Fujitsu ScanParter 10C Manuale utente
ScanPartner 10C
Image Scanner
User's Manual
NOTICE
FCC CLASS B COMPUTING DEVICES
THIS EQUIPMENT HAS BEEN TESTED AND FOUND TO COMPLY WITH THE LIMITS
FOR A CLASS 6 DIGITAL DEVICE, PURSUANT TO PART 15 OF THE FCC RULES.
THESE LIMITS ARE DESIGNED TO PROVIDE REASONABLE PROTECTION AGAINST
HARMFUL INTERFERENCE IN A RESIDENTIAL INSTALLATION. THIS EQUIPMENT
GENERATES, USES AND CAN RADIATE RADIO FREQUENCY ENERGY AND, IF NOT
INSTALLED AND USED IN ACCORDANCE WITH THE INSTRUCTIONS, MAY CAUSE
HARMFUL INTERFERENCE TO RADIO COMMUNICATION. HOWEVER, THERE IS NO
GUARANTEE THAT INTERFERENCE WILL NOT OCCUR IN A PARTICULAR
INSTALLATION. IF THIS EQUIPMENT DOES CAUSE HARMFUL INTERFERENCE TO
RADIO OR TELEVISION RECEPTION, WHICH CAN BE DETERMINED BY TURNING
THE EQUIPMENT OFF AND ON, THE USER IS ENCOURAGED TO ATTEMPT TO
CORRECT THE INTERFERENCE BY ONE OR MORE OF THE FOLLOWING MEASURES:
-REORIENT OR RELOCATE THE RECEIVINGANTENNA.
-INCREASE THE SEPARATION BETWEEN THE EQUIPMENT AND RECEIVER.
-CONNECT THE EQUIPMENT TO AN OUTLET ON A SEPARATE OR DEDICATED
CIRCUIT.
- CONSULT THE DEALER OR AN EXPERIENCED RADIO/TV TECHNICIAN FOR HELP.
CAUTION: ANY CHANGES OF MODIFICATIONS NOT EXPRESSLY APPROVED BY THE
GUARANTEE OF THIS DEVICE COULD VOID THE USER’S AUTHORITY TO OPERATE
THE EQUIPMENT.
1
ScanPartner 10 Image Scanner
User’ s Manual
TABLE OF CONTENTS
Chapter 1 General ............................................ 3
Chapter 2 Scanner Installation. ................................. 3
Chapter 3 Operation .......................................... 14
Chapter 4 Replacement of Lamp Units ......................... 19
Chapter 5 Paper Jams ........................................ 28
Chapter 6 Diagnostics ......................................... 31
2
CHAPTER 1 GENERAL
The ScanPartner 10 Image
inputs the information into Scanner reads image information on a document and
the host computer. The image scanner consists
of the image reading mechanism, document feed mechanism,
microprocessor control circuit, and power supply.
The features of ScanPartner 10 are :
l Ability to read A4lLTR size documents using the flat- bed and legal
size documents using the Automatic Document Feeder.
. High- speed reading ( 10 ppm @ 200 dpi resolution in binary mode)
l High- resolution reading ( Max. 300 dpi).
l Compact desktop size.
l Built- in Automatic Document Feeder (ADF) of 50-page capacity.
CHAPTER 2 SCANNER INSTALLATIDN
2.1 Selecting a Location
Follow these precautions when
l Avoid locations where
l Avoid direct sunlight.
selecting an installation site for the scanner.
excess vibration may occur.
l Avoid excessive humidity and dust.
l Use the proper AC power source.
2.2 Unpacking Procedure
Unpack the scanner according
1.
2.
3.
4.
5.
6.
Remove the packing
Remove the scanner
Remove the scanner
Open the manual to
to the following procedure.
material
from the shipping container.
from the PVC bag.
the “CheckList” Page.
Check the items by referring to Figure 2.1 and the Checklist in the
table below.
For any missing items, please contact your nearest dealer or
distributor.
3
‘- FOAM LEFl
Figure 2. 1 Parts in the package
4
Checklist
Item Number
1
Item Name
Scanner
1
2 ADF Output Paper Stacker
3 Power Cable
4 SCSI Terminator
I 5 I Daisy Chain Connector I
6 User’ s manual
7 ScanPartner PAK
2.3 Removing The Shipping Retainer
1.
2.
3.
4.
5.
Place the scanner on its side as shown in Figure 2.2a.
Using a screwdriver, remove the screw on the bottom of the scanner.
Labeled Shipping Position.
Remove the shipping retainer as shown in Figure 2. 2a.
Insert the shipping retainer and fasten with the same screw as shown
in Figure 2. 2b.
Return the scanner to its normal operating position.
2.4 Automatic Dtiument Feeder (ADF)
ADF Input Paper Chute
Raise the unattached end of the input paper chute about 45” as
2.4.1
1.
2.
3.
4.
2.4.2
1.
2.
3.
4.
-2.5
:
shown in Figure 2. 3.
Pull the metal bracket down from the
Slide the metal bracket into the grips
Pull the chute extension up as far as
ADF Output Paper Stacker
under side of the paper chute.
on the document cover.
possible.
Position the output paper stacker as shown in Figure 2.4.
Slide the three notches on the paper stacker into the three openings
below the scan exit aperture.
Release the stacker gently, making sure that the stacker is firmly
attached to the paper scanner.
Pull the paper stacker extension out as far as possible.
The ScanPartner 10 lmago Scanrmr (See Figure 2.5, 2.6)
5
-
Figure 2. 2a Remove the shipping retainer
Figure 2. 2b Fasten the shipping retainer
6
,--
Figure 2. 3 Set up the ADF input paper chute
7
rExtensions
Extensions 2
Figure 2.4 Set up the ADF output paper stacker
8
r ADF chute
Figure 2.5 ScanPartner 10 Image Scanner,
With ADF output paper stacker
lent
Figure 2. 6 ScanPartner 10 Image Scanner,
Without ADF output paper stacker
9
cover
Indice
Altri manuali Fujitsu Scanner
Fujitsu
Fujitsu M3097DG Manuale di installazione e funzionamento
Fujitsu
Fujitsu ScanSnap N1800 Guida rapida
Fujitsu
Fujitsu FI-4860C2 Manuale utente
Fujitsu
Fujitsu fi-5650C Manuale
Fujitsu
Fujitsu FI-4120C Manuale
Fujitsu
Fujitsu fi-6140Z Manuale utente
Fujitsu
Fujitsu S510M - ScanSnap - Document Scanner Manuale
Fujitsu
Fujitsu ScanSnap iX500 Manuale utente
Fujitsu
Fujitsu M3096NT Manuale utente
Fujitsu
Fujitsu fi-4750L Manuale utente
Fujitsu
Fujitsu FI-5530C2 Manuale utente
Fujitsu
Fujitsu FI-4120C Manuale utente
Fujitsu
Fujitsu ScanZen Eco Series Manuale utente
Fujitsu
Fujitsu fi-5220C Manuale utente
Fujitsu
Fujitsu fi-4340C Guida alla configurazione
Fujitsu
Fujitsu M3097G Manuale di installazione e funzionamento
Fujitsu
Fujitsu Fi-7030 Manuale
Fujitsu
Fujitsu FI-5015C Guida alla configurazione
Fujitsu
Fujitsu ScanSnap FI-4110EOX2 Manuale utente
Fujitsu
Fujitsu Fi-4750c - Color Duplex Document Scanner 50ppm 90ipm... Manuale
