Hanging the Fan
REMEMBER to turn off the power. Follow
the steps belowto hang yourfan properly:
Step 1. Remove the decorative canopy
bottom cover from the canopy by turning the
cover counter clockwise.(Fig.6)
Step 2. Remove the hanger bracket from the
canopy by loosening the two screws on the
bottom of the hanging bracket turn
from the screw head and turning the canopy
counter clockwise.(Fig, 6)
Step 3. Pass the 120-volt supply wires
through the center hole in the ceiling hanger
bracket as shownin Fig.7.
Step 4. Secure the hanger bracket to the
ceiling outlet box with the screws and
washers provided withyour outlet box.
Step 5. Remove the hanger pin, lock pin and
set screws from the top of the motor
assembly.
Step 6. Route wires exiting from the top of
the fan motor through the collar cover,
canopy cover, canopy and then through the
ball / downrod.(Fig. 8)
Step 7. Align the holes at the bottom of the
downrod with theholes in the collar on topof
the motor housing (Fig.8). Carefully insert
a half
WARNING
FAILURETO PROPERLY INSTALL LOCKINGPIN
AS NOTED INSTEP 7 COULD RESULT IN FAN
LOOSENING ANDPOSSIBLYFALLING.
Step 8. Tighten twoset screws ontop of the fan
motor firmly (Figure8)
Step 9. Place the downrod ball into the hanger
bracket socket.
CHANGING THE DOWNROD(OPTIONAL)
NOTE: Your fan comes with a 4" downrod
attached to the hanger ball. In addition you
have been provided with a 6"downrod to use if
desired. If you choose to use the 6" downrod,
perform the followingsteps:
1. Remove the hanger ball from the 4"
downrod by loosening the set screw at the
top of the downrod which holds the hanger
ball to thedownrod.
2. Slide the hanger ball down the downrod and
remove the supportpin.
the hanger pin through the holes in the collar
and downrod. Be careful not to jam the pin
against the wiring inside the downrod. Insert
the locking pin through the hole near the end
of the hanger pin until it snaps into its locked
position, as notedin the circleinset of Fig. 8.
4.
Figure 5
Installing the bulbs
and glass plate
Step 1. Install 6 x15W bulbs (provided) into
the sockets of the bulb holder bracket on the
top of motor,
Step 2. Loose the four thumb screws and
rubber washers from the bulb holder bracket.
Step 3. Place the two glass plates over the bulb
holder bracket and secure them in place with
the four thumb screws and rubber washers
previously removed. Tighten the thumb screws,
DO NOT OVER TIGHTEN.
Glass plate
Bulb holder bracket
Bulbs
Thumb screw
Rubber washer
