Fanvil I20-T Manuale utente

Voice Access System I20 T Quick Installation Guide

1、Introduction

Package Contents

2、Voice Access Controller Components Description

3、Interface Description

I20-T Access Controller

Amphenol Connector

Software CD

Quick Instanllation Guide

Speaker

Mic

Intercom call

Button

Numeric Keypad(password

and dialing)

Fixed screw

Red Light: Power Indicator

Green Light: Networking and

registration status indicator

Call/Answer Indicator

Housing

3.1 Network, Power Switch, Electric Lock Connection

3.2 Electric Lock Connection Driver Option

【Notice】When the initial electric current of the lock is less than 500mA/12V, you can access

CN7

LAN（UTP Cable Connection）

4/5

7/8

TX+

TX-

RX-

RX+

CN6

Output12V DC

Electric Lock Driver

WAN（UTP Cable Connection）

V+

GND

COM

POE+

POE-

TX+

TX-

RX-

RX+

12V DC input

Normally open, normally

close port

JP1

Outside

Driver

External Power Driving

Jumper

JP1

Inside

Driver

Internal Power Driving

Jumper

CN6

CN7

to the internal driven mode and use the POE of the Voice Access System or 12V DC to

control the the switch of the electric lock ; When the initial electric current of the lock is more

than 500mA/12V, you need to access to the external driven mode(Use specialized DC

power to control the electric lock )

3.3 Wiring

Relay connection description：

NO：means idle-disconnected contact (normally open)

COM: means a pin contact(middle)；

NC：means an idle-connected contact(normally close)；

Electric lock

power supply

mode

Electric

lock

Jumper

JP1

Mode of connection

Internal

External

√

Inside

Driver

√

Outside

Driver

√

Inside

Driver

Electric lock power

supply mode

Electric

lock

Jumper

JP1

mode of connection

Interna

External

√

Outside

Driver

√

Outside

Driver

4、Setup of Voice Access System

Step 1：Connect Network

Plug one side of a cable to the WAN socket of I20, then the connection of hardware is

finished. In most of time, you should reset your network to DHCP mode.

Step 2：Get Device IP Address

How to get IP Address：

Method 1. Use iDoorPhoneNetworkScanner tool

1）Install enclosed iDoorPhoneNetworkScanner tool;

2）Ensure the computer which installed iDoorPhoneNetworkScanner.exe is in the same network with I20

Voice Access Controller.

3）Run iDoorPhoneNetworkScanner.exe to search corresponding device’s IP address.

Method 2: Press “#”key for 5 seconds, the controller will report it IP number by itself.

Step 3: Get Voice Access SIP account via web

Use your web browser to input its IP address (example: http://192.168.1.149) The default user name

“admin”, the password is also “admin”.

VOIP Account Setting：

Set SIP server address, port, user name, password and number. Then start registration.

Step 4：Set Speed Dial Key

Setting Speed Dial to call SIP accounts, configuring DSS KEY1 corresponding Type: Hok key, Value:

number, line: the registered SIP line (the number corresponded to), subtype: Speed Dial. Then submit

Step 5：Parameters Setting

Voice Access Configuration

Setting Item

Function

Initial Value

Open Time

Time for open the door, if time is up, the

door will be closed automatically.

Holding Time

After time is up, the call will be ended

automatically.

120s

Remote Openig

Time

Remote opening password.

Local PIN

Local password for the keypad

6789

Tone settings

Mute/Short beeps/Long beeps

Bell ringing

Keypad mod（I20T

Valid）

Password only(Prohibit

call)/Password-Dial

Dialing and password

input

Description

Displayed on iDoorPhoneNetworkScanner

software

I20 IP door phone

Remote

phonebook

settings

Enabling access phone: when remote phone

calls, input access code first then input

password to open the door.

Disabling access phonebook: when remote

Enable

phone calls, input password only.

Remote Phonebook

Number

Remote phone number

Authentication

code

Access code for visitor. When remote

phone calls, if the number is in access

list, you can input access code to open

the door.

When IP phone calls, it

needs to input

authentication code to

control voice access

controller.

Type of Host

When owner calls, controller answer

automatically, when visitor calls,

controller mute.

Name

Card holder’s name

Position

Card holder’s position

Department

Card holder’s department

Card number

RFID’s number

5、Visitor Calls, Remote Open the Door

1）Visitor presses speed-dial key to call the owner.

2）Owner answers the call and presses “*”key to open the door from visitor.

6、Owner Remote Opens the Voice Access Controller by VOIP Phone

1）Owner calls the Voice Access Controller by VOIP Terminal.

2）the Voice Access Controller answers the call automatically.

3）Owner enter Authentication code by VOIP Terminal’s keypad to open the door.

7、Card Management

7.1 Issue Card Management

（1）Issue <issue administration card>

Input available card number to ID input field, choose Issuer, then press Add to add Issue

Administration Card.

（2）Issue <Delete administration card>

Input available card number to ID input field, choose “Revocation”, then press Add to add Delete

Administration Card.

（3）Administration Card List

7.2Issue User Card

Issue User Card (method 1):

1）Choose “Card Issuing”in “Door Card”.

2）Press “Apply”to submit new User Card.

3) Put IC card on the Reader Sensing Area, and make sure the reader responded.

4）Choose “Normal”in the Card Reader Setting.

Altri manuali per I20-T

Indice

Manuali Sistema di interfono popolari di altre marche

Bticino

Bticino LINEA 3000 Manuale utente

MSI

MSI MSI-140 Manuale utente

golmar

golmar Stadio Plus Manuale utente

CyberData

CyberData 011211 series Manuale

Vidos

Vidos duo M1021 Manuale utente

Vimar

Vimar ELVOX 7539/E Manuale utente

SSS Siedle

SSS Siedle BTSV 850-03 Manuale utente

Dahua

Dahua VTO Series Manuale utente

Elvox

Elvox 5651 Manuale utente

Videx

Videx VIDEOKIT Series Manuale utente

Rocom

Rocom Doortello Business FW T2.05W2.04 Manuale utente

Viking

Viking E-35-EWP Manuale utente

Safeguard Supply

Safeguard Supply LRA-EX1000 Manuale utente

SSS Siedle

SSS Siedle BFCV 850 Series Manuale utente

GRD

GRD MAX V2 Manuale utente

Alecto

Alecto ADI-250 Manuale utente

Aiphone

Aiphone IE-8MD Manuale utente

Perel

Perel EDB4 Manuale utente