GE Monogram ZEK737WW Manuale utente
GE Monogram®
Installation
Instructions
27" Built-In Ovens
Models
ZEK757WW
ZEK757BW
ZEK737WW
ZEK737BW
Before you begin—Read these instructions completely and carefully.
IMPORTANT: Save these instructions for local inspector’s use.
IMPORTANT: OBSERVE ALL GOVERNING CODES AND ORDINANCES.
NOTE TO INSTALLER: Be sure to leave these instructions with the
Consumer.
NOTE TO CONSUMER: Keep these instructions with your Use and Care
Book for future reference.
This appliance must be properly grounded. See “Electrical Supply”, page 16.
CAUTION
WARNING
If you have questions concerning the installa-
tion of this product, call the GE Answer
Center®Consumer Information Service at
800.626.2000, 24 hours a day, 7 days a week.
If you received a damaged oven, you should
contact your dealer.
Proper installation is the responsibility of the
installer. Product failure due to improper installation
is not covered under the GE Appliance Warranty. See
the Use & Care Guide for warranty information.
CAUTION:
• This oven should be installed by a qualified
installer or service technician.
• Never use the oven for warming or heating a
room. Prolonged use of the oven without
adequate ventilation can be hazardous.
Check with local utilities for electrical codes which
apply in your area. Local codes vary. Installation,
electrical connections and grounding must comply
with applicable codes. In the absence of local codes,
the oven should be installed in accordance with
National Electrical Code ANSI/NFPA 70-1990.
Design Information
Models Available..................................................................................................................................3
Dimensions and Clearances ...............................................................................................................3
Cabinet Style Options .........................................................................................................................4
Installation Options ............................................................................................................................5
Side-by-side Installation Option .........................................................................................................5
Cabinetry
Tools and Materials required .............................................................................................................6
Framed Cabinet, Double Oven ..........................................................................................................6
Framed Cabinet, Single Oven ............................................................................................................7
Recessed Installation: Front framed cabinets with inset doors and drawers..................................8
Frameless Cabinets..............................................................................................................................9
Single Oven Installed Below a Microwave Oven.............................................................................10
Single Oven Installed Below a Countertop......................................................................................11
Cabinetry Modification Suggestions
Provide Oven Supports .....................................................................................................................12
Install Oven Supports........................................................................................................................12
Determine Need for Filler Panels.....................................................................................................13
Filler Panel Construction ..................................................................................................................13
Cut Rail for Filler Panel ....................................................................................................................14
Cut Appearance Panel ......................................................................................................................14
Determine Location of Cleats...........................................................................................................14
Cut and Secure Cleats to Filler Panel...............................................................................................15
Secure Rail to Appearance Panel .....................................................................................................15
Secure Assembled Filler Panel to Cabinet .......................................................................................15
Installation
Tools and Materials Required ..........................................................................................................16
Electrical Locations ...........................................................................................................................16
Finalize Installation ...........................................................................................................................17
Route Cable Through Cutout...........................................................................................................17
Secure Oven to Cabinet ....................................................................................................................18
Replace the Oven Door.....................................................................................................................18
Connect Electrical .............................................................................................................................18
Contents
2
Models
available ZEK757WW
White double convection oven
ZEK757BW
Black double convection oven
ZEK737WW
White single convection oven
ZEK737BW
Black single convection oven
Dimensions
and clearances
Double oven
A - 20" (508 mm)
B - 23-1/2" (597 mm)
C - 26-13/16" (681 mm)
D - 50-3/4" (1289 mm)
E - 26-3/16" (665 mm)
F - 1-3/4" (44 mm)
G - 15/16" (24 mm)
H - 49-5/8" (1260 mm)
J - 1/4" (6 mm)
K - 7/8" (22 mm)
Design Information
Built-In Ovens
With both single and double built-in styles, contempo-
rary Monogram ovens offer an array of choices for the
custom kitchen:
• Built-in double convection ovens
• Built-in single convection ovens
• Monogram built-in ovens are available in sophisti-
cated black or glistening white.
