxun SX-GES24 Manuale utente

MuxLab

MuxLab 500771 Manuale utente

foxunhd

foxunhd SX-AEX01 Manuale utente

TERK Technologies

TERK Technologies LFIRX2 Manuale utente

Devolo

Devolo Audio Extender Manuale

Edimax

Edimax EW-7438RPn V2 Manuale utente

Shinybow USA

Shinybow USA SB-6335T5 Manuale utente