4. TouchLink to a Zigbee Lighting Device
5. Removed from a Zigbee Network through Coordinator or Hub Interface
6. Factory Reset Manually
7. Remove a Touchlink Paired ZigBee Lighting Device
8. Factory Reset a Lighting Device (Touch Reset)
Note: the device shall be added to a network, the remote added to the same one or not added to any network.
Note: 1) After pairing successfully, the remote information will appear on the controller or hub interface.
2) No remote information will appear on the hub interface if pairing to Philips Hue Bridge.
Step 1: Set the zigbee lighting
device to start TouchLink
commissioning, please refer to
its manual to learn how.
From your ZigBee controller or hub
interface, choose to delete or reset
the remote as instructed, indicator
flashes 3 times quickly to indicate
successful removing.
Note: Make sure the device and remote already added to the same zigbee network.
Note: Each remote can bind max. 30 lighting devices.
ZigBee Lighting Device
< 10cm
Step 2: Bring the remote within 10cm
of the lighting device.
Step 3: Press and hold down
until LED indicator turns on.
Step 4: Immediately short press to
start TouchLink commissioning of the
remote. LED indicator flashes fast for
3S, then flash 6 times slowly to
indicate successful pairing to the
device and the light connected to the
device will blink twice.
Note: 1) Directly TouchLink (both not added to a ZigBee network), each remote can link with 30 devices.
2) TouchLink after both added to a ZigBee network, each remote can link with max. 30 devices.
3) For Hue Bridge & Amazon Echo Plus, add remote and device to network first then TouchLink.
4) After TouchLink, the remote can control the linked lighting devices.
9. Find and Bind a Zigbee Lighting Device
Step 1: Press and hold down until
LED indicator turns on.
Note: All configuration
parameters will be reset after
the remote is reset or removed
from the network.
Step 2: Immediately short press 5
times continuously, indicator
flashes 3 times quickly to indicate
successful reset.
Step 1: Set the Touchlink paired
zigbee device to start TouchLink
commissioning, please refer to
its manual to learn how.
ZigBee Lighting Device
< 10cm
Step 2: Bring the remote within 10cm
of the lighting device.
Step 3: Press and hold down
until LED indicator turns on.
Step 4: Immediately short press twice
to start TouchLink removing of the
remote. LED indicator flashes fast for
3S, then flash 6 times slowly to
indicate successful removing.
Step 1: Set the zigbee device to
start TouchLink commissioning,
refer to its manual. ZigBee Lighting Device
< 10cm
Step 2: Bring the remote within 10cm
of the lighting device.
Step 3: Press and hold down
until LED indicator turns on.
Step 4: Immediately short press 5
times to start Touch Reset of the
remote. LED indicator flashes fast for
3S, then flash 3 times slowly to
indicate successful reset.
Step 1: Start find and bind mode
on the Zigbee lighting device
(initiator node) and enable it to
find and bind target, refer to its
manual.
ZigBee Lighting Device
Step 2: Press and hold down
until LED indicator turns on.
Step 3: Short press to enable the
remote (target node) to find and bind
initiator.LED indicator flashes 4 times
for successful binding or twice if
binding fails.
www.havit.com.au www.havit.com.auwww.havit.com.au