Single oven
A - 20" (508 mm)
B - 23-1/2" (597 mm)
C - 26-13/16" (681 mm)
D - 28-9/16" (725 mm)
E - 26-3/16" (665 mm)
F - 1-3/4" (44 mm)
G - 15/16" (24 mm)
H - 27-7/16" (697 mm)
J - 1/4" (6 mm)
K - 7/8" (22 mm)
3
Cabinet style
options
Design Information
Built-In Ovens
Front Framed Partial Overlay Door Front Framed Full Overlay Door
Frameless
Monogram ovens are installed directly into a wall or
wall oven cabinetry, 27" minimum width. The front
surface of the ovens will be nearly flush with sur-
rounding cabinetry. To obtain optimal appearance,
cabinet cutouts must be exact. The examples shown
here illustrate typical styles of 27" cabinets and oven
fit. Installation instructions for each of these basic
cabinetry styles are provided in this section.
Designer Note:
Whenever
possible, align the oven with
cabinetry details such as
drawers, doors and reveals.
Monogram ovens can be recessed into front framed
cabinets with inset flush doors. This installation
requires 26-7/8" wide and 24-1/2" deep cutout. See
page 6 for details.
Note:
This installation requires
26-7/8" wide, 24-1/2" deep
cutout.
Recessed Installation In
Front Framed Inset Flush Door
4
Installation
options
Single Oven Installed Below A
ZMC1090WV/ZMC1090BV Microwave Oven Single Oven Installed Below A
ZEM200WV Microwave Oven
Design Information
Built-In Ovens
• Install a single oven alone or below any Monogram
microwave oven.
• For an integrated look, install a single oven below
the ZMC1090BV and ZMC1090WV built-in style
microwave ovens. No trim kits required.
• Install a single oven below a ZEM200WV microwave
oven. JX827WN trim kit required.
Side-by-side
installation
option
Install single ovens side-by-side. Minimum spacing
allowed:
• 5" minimum separation between cabinet openings—
any type oven.
5
Cabinetry
Built-In Ovens
• 2" x 4" lumber for runners
• Saw
• Level
• Phillips screwdriver and wood screws or other hardware for
installing runners or shelf to support oven.
Ovens are designed for installation in a cabinet 27" min. wide.
• Cut 2" x 4" runners of appropriate length or solid shelf to
support oven.
• Attach runners or solid shelf in opening as shown.
• Runners must be level and rigidly mounted.
6
Tools and
materials
required
Framed cabinet
double oven
Use the information in this dimension drawing for
typical framed cabinets. The front face of the oven
will be flush with cabinetry doors or drawers.
Order a double oven cabinet.
Rough opening for double oven must be:
• Depth—23-5/8" min. from inside back to front of
cabinet frame.
• Width—25" min.
• Height—49-11/16" min. 50-1/8" max.
• Installing 13-1/4" from floor will place base of upper
oven at countertop level.
–May be more than 13-1/4" from floor, depending
upon user preference.
• All Monogram ovens require 7/8" overlap to
both sides and bottom. Allow 1/4" min. for top
overlap.
• Oven overlaps will conceal all raw edges.
DIMENSIONS
A Cabinet Width 27" Min.
B Cutout Width 25 " Min.
C Cutout Height 49-11/16" Min./50-1/8" Max.
D Cutout Depth 23-5/8" Min.
E Cutout Location 13-1/4" Min.
H Overall Height 50-3/4"
W Overall Width 26-13/16"
Front Framed
Partial Overlay Door Front Framed Full
Overlay Door
Framed cabinet
single oven
DIMENSIONS
A Cabinet Width 27" Min.
B Cutout Width 25" Min.
C Cutout Height 27-1/2" Min./28-1/8" Max.
D Cutout Depth 23-5/8" Min.
E Cutout Location 32-1/2" Recommended
H Overall Height 28-9/16"
W Overall Width 26-13/16"
Use the information in this dimension drawing for
typical framed cabinets. The front face of the oven
will be flush with cabinetry doors or drawers.
Order a single oven cabinet.
Rough opening for single oven must be:
• Depth—23-5/8" min. from inside back to front of
cabinet frame.
• Width—25" min.
• Height—27-1/2" min. 28-1/8" max.
• 32-1/2" from floor is recommended to bring oven
floor to countertop height.
• All Monogram ovens require 7/8" overlap on both
sides and bottom. Allow 1/4" min. for top overlap.
• Oven overlaps will conceal all raw edges.
