4 5
Opening and closing of Fliptop Slider with electrical motor (802-003)
To operate the sliding roof the main switch must be turned on. The roof is opened or closed by
remote or with push buttons on the electrical cabinet, normally the truck must be connected, or an
extern 24V battery is needed to operate the roof.
Fliptop Slider uses a power card that senses the power consumption, when the roof comes to a
stop, the power card senses the load and breaks the power. You can’t start in the same direction
as the power card cut the power, you can only move the roof system in the opposite direction in
this case. The power card inside the electrical cabinet is preprogrammed. Should the roof stop
earlier, please check that the load does not reach the platform edge, or lies against the Fliptop
Slider System.
The remote control is started by holding down the On button for a few seconds, when the middle
LED lights up green = The remote control is active. The remote control turns o with the O button
or automatically after a while to save battery. The buttons with arrows open and close the ceiling.
The roof can also be operated with the push buttons on the electrical cabinet. There is a main
switch on the back of the remote control as well as the electrical cabinet. It should always be in the
”on” position, the transmitter will not drain the battery.
When opening and closing the Fliptop Slider, you must be vigilant and make sure that there
is no chance of personal injuries. The electric or manually driven movements are very strong and
can cause very serious damage if you get pinched or hit by the system. If your Fliptop slider has a
remote control be extra careful, so that no one accidentally accesses it and maneuver when
someone is near moving parts. It is also important to not open or close while driving. If you need to
perform service or other work on the system, it is imperative to disconnect the power. If the system
is locked with straps, do not forget to release them before operating the Fliptop Slider.
Important information
Strong winds can seriously damage the system. Therefore, tighten down the roof with straps under
strong wind. It is important to be careful when loading and unloading so that the loaded material
does not end up on the roof of the system. If the cargo lls the entire cargo space and tends to
collapse into a coherent mass there is a risk of a vacuum forming, this can bend the arches and
seriously damage your system, if this is a risk, open then the ceiling to let in air before unloading.
When loading and unloading masses of heavy stone, roots or anything else that stands up, it is
important that the load does not come into contact with the roof system, it prevents opening and
closing of the roof. NOTE it is important to open the roof before tipping so that the load does not
get stuck in the roof, because the system can be damaged then.
Automatic start with Time relay
Slider has a time relay which can be switched on, this then opens the roof when tilting or when
opening the back door, so that the Slider will not be crushed by the tailgate/ tailboard. Operation of
the tailgate and when tipping should always be supervised to be able to cancel if something
unexpected should happen. The manufacturer accepts no liability for damage that occurs if
the time relay or other technology would not operate the slider system during tipping or
opening.
Main power switch
should always be ”on”
