8598-1373-01
ADJUSTMENTS
TIME
There are preset selections for the amount of time
thelightsstayon:Test(30seconds),5,10,20,and
30 minutes. Use a small, phillips screwdriver to
adjusttheTIMEcontrol(see Figure 7).Turnthe
TIMEcontroluntilit“snaps”intothedesiredtime
position(arrowdeterminesposition).
LIGHT SENSITIVITY LEVEL
Youcanadjustthesensor’ssensitivitytoexisting
light. Use a small phillips screwdriver to adjust
theLIGHTcontrol(seeFigure7).Byturningthe
controlfullyclockwise(arrowdeterminesposition),
the sensor will turn lights on even in full daylight.
By turning the control fully counterclockwise, the
sensor will only turn lights on when the existing
light is very low.
1. When the existing light in the room is at the
level you want the lights to turn on, set the mode
selectionswitchtotheAUTOposition.
2. AdjusttheTIMEcontroltothe5minuteposi-
tion.
3. AdjusttheLIGHTcontroltotheminimumdark
position(fullycounterclockwise).
4. Waitforthelightstoturnoff.
5. SlightlyturntheLIGHTcontrolclockwise.Wait
2seconds,thenmoveyourhandinfrontofthe
sensor. If lights controlled by the sensor do not
come on, repeat this step until they do. The light
will now come on when the light level is at or
below the present level and motion is detected.
COMPLETING INSTALLATION
1. Replacecontrolpanelcoverandattachthedeco-
rativewallplate(seeFigure4).Ininstallations
where the motion sensor switch is combined
with other switches or outlets on an expanded
box, you will need to purchase a combination
wall plate. Various combination wall plates are
available at home centers and electrical supply
stores.
2. Slidethemodeselectionswitchacoupletimes
to make sure it moves freely.
MODE SELECTION SWITCH
This switch allows you to select one of three modes
ofoperation:OFF,AUTO,orON.
OFF: Lights stay off.
AUTO: Lights automatically come on when mo-
tion is detected and the existing light is below
the set level.
ON: Lights stay on continuously.
IMPORTANT THINGS TO REMEMBER
• Theremoteswitchwillonlyoperateifthemotion
switchisinAUTOmode.
• Themotionswitchwillsoundalowaudibleclick
when motion is detected.
• Theswitchwillactivateonlyifthemotionswitch
isinAUTOmodeandtheambientlightisbelow
the set LIGHT level.
• Itisrecommendedtousethesettingof10minutesor
greaterwhenusinguorescentandCFLlighting.
Figure 7 - Control Panel
TIME LIGHT
+
Test 30
20
5
5
10