Front Framed
Partial Overlay Door Front Framed Full
Overlay Door
Cabinetry
Built-In Ovens
7
Recessed
installation:
Front framed
cabinets
with
inset doors
and drawers
Cabinetry
Built-In Ovens
Front Framed
Inset Flush Door
8
Rough opening for single and double ovens:
• Depth 24-1/2" min. from inside back to front of
cabinet frame.
–If the cabinet is not 24-1/2" deep, the back of the
cabinet should be cutout. The cutout should be
minimized in order to maintain structural strength
and squareness of the cabinet.
• Height—for double oven 50-3/4".
• Height—for single oven 28-9/16"
Note:
Installation in a recessed
application is not approved for
vinyl covered cabinets.
If you are using front framed cabinets with inset
doors, these ovens can be installed flush with the
front. In this installation the oven is completely
recessed into the cabinet.
This is achieved by installing cleats, set back 15/16"
from the front frame. The cleats will hold the oven
mounting screws. The cabinet must be wide enough
to allow 26-7/8" opening. Whenever possible, order
the cabinets with the cutout sized to fit the oven.
Provide this information to the cabinet manufacturer
in advance.
Frameless
cabinets
Frameless
Use the information in this dimension drawing for
typical frameless cabinets. The front face of the oven
will be flush with cabinetry doors or drawers.
Whenever possible, order 27" frameless cabinet with
the cutout sized to fit the oven. If you are using stock
cabinets, additional finished filler pieces may be
required to cover openings.
Rough opening for single and double ovens:
• Depth—23-5/8" min. from inside back to front of
cabinet or side panel, excluding doors or drawer
fronts.
–If the cabinet is not 23-5/8" deep, the back of the
cabinet should be cutout. The cutout should be
minimized in order to maintain structural strength
and squareness of the cabinet.
• Width—25" min.
– Frameless cabinet inside width may be up to
25-3/4". Add 1/2" cleats to the sides, flush with
the front edge of the side panels to accept
mounting screws.
• Height—for double oven 49-11/16" min.
• Height—for single oven 27-1/2" min.
Both single and double ovens require 7/8" overlap
around edges of opening on both sides and bottom.
Allow 1/4" for top overlap.
• Allow 1/8" clearance between top of oven and
cabinet door or panel and 1/8" between bottom of
oven and cabinet drawer.
• Installation of double oven requires a total height of
51" including clearances at top and bottom.
• Installation of single oven requires a total height
of 28-13/16" including clearances.
Cabinetry
Built-In Ovens
9
Single oven
installed
below a
microwave
oven
Order a double oven cabinet.
See the chart above for cutout dimensions and
receptacle locations for each microwave oven.
• Allow 1-7/8" clearance between microwave oven and
single oven, for trim kit or oven overlap.
Models ZMC1090WV and ZMC1090BV do not require
trim kits. When installed the outside dimensions will
be 26-3/4"W, 18-5/8"H.
• Model ZEM200WV requires JX827WN accessory
trim kit. When installed the outside dimensions will
be 26-1/8"W, 16-1/4"H.
Install a level base of 3/8" thick plywood, supported by
2"x4" or 1"x2" equivalent runners on all four sides:
–Flush with lower edge of opening and entirely
covering floor of opening.
• Finished microwave oven floor must support
minimum weight of:
–120 pounds for ZMC1090BV/WV.
–100 pounds for ZEM200WV.
Cabinetry
Built-In Ovens
10
Microwave Ovens A B C
ZMC1090WV, ZMC1090BV 17-1/2" 25-1/4" 19" min.
ZEM200WN 15" ±1/16" 24-7/8" ±1/16" 18" min.
Questo manuale è adatto per i seguenti modelli
6
Indice
Altri manuali GE Forno
GE
GE JKP20-27 Single Wall Oven Manuale utente
GE
GE Profile PT956SM Manuale
GE
GE PT7550 Manuale utente
GE
GE RPN2512E Manuale operativo
GE
GE JKP44 Manuale utente
GE
GE 169074 Manuale utente
GE
GE Advantium PSB1200BB Manuale utente
GE
GE PCT7050 Manuale utente
GE
GE Advantium CSB923P2NS1 Manuale utente
GE
GE Monogram ZET737BW Manuale utente
