Construction / Installation Diagram
1. Faucet Soap Assembly
i.
Soap Dispenser oftentimes can be mounted in the left or right hole of a
100 m or 200 mm center-set sink. The ability to do this is contingent upon
the width of the faucet spout and accessibility to the unit on the underside
of the sink (the Motor and Soap Bottle cannot interfere with the water or
drain lines). When such interference above or below the sink occurs, the
Soap Dispenser must be installed through the countertop to the side of the
sink as shown in figure 1.
ii.
Drill a 25 – 30 mm hole into the counter.
iii.
Slide the plastic gasket onto the brass shank making certain that the hole
in gasket is positioned over the washer in the base of the spout.
iv.
Guide the brass shank, tubes and the sensor cable through the hole in the
counter.
v.
Position spout to direct soap into the sink
vi.
Screw the flange nut onto the shank and tighten.
2. Control Box Assembly (Including Battery Box)
i.
Determine a temporary position for mounting the foam tank & battery case
units.
ii.
Make sure foam tank unit is within reach of the liquid soap and air tube
from the foam soap dispenser.
iii.
Use the mounting grey plastic bracket as a guide, mark where holes need
to be drilled. Important: Make sure bracket and foam tank case unit is
mounted level. Repeat for battery case unit.
iv.
When installing onto a concrete wall, drill holes 30 mm deep using a 6 mm
masonry drill bit. Insert wall anchors into the holes and mount the
dispenser using screws.
v.
When installing onto a wood wall, drill holes using a 3 mm drill bit and
attach the dispenser bracket using screws provided.
vi.
Remove the battery case cover and install 4 D size batteries. Assemble
back the cover and tighten the cover using the four supplied Philips
screws. Guide the male battery box cable through the bottom opening and
place the case.
