Fanvil I31S Manuale utente

Video Door Phone

Quick Installation Guide

i31S

WWW.FANVIL.COM

Table of Contents

1. Package Contents ......................................................................................... 4

2. Physical Specifications.................................................................................. 4

3. Installation ................................................................................................... 8

4. Searching Door Phone ................................................................................ 11

5. SIP Door Phone Setting............................................................................... 12

6. Door Unlocking Setting............................................................................... 13

1. Package Contents

2. Physical Specifications

Device size

223 x 130 x 74mm

Weight

1800g

1) Front Panel

Speaker

Numeric keypad

(password and dialing)

Lock status

Call status

Ring status

Network and registration

status

Dss Key

MICs

Camera

photoresistor

Infrared light

RFID area

Door Phone

Connectors

Quick Installation

Guide

RFID Cards

Mounting Template

Screw and

Wrench

Interface

Description

Camera

Get the video.

Infrared light &

Photoresistor

The Compensate for lack of ambient light

Speaker

The door phone has a built-in speaker for convenient communication

and alert use.

MIC

The door phone has a built-in microphone hidden in the pinhole located

on the front panel.

RFID Reader

Use RFID cards to unlock the door by touching RFID reader of device.

Button Definition

Button

Description

DSS Key

Press the Button, calling or request to open the door.

Numeric Keyboard

Input password to open the door or call.

LED Definition

LED

Status

Description

Lock

Steady Blue

Door unlocking

off

Door locking

Call

Blinks per second

Hold

Steady Blue

Call Hold

off

On Hook

Ring

Steady Blue

Ringing

off

On Hook

Network & SIP

Registration

Blinks per second

Network error

off

Network is normal, SIP is not registered

Blinks every 3 seconds

SIP Registration failed

Steady Blue

SIP Registration succeeded

2) Port Definition

After removing the Back Panel of device, there are one terminal block connectors for power and lock

control connection as shown in the picture below.

JP1 Jumper

Power and lock

connector

WAN Port

Network Connector

Power and Electric-lock Connector

+DC12V

VSS

COM

S-IN

S-OUT

12V DC Input

Electric-lock switch

Indoor switch

JP1 Jumper

There are two modes for power supply of electric-lock as shown in the picture below.

(The default is “Passive Mode:”).

Passive Mode: When the electric-lock starting current is more than 12V/650mA, need to use the external

drive mode, the electric lock interface for short circuit output control.

Active Mode : When the electric-lock starting current is less than 12V/650mA, can use the internal drive

mode, the electric lock interface is 12V DC output.

Jumper in passive mode Jumper in active mode

Wiring instructions

NO: Normally Open Contact

COM: Common Contact

NC: Normally Close Contact

Driving Mode

Electric-lock Mode

JP1

Jumper

Connections

Active

Passive

No electricity

when open

Electrify

when open

√

3. Installation

Front Panel Main Part of Intercom Rain Shade Back Panel

Figure 1 Three Major Parts of i31S

Step 1: Installation preparation

A. Check the following contents:

Hex wrench x 1

RJ45 plugs x 2 (1 spare)

TA5 x 40mm screws x 4

35mm screw anchors x4

B. Tools that may be required:

Hex wrench

Phillips screwdriver (Ph2 or Ph3), hammer, RJ45 crimper

Electric impact drill with an 6mm drill bit

Step 2: Drilling

Figure 2 Wall Mounting

A. Place the mounting template with dimensions on the surface of a wall in a desired flat position.

B. Use an electric drill to drill the 4 holes marked on the mounting template. It is recommended to drill

about 50mm deep. Remove the template when finishing drilling.

C. Push or hammer screw anchors into the drilled holes.

Step 3: Removing hanging shell

A. With L-shaped screwdriver, unpack the front panel as diagram (3) (Counter-clockwise) and (4)

Figure 3 Figure 4

B. With Phillips screwdriver, unpack the rain shade and the main part of intercom as diagram (5)

Figure 5

Step 4: Back panel fixing and cabling

Figure 6 Figure 7

A. Select the hole for cable supply, 15cm to 20cm cable length is recommended.

Note: The direction of the cable hole on back panel is pointing down.

B. With 4 TA5*40mm screws, tighten the back panel on the wall as diagram (6).

C. Connect the cables of RJ45, power, and electric-lock to the motherboard socket as mentioned

in connectors description (refer to Section 2).

D. Test whether there is electricity by doing the following:

Press the # button for 3 seconds to get the IP address of intercom by voice.

Input access password or press the indoor switch to check electric-lock installation.

Note: Do not proceed mounting until you have finished the electric checking.

Step 4: Mounting

Figure 8 Figure 9

A. With 6 screws unscrewed before, tighten the main part (together with rain shade) of intercom

on the back panel as diagram (8).

B. Push the front panel into the plastic frame, and tighten it with 6 screws as diagram (9).

Note: Make sure the screws have been tightened properly for better waterproof effect.

Altri manuali per i31S

Indice

Manuali Sistema di interfono popolari di altre marche

Bticino

Bticino LINEA 3000 Manuale utente

MSI

MSI MSI-140 Manuale utente

golmar

golmar Stadio Plus Manuale utente

CyberData

CyberData 011211 series Manuale

Vidos

Vidos duo M1021 Manuale utente

Vimar

Vimar ELVOX 7539/E Manuale utente

SSS Siedle

SSS Siedle BTSV 850-03 Manuale utente

Dahua

Dahua VTO Series Manuale utente

Elvox

Elvox 5651 Manuale utente

Videx

Videx VIDEOKIT Series Manuale utente

Rocom

Rocom Doortello Business FW T2.05W2.04 Manuale utente

Viking

Viking E-35-EWP Manuale utente

Safeguard Supply

Safeguard Supply LRA-EX1000 Manuale utente

SSS Siedle

SSS Siedle BFCV 850 Series Manuale utente

GRD

GRD MAX V2 Manuale utente

Alecto

Alecto ADI-250 Manuale utente

Aiphone

Aiphone IE-8MD Manuale utente

Perel

Perel EDB4 Manuale utente

Fanvil i31S Manuale utente

Manuali Sistema di interfono popolari di altre marche